Acoustics, Dynamics, and Controls Commons^™

Trajectory-Based Model Predictive Control For Rotary Crane Sway Suppression With Only Horizontal Boom Actuation, Haryson J. Nyobuya

Tanzania Journal of Engineering and Technology (TJET)

Safety is of biggest importance in construction and industrial activities involving rotary cranes. These cranes are huge and responsible of moving large parts or/and materials from different positions. Now operating these cranes tend to be subdue to pay load oscillations when moving the load for which is extremely dangerous when not suppressed. This study proposes the generation of trajectory using Model predictive control approach with reduced control horizon compared to state horizon. Reduced control horizon design reduces computational time for trajectory generation while maintaining the pay-load sways to a minimum. In this approach the complex dynamic model is reduced to …

The Pid-Based Three Quadcopter Uavs Formation Control Under External Disturbance, Vo Van An, Trinh Luong Mien

Makara Journal of Technology

This paper presents the design and evaluation of a formation control strategy for three quadcopter UAVs, based on a PID controller in a leader–follower structure, under the influence of external disturbances. Each UAV employs a six-degree of-freedom dynamic model and utilises a cascade PID control architecture, in which the inner control loop stabilises the attitude. In contrast, the outer control loop regulates position and maintains the formation. The PID parameters are tuned using the Ziegler–Nichols method to ensure simple implementation and low computational cost. The performance of the control system is evaluated through simulations in the MATLAB environment for two …

Numerical Investigation Of Heat Transfer And Aero-Acoustic Response In Deep Cavity Flows Using Urans Simulations, Abdul Hamid Jabado, Ali Hammoud, Bilal El Zohbi, Bilal Taher, Hassan Assoum

BAU Journal - Science and Technology

This paper presents a numerical study to investigate a deep cavity flow, in order to better understand the underlying mechanisms involved in it, such as flow dynamics, heat transfer, and aeroacoustics. A 2-D Unsteady Reynolds Averaged Navier Stokes model (URANS) was implemented using an SST k-ω turbulence closure simulated over a rectangular deep cavity. Previous experimental results were used to validate the numerical results, to confirm the accuracy of the flow field patterns reproduced. Both controlled and uncontrolled cases were analyzed. Heat transfer was also investigated on both configurations, showing the effect of cavity geometry and inlet conditions on heat …

An Engineering Solution For Fan Aeroacoustics Measurements Correction In A Non-Anechoic Testing Environment, Saad-Eldin Taha, Mohamed Y.Zakaria, Mohamed Abdelgaied, M.M. Bassuoni Prof. Dr.

Journal of Engineering Research

Abstract- Nowadays, acoustic signatures of daily used applications are to be minimized. The study of noise generated through aerodynamic interaction with moving bodies has passed through different phases since the early 50s, and this leads to the evolvement of many analytical, empirical and computational techniques in order to be able to estimate the emitted noise. Concerning fan blades, until now the researches are still going for a reliable method for noise estimation during the early phases of design which help in the development of blades with a lower aeroacoustic signature, the Brooks, Pope and Marcolini (BPM) model was chosen to …

Design And Control Of Delta Robot (Mini Review), Donia Waheed Seleem, Mohamed A. Shamseldin, Hasan Eleashy

Future Engineering Journal

The control of Delta robots, known by their parallel kinematic structure and high-speed operation, presents unique challenges and opportunities. A recent developments in Delta robot will be described. The strategies are aimed at enhancing precision, speed, and flexibility in a variety of robotic applications. Here are some key elements: trajectory tracking, motion planning, and obstacle avoidance. This review paper presents a comprehensive evaluation of three different approaches to enhancing the performance of Delta robots: structural optimization, kinematics and dynamics refinement, and control techniques that have been used. This provides a unique, multidimensional perspective that bridges the gap between isolated optimizations …

Numerical Simulation Of Airflow Properties Of The Naca 6420 Airfoil Using The Transition Rans K-Ε Model, Oluwaseyi O. Alabi, Saidat A. Salisu, Oyeyemi T. Aforolagba -Balogun, Temitope A. Ladigbolu, Ayotunde O. Fasina, Anas Bala

Al-Bahir

This study investigates the airflow properties around the airfoil using numerical simulation, addressing the longstanding challenge of accurately predicting transition phenomena in turbulent flows. The importance of this research lies in its potential to improve the design and performance of airfoils in various engineering applications, such as wind turbines, and aircraft. A custom 2-dimensional airfoil model was created using Airfoil instruments, featuring a 6% maximum curvature, 40% curvature position, and 20% thickness. COMSOL Multiphysics software performed computations at a velocity of over 19 hours, with data analyzed at 60-minute intervals. The Transition turbulent model was employed to simulate the airflow …

Development Of A Drive-Rod Unified Variable Pitch Control Mechanism For Small-Scale Horizontal Wind Turbines, Ayman I. Bakry, Mohamed Elfouly, Omar Mehrez

Journal of Engineering Research

Typically, small-scale wind turbines use either a breaking equipment or stall control methods once the wind speed exceeds its rated value. This is to limit the power extracted from the wind turbines which largely depends on the blades' shape and pitch angle. Most of small-scale wind turbines are of fixed pitch angle to avoid complexity and cost. In this work, a novel drive-rod unified variable pitch drive mechanism is proposed for blades pitch control for small-scale horizontal wind turbines. The mechanism is powered by a DC motor coupled with a lead screw which in turn is connected to the pitch …

Pd Controller Design For Automotive Magnetorheological Semi-Active Suspension System, Ayman I. Bakry, Emad M. S. El-Said, Ahmed Shehata Gad, Ahmed Abd Almoez, Omar Mehrez

Journal of Engineering Research

Recently, there is a tendency towards the utilization of magnetorheological (MR) dampers in electrical vehicles (EV) due to its adaptability of active control devices with lower requirement of large power sources compared to the active damping systems. This paper investigates the performance of the most used control technique for MR dampers used in EV, the PID controller, under different road conditions. In this investigation, the Dynamic-Damper-Motor System (ADM-EV) is used as the EV suspension system model. Meanwhile, modified Bouc-Wen model is used as the MR damper model. The design procedure for the optimum design of the system controller parameters is …

Design, Modeling, And Control Of Medical Service Quadrotor, Mohamed Eid, Anas Mohamed, Ali M. Mohamed

Journal of Engineering Research

Due to road accidents, it is difficult to supply injured people with first aid, especially in difficult-access regions. Also, uneven roads or far places pose a problem for ambulances and doctors to reach and save injured people’s lives. The paper aims to design, model, and control a drone able to fly at different heights and support patients with essential needs after accidents. The drone also contains sensors to measure blood sugar and pressure in cases of diabetic coma that require urgent intervention. The drone design was tested using SolidWorks and FLUENT to ensure safe design in different flying conditions. The …

Smart Materials For Noise And Vibration Damping In High-Speed Rail Systems: A Comparative Analysis, Hyginus Chidiebere Onyekachi Unegbu, Danjuma Saleh Yawas, Bashar Dan-Asabe, Abdulmumin Akoredeley Alabi

Makara Journal of Technology

Effective noise and vibration control remains a critical challenge in high-speed rail systems, directly influencing passenger comfort and the longevity of infrastructure. This study evaluated four advanced materials—piezoelectric materials, shape memory alloys (SMAs), magnetorheological (MR) fluids, and damping composites—focusing on their potential for mitigating noise and vibration in high-speed rail applications. A combination of experimental and simulation-based analyses was employed to assess these materials based on their noise reduction coefficient, vibration transmissibility ratio, thermal stability, and durability under varying environmental conditions. The findings revealed that damping composites and SMAs demonstrated superior performance, offering enhanced noise attenuation and vibration control compared …

Capacitive Sensors With Ultra-Small Capacitance For Smart Measurement And Control Systems, Rustam Baratov, Farrux Jabbor O'G'Li Ko'charov

Chemical Technology, Control and Management

This article discusses methods of low capacitance measurement of capacitive sensors. The results of the study of the amplitude-frequency (AF) and phase-frequency (PF) response of measurement circuits of capacitive sensors for low capacitances measurement, consisting of RC - differentiating elements are presented. The input and output parameters of the differentiating circuit and the complex transfer function are analyzed. The research results show that low capacitances measurement by measuring the rectangular pulses duration is the most effective measurement method.

Performance Comparison Of Several Control Algorithms For Tracking Control Of Pantograph Mechanism, Laylaa Mahmoud Eng, Mohamed Shamseldin Dr, Mohamed Sallam Dr, Abdelghany Mohamed Prof

Future Engineering Journal

A sort of parallel manipulator known as a pantograph robot mechanism was created primarily for industrial requests that required high precision and satisfied speed. While tracking a chosen trajectory profile requires a powerful controller. Because it has four active robot links and one robot passive link in place of just two links like the open chain does, it can carry more loads than the open chain robot mechanism while maintaining accuracy and stability. The calculated model for a closed chain pantograph robot mechanism presented in this paper takes into account the boundary conditions. For the purpose of simulating the dynamics …

Prediction Of Temperature Difference Across Thermoacoustic Stack Through Artificial Neural Network Technique, Anas A. Rahman, Xiaoqing Zhang

Future Engineering Journal

This study involved the application of artificial neural network (ANN) as a new approach for thermoacoustic refrigerators to predict the temperature difference across the stack under some operating conditions. One ANN model for a standing wave thermoacoustic refrigerator, had been developed based on the experimental data from other literature. Temperature difference across the stack was chosen as a response to the input parameters, mean pressure and frequency in the proposed ANN model. A multi-layer feed-forward neural network with a back propagation algorithm had been proposed for predicting the temperature difference across the stack of the thermoacoustic refrigerator. This proposed ANN …

The Effect Of Noise-Reducing Acoustic Panels On The Noise Levels And Overall Safety Of Infant Sleep Machines, Pranav Poola

Journal of the South Carolina Academy of Science

Infant sleep machines (ISMs) are devices used to help infants fall asleep faster and stay asleep for longer amounts of time, yet they can often be too loud for infantile ears, which could potentially be dangerous. This research aimed to minimize the risks of infant sleep machines without reducing the effectiveness of the infant sleep machines themselves through the use of acoustic panels. Based on previous studies, it was hypothesized that the acoustic panels would reduce the noise levels of the ISM to less than recommended limits of 50 dB-A. A specific corner of a designated room was prepared with …

The Beautiful Math Of Everything And You Included, E. Ozie

The Transdisciplinary STEAM+ Journal

This a reflection on how there is beautiful math to everything. An author's interpretation of matrices and mechanics in its relationship to someone's identity.

Control Of Mr Damper Using Anfis And Pid Controller For Optimum Vehicle Ride Comfort, Mohammad Faisal Yakhni, Mohamad Ali, Mohamed El-Gohary

BAU Journal - Science and Technology

Suspension system design is an important challenging duty that facing car manufacturers, so the challenge has become to design the best system in terms of providing ride comfort and handling ability under all driving situations. The goal of this paper is to provide assistance in enhancing the effectiveness of the suspension system. A full car model with eight Degrees Of Freedom (DOF) was developed using MATLAB/Simulink. Validation of the Simulink model was obtained. The model was assumed to travel over a speed hump that has a half sine wave shape and amplitude that changing from 0.01 to 0.2 m. The …

Analytical Approach To Investigation Of Free Vibration Of Thin Rectangular Plate Immersed In Fluid, Resting On Winkler And Pasternak Foundations, Obanishola Sadiq, Gbeminiyi Sobamowo, Saheed Salawu

Karbala International Journal of Modern Science

Dynamic behaviour of free vibration of rectangular plate is investigated. This study considered an analytical approach to investigation of free vibration of thin rectangular plate immersed in fluid, resting on Winkler and Pasternak foundations.The governing nonlinear partial differential equation is analyzed using two-dimensional differential transform method. The accuracy of the analytical solutions obtained is verified with existing results in literature and confirmed in excellent agreement. Thereafter, the analytical solutions are used for investigation of effect of elastic foundation, fluid and aspect ratio on vibrating plate.From the result, it is observed that, increase elastic foundation parameters increases natural frequency, increase aspect …

Analysis Of Dynamic Behaviour Of A Tensioned Carbon Nanotube In Thermal And Pressurized Environments, Ahmed Yinusa, Gbeminiyi Sobamowo

Karbala International Journal of Modern Science

In this paper, the dynamic behaviour of a tensioned single-walled carbon nanotubes (SWCNT) in thermal and pressurized environments is investigated analytically. With the applications of Bernoulli-Euler and thermal elasticity mechanics theories, the governing equation of motion are developed and solved using Laplace and Fourier transforms. The results of the close form solution in this work are in excellent agreements with past results in literature. From the parametric studies, it is established that as the magnitude of the pressure distribution at the surface increases, the deflection associated with the nanotube increases at any mode of vibration. However, a corresponding increase in …

Hydraulic Test Bench Circuit Construction, Testing, And Analysis, Shane Michelson, Mitch Mueller, Brett Schurman

The Journal of Undergraduate Research

Hydraulic power control systems are a common and important part of mechanical and agricultural systems. In hydraulic power system design, power, pressure, flow rates, and mechanism of circuitry are all important factors when analyzing any hydraulic system. Pumps, electric motors, reservoirs, working fluid properties, hydraulic circuitry, and a large variety of valves make up a functional hydraulic system. Applications for hydraulic systems vary widely from automotive, agricultural, mechanical etc. It is the engineers’ job to design a hydraulic system that will be functional, efficient, and safe.

Fantasy And The Concert Hall: Musical Performance In The Electroacoustic Age, Matthew Malsky

Reconstruction: Studies in Contemporary Culture

[First paragraph]

In 1941, the famously despondent Theodor Adorno worried about the detrimental effects of radio broadcast upon the symphony. He theorized that much of value was lost when listeners experienced an orchestral performance of a composition in symphonic form through its electronic transmission to their kitchens rather than in a concert hall. Based upon empirical research done in collaboration with Paul Lazarsfeld and the Princeton Radio Research Project, he argued that the presence of music was lost to the radio listener, and with it a part of music's auratic spell, its uniqueness in time and place, its ritual, cultish …

Farm Safety, Department Of Agriculture, Western Australia

Journal of the Department of Agriculture, Western Australia, Series 4

Careful investigation has been made into the causes of tractors overturning.

The most common types of accident are set out below, with advice on how to avoid them.

Making Beats Visible, Carl J. Ulrich

Journal of the Minnesota Academy of Science

No abstract provided.