Acoustics, Dynamics, and Controls Commons^™

Alternative Method For Low Frequency Impact Sound Measurement For Building Field Tests, Sunit Girdhar

Dissertations, Master's Theses and Master's Reports

What do high heels, dog nails, and dragging furniture have in common? They are all frequent sources of noise pollution and annoyance in multi-story buildings. Building codes exist to control and mitigate such noise, but these codes are outdated and fail to protect the residents against noise annoyance. Footstep noise is still the number one cause of complaints among the residents. The impact performance of floor-ceiling assemblies is characterized using a single-number rating called the Impact Sound Rating (ISR). A standard tapping machine is used in pre-defined locations on the floor and the radiated Sound Pressure Level (SPL) is measured …

Less Commute Miles. Decreased Tire Wear. What Would You Do?, Dylan Schwarz, Brendon M. Ford, Brandon D. Hadinger, Abbie N. Pearce, Jacinta M. Pikunas

Williams Honors College, Honors Research Projects

With the flagrant recognition of the coronavirus as one of those most impactful viruses in the history of the world, it is important to study how the effects of such a disease can create troublesome ripple effects in the world. Covid-19 has caused the death of hundreds of thousands of individuals and has negatively impacted the lives of American’s all across the country during the nationwide lockdown. Decreased work commuters, minimal road travel, and little need for car repairs hit the Goodyear Tire and Rubber Company hard. The University of Akron has teamed up with Goodyear to explore such effects …

Reducing The Noise Impact Of Unmanned Aerial Vehicles By Flight Control System Augmentation, Matthew B. Galles

Mechanical & Aerospace Engineering Theses & Dissertations

The aim of this thesis is to explore methods to reduce the noise impact of unmanned aerial vehicles operating within acoustically sensitive environments by flight control system augmentation. Two methods are investigated and include: (i) reduction of sound generated by vehicle speed control while flying along a nominal path and (ii) reduction of acoustic exposure by vehicle path control while flying at a nominal speed. Both methods require incorporation of an acoustic model into the flight control system as an additional control objective and an acoustic metric to characterize primary noise sources dependent on vehicle state. An acoustic model was …

Development Of A Model To Predict The Likelihood Of Complaints Due To Assorted Tone-In-Noise Combinations, Joonhee Lee, Lily M. Wang

Durham School of Architectural Engineering and Construction: Faculty Publications

This paper develops a model to predict if listeners would be likely to complain due to annoyance when exposed to a certain noise signal with a prominent tone, such as those commonly produced by heating, ventilation, and air-conditioning systems. Twenty participants completed digit span tasks while exposed in a controlled lab to noise signals with differing levels of tones, ranging from 125 to 1000 Hz, and overall loudness. After completing the digit span tasks under each noise signal, from which task accuracy and speed of completion were captured, subjects were asked to rate level of annoyance and indicate the likelihood …

Development Of Data Analytics Tools For Acoustic Measurement Of Positive Displacement Machines, Dan Ding, Monika Ivantysynova, Paul Kalbfleisch

The Summer Undergraduate Research Fellowship (SURF) Symposium

Noise control is an important factor in evaluating the design of positive displacement machines. This research project aims to develop new tools in MATLAB, with emphasis on visual approaches, to comprehensively characterize the noise generated by positive displacement machines in spatial, temporal and frequency domains. Sound pressure level (SPL), sound intensity level (SIL) and loudness were calculated and plotted on a measurement surface surrounding the pump, which illustrates the spatial distribution of the sound field. In order to highlight the phenomenon within specific frequency bands, Butterworth filters were used to isolate desired frequencies, such that specific harmonic content or 1/3 …

Influences Of Wind On Automotive Interior Sound Quality, Sara Huelsman, Patricia Davies, Daniel Carr

The Summer Undergraduate Research Fellowship (SURF) Symposium

The effects of noise on human health (both mental and physical) are well known, and motivation to decrease noise in daily life is prevalent. Wind noise within automotive interior cabins could be detrimental to human health and comfort because of the negative impact on speech intelligibility and fatigue overall. There is little information on human perception of wind noise in automobile interiors though Loudness and Articulation Index have been examined as predictors of human response. They have been found to predict well in some circumstances, but not in others. In this research, a variety of sound quality metrics are being …

Room Acoustic Effects On Speech Comprehension Of English-As-Second-Language Talkers And Listeners Versus Native-English-Speaking Talkers And Listeners, Lily M. Wang

Durham School of Architectural Engineering and Construction: Faculty Publications

Approximately 21% of the children in the United States school system speak a language other than English at home, but are being taught in English at school. English is additionally being used more and more often as a common language in international settings, even though participants at these international events again are not native English speakers. How do adverse room acoustic environments, including higher background noise levels and longer reverberation times, impact English-as-a-Second-Language (ESL) talkers and listeners versus native English-speaking talkers and listeners? This presentation focuses on two recent studies at the University of Nebraska that investigate how assorted room …

Determining Annoyance Thresholds Of Tones In Noise, Jennifer M. Francis, Joonhee Lee, Lily M. Wang

Durham School of Architectural Engineering and Construction: Faculty Publications

Building services equipment often produces noise signatures with significant tones in them that can lead to complaints in the built environment. Previous studies have investigated prominence levels of assorted tonal frequencies, but it is still unclear what prominence of the tones across varying tonal frequencies can lead to human annoyance. This project seeks to apply two different methods towards defining annoyance thresholds of tones in noise at two tonal frequencies: 125 Hz and 500 Hz. In the first, subjects are asked to perform a task, while exposed to ten minutes of a broadband noise spectrum with a specific level of …

Optimization Of Wind Fence Enclosures For Infrasonic Wind Noise Reduction, Johnpaul Russell Abbott

Electronic Theses and Dissertations

A large porous wind barrier enclosure has been built and tested to optimize wind noise reduction at infrasonic frequencies between 0.01-10 Hz in order to develop a technology that is simple, cost effective, and improves upon the limitations of pipe and porous hose arrays. The effects of varying the fence's porosity, modifying its top condition and bottom gap, doubling the height and diameter, and adding a secondary wind barrier were investigated. A simple mathematical model which estimates the wind noise measured at the center of the enclosure was derived based on the measured turbulence and velocity profiles measure outside the …

Effects Of Acoustic Environments On Speech Comprehension By Native-English-Speaking Listeners, Zhao Peng, Lily M. Wang, Siu Kit Lau

Durham School of Architectural Engineering and Construction: Faculty Publications

This study investigates the effects of acoustic conditions on speech comprehension, rather than speech intelligibility as often reported in existing literature. Sets of 15-minute-long listening comprehension tests were developed based on the format of the Test of English for International Communication (TOEIC). Each test set includes four types of tasks: matching aural phrases to photographs, selecting appropriate responses to aural questions, and answering questions after listening to conversations (between two talkers) and talks (single talker). Within the Nebraska acoustics test chamber, native-English-speaking participants are asked to perform these tests under 15 acoustic conditions, from combinations of three background noise levels …

Lv-11-C031: Measured Levels Of Hospital Noise Before, During, And After Renovation Of A Hospital Wing, And A Survey Of Resulting Patient Perception, Cassandra H. Wiese, Lily M. Wang

Durham School of Architectural Engineering and Construction: Faculty Publications

Acoustic conditions in hospitals can negatively influence a patient’s physical and psychological health. This paperreports on noise levels measured before, during, and after renovation of a hospital wing in an Omaha, Nebraska, facility thatregularly receives unsatisfactory noise scores on patient satisfaction surveys. Sound pressure levels were logged every 10seconds over four-day periods in three different locations: at the nurses' station, in the hallway, and in a nearby patient’sroom. The resulting data have been analyzed in terms of A-weighted equivalent sound levels (LAeq) as well as variousexceedance levels (Ln). Results indicate that sound levels did not change much due to the …

Ab-10-C037: Effects Of Noise From Building Mechanical Systems On Elementary School Student Achievement, Lauren M. Ronsse, Lily M. Wang

Durham School of Architectural Engineering and Construction: Faculty Publications

This project seeks to determine what relationship, if any, exists betweenbackground noise levels in elementary classrooms due to the building mechanicalsystems and student performance on achievement tests. Previous research inclassroom acoustics has clearly identified that lower background noise levelsresult in higher speech intelligibility which is crucial for the learning process;however, there is a lack of data correlating lower noise levels to improved studentachievement scores. For this study, background noise level measurements were madein 14 elementary schools in a public school system in Council Bluffs, Iowa, USA.The measurements were made in unoccupied classrooms with the central buildingmechanical systems activated. Second and …

Ab-10-018: The Effects Of Noise From Building Mechanical Systems With Tonal Components On Human Performance And Perception (1322-Rp), Erica E. Ryherd, Lily M. Wang

Durham School of Architectural Engineering and Construction: Faculty Publications

This study investigated the effects of noise from building mechanical systems with tonal components on human task performance and perception. Six different noise conditions based on in-situ measurements were reproduced in an office-like setting; all were set to approximately the same sound level (47 dBA) but could have one particular tonal frequency (120 Hz, 235 Hz, or 595 Hz) at one of two tonal prominence ratios (5 or 9). Thirty participants were asked to complete typing, grammatical reasoning, and math tasks plus subjective questionnaires, while being exposed for approximately 1 hour to each noise condition. Results show that the noise …

Ab-10-017: Combined Effects Of Noise And Temperature On Human Comfort And Performance (1128-Rp), Dale Tiller, Lily M. Wang, Amy Musser, Matthew Radik

Durham School of Architectural Engineering and Construction: Faculty Publications

This paper summarizes results from an experiment designed to investigate the combined effects of noise and temperature on human thermal comfort and task performance. Thirty subjects (16 females, 14 males) were exposed to all combinations of five thermal conditions (PMV +1 [79.6°F:26.4°C], PMV +0.5 [75.8°F:24.3°C], PMV 0 [72.1°F:22.3°C], PMV -0.5 [68.3°F:20.2°C], and PMV -1 [64.6°F:18.1°C]), three RC noise levels (RC-30, RC-40, and RC-50), and two sound qualities (neutral and rumbly): all sounds mimicked noise from building ventilation systems. After a one-hour adaptation period at each condition, subjects rated their thermal comfort using the ASHRAE Thermal Comfort Scale and the Tenant …

Ab-10-019: Human Performance And Perception-Based Evaluations Of Indoor Noise Criteria For Rating Mechanical System Noise With Time-Varying Fluctuations (1322-Rp), Lily M. Wang, Cathleen C. Novak

Durham School of Architectural Engineering and Construction: Faculty Publications

The goal of this study was to investigate the effects of noise from building mechanical systems with time-varying fluctuations on human task performance and perception, and to determine how well current indoor noise rating methods account for this performance and perception. Six different noise conditions with varying degrees of time-varying fluctuations, many focused in the low frequency rumble region, were reproduced in an office-like setting. Thirty participants were asked to complete typing, grammatical reasoning, and math tasks plus subjective questionnaires, while being exposed for approximately one hour to each noise condition. Results show that the noise conditions with higher sound …

Computation Of Shock Induced Noise In Imperfectly Expanded Supersonic Jets, Bulent Imamoglu

Mechanical & Aerospace Engineering Theses & Dissertations

Screech noise exists only in imperfectly expanded jets. The exit pressure of imperfectly expanded jets does not match ambient pressure, so expansion or compression waves appear out of the nozzle and generate shock cell patterns. Screech is generated by the interaction of shock cells and instability waves. Many experiments and computations have been done to model screech noise, but it is not yet a very well known subject.

A numerical study is performed to understand screech generation mechanisms and to compare with latest experiments. A supersonic underexpanded jet of 25.4 mm diameter is modeled for cases of Mach numbers of …