Acoustics, Dynamics, and Controls Commons^™

Wearable Sensor System Used To Measure Linear And Angular Acceleration Of The Head Of American Football Players, David A. Emerson

LSU Master's Theses

American football players are repeatedly subject to high-velocity impacts; collisions can exceed 100 g in the NFL [1]. Rotational accelerations of the head caused by high-velocity collisions have been proven to be extremely damaging to the highly organized brain fibers at the brain-skull interface [2]. The sensor system (SS) measures the nonplanar acceleration at four locations on a chin strap using ADXL314 accelerometers and utilizes rigid-body kinematics to estimate the head rotational state from the measured acceleration of the SS [3]. The SS was validated through progressive testing, including steady-state, linear impact, and rotational impact testing. The ADLX314 sensor exhibited …

Marine Vehicle Dynamics Using Koopman Operator Theory With Hybrid Observables, Mikhalib A L Green

LSU Master's Theses

Accurate modeling of marine vehicle dynamics remains challenging due to strong nonlinear hydrodynamic effects, environmental disturbances, and sensitivity to configuration changes, particularly for small-scale platforms. Classical physics-based models require extensive parameter identification and often exhibit degraded performance outside narrow operating regimes, while purely data-driven approaches may lack structure or impose high computational cost. This thesis presents a data-driven Koopman operator framework with hybrid observables for modeling the dynamics of unmanned marine vehicles. The proposed approach combines structured monomial observables with a learned neural network embedding to construct a lifted state representation in which the nonlinear vehicle dynamics are approximated by …

The Design And Effect Of Continuum Robot Compliance On Locomotion, Parsa Molaei

LSU Doctoral Dissertations

Continuum robots, due to their compliant structures and ability to navigate through constrained environments, offer significant advantages in applications requiring safe physical interaction and dexterous motion. However, challenges related to limited structural stiffness, payload capacity, and precise control remain open problems in the field. This dissertation presents novel contributions aimed at addressing these limitations through two main actuation units of continuum robots: tendon-driven continuum robots (TDCRs) and concentric tube robots (CTRs). In the first part, we focus on methods to improve the stability and modify the stiffness of the TDCR. A tendon decoupling strategy is introduced for planar TDCRs. The …

Enhancing Bridge Resilience And Overheight Vehicle Mitigation Through Innovative Sacrificial Cushion Systems, Aly Mousaad Aly, Marc Hoffmann

Faculty Publications

Transportation departments have made significant strides in addressing the challenges posed by the increasing weights of trucks on bridges. While there is a growing awareness of overheight vehicle collisions with bridges, implementing effective countermeasures remains limited. The susceptibility of bridges to damage from such collisions is on the rise, further exacerbated by unpredictable lateral impact forces. This study employs nonlinear impact analysis to assess the response of an unprotected vehicle-girder model, yielding realistic deformation outcomes comparable to observed impacts on the US-61 bridge. Predictions for a truck traveling at 112.65 km/h indicate deformations of 0.229 m, 0.161 m, and 0.271 …

A Multi-Aerial Vehicle Platform For Testing Collaborative Mobility Formation Controllers, Matthew Snellgrove

LSU Master's Theses

Multi-agent systems have potential applications in a multitude of fields due to their ability to perform complex tasks with a high degree of robustness. Decentralized systems are multi-agent systems where sensing, control, and communication responsibilities are distributed amongst the agents giving this scheme a particularly high potential for robustness, adaptability, and complexity; however, this comes with its own list of challenges. Formation control is a topic in multi-agent systems that aims to have the agents moving as a virtual rigid body through space. In the literature, there have been successful implementation of formation control algorithms on robot agents in both …

Cable Decoupling And Cable-Based Stiffening Of Continuum Robots, Parsa Molaei

LSU Master's Theses

Cable-driven continuum robots, which are robots with a continuously flexible backbone and no identifiable joints that are actuated by cables, have shown great potential for many applications in unstructured, uncertain environments. However, the standard design for a cable-driven continuum robot segment, which bends a continuous backbone along a circular arc, has many compliant modes of deformation which are uncontrolled, and which may result in buckling or other undesirable behaviors if not ameliorated. In this study, a detailed approach for using additional cables to selectively stiffen planar cable-driven robots without substantial coupling to the actuating cables is investigated. A mechanics-based model …

Control And Planning For Mobile Manipulators Used In Large Scale Manufacturing Processes, Joshua T. Nguyen

LSU Master's Theses

Sanding operations in industry is one of the few manufacturing tasks that has yet to achieve automation. Sanding tasks require skilled operators that have developed a sense of when a work piece is sufficiently sanded. In order to achieve automation in sanding with robotic systems, this developed sense, or intelligence, that human operators have needs to be understood and implemented in order to achieve, at the minimum, the same quality of work. The system will also need to have the equivalent reach of a human operator and not be constrained to a single, small workspace. This thesis developed solutions for …

Accelerated Controller Tuning For Wind Turbines Under Multiple Hazards, Aly Mousaad Aly, Milad Rezaee

Faculty Publications

During their lifecycle, wind turbines can be subjected to multiple hazard loads, such as high-intensity wind, earthquake, wave, and mechanical unbalance. Excessive vibrations, due to these loads, can have detrimental effects on energy production, structural lifecycle, and the initial cost of wind turbines. Vibration control by various means, such as passive, active, and semi-active control systems provide crucial solutions to these issues. We developed a novel control theory that enables semi-active controller tuning under the complex structural behavior and inherent system nonlinearity. The proposed theory enables the evaluation of semi-active controllers’ performance of multi-degrees-of-freedom systems, without the need for time-consuming …

A Feedback-Based Pneumatic Compression System For Effective Lymphedema Management, Mohammad Imrul Kayes

LSU Master's Theses

Bioimpedance analysis (BIA) is a method of detecting lymphedema- a debilitating medical condition involving swelling of the extremities. Pneumatic compression devices are frequently used in the compression treatment of lymphedema. Although existing compression technology provides relief of symptoms, it has limitations in terms of ease-of-use, portability, and monitoring of treatment progress. Currently, there are no BIA analyzers in the market that run on a low-power microcontroller and a rechargeable battery. Moreover, no such device currently exists that integrate the BIA analysis with pneumatic compression system to offer a feedback-based solution for lymphedema treatment. This work represents the first steps towards …

Maximizing And Modeling Malonyl-Coa Production In Escherichia Coli, Tatiana Thompson Silveira Mello

LSU Master's Theses

In E. coli, fatty acid synthesis is catalyzed by the enzyme acetyl-CoA carboxylase (ACC), which converts acetyl-CoA into malonyl-CoA. Malonyl-CoA is a major building block for numerous of bioproducts. Multiple parameters regulate the homeostatic cellular concentration of malonyl-CoA, keeping it at a very low level. Understanding how these parameters affect the bacterial production of malonyl-CoA is fundamental to maximizing it and its bioproducts. To this end, competing pathways consuming malonyl-CoA can be eliminated, and optimal nutritional and environmental conditions can be provided to the fermentation broth. Most previous studies utilized genetic modifications, expensive consumables, and high-cost quantification methods, making …

Formation Control Of Nonholonomic Multi-Agent Systems, Milad Khaledyan

LSU Doctoral Dissertations

This dissertation is concerned with the formation control problem of multiple agents modeled as nonholonomic wheeled mobile robots. Both kinematic and dynamic robot models are considered. Solutions are presented for a class of formation problems that include formation, maneuvering, and flocking. Graph theory and nonlinear systems theory are the key tools used in the design and stability analysis of the proposed control schemes. Simulation and/or experimental results are presented to illustrate the performance of the controllers.

In the first part, we present a leader-follower type solution to the formation maneuvering problem. The solution is based on the graph that models …

Formation Control Of Multi-Agent Systems By Using Rigid Graphs, Pengpeng Zhang

LSU Doctoral Dissertations

This research is devoted to the decentralized formation control of multi-agent systems in two- and three-dimensional space. Rigid graph theory is used to describe the interactions between the agents, and Lyapunov theory and input-to-state stability are the main tools for designing and analyzing the stability of the proposed formation controllers. Two formation problems are addressed in this work: formation acquisition, where the goal is for the agents to form and maintain a pre-defined geometric shape; and formation maneuvering, where the agents need to acquire a formation and move cohesively as a virtual rigid body.

In the first problem, we tackle …

Nonlinear Model-Based Control For Neuromuscular Electrical Stimulation, Ruzhou Yang

LSU Doctoral Dissertations

Neuromuscular electrical stimulation (NMES) is a technology where skeletal muscles are externally stimulated by electrodes to help restore functionality to human limbs with motor neuron disorder. This dissertation is concerned with the model-based feedback control of the NMES quadriceps muscle group-knee joint dynamics. A class of nonlinear controllers is presented based on various levels of model structures and uncertainties. The two main control techniques used throughout this work are backstepping control and Lyapunov stability theory.

In the first control strategy, we design a model-based nonlinear control law for the system with the exactly known passive mechanical that ensures asymptotical tracking. …