Mechanical Engineering Commons^™

Freezing Point Mobile Munitions Assessment Sytem: Thermal Chamber Redesign, Sara Gifford, Preston Harris

Undergraduate Honors Capstone Projects

The Army is actively investigating non-intrusive methods to identify six chemical weapons agents. The chemical munitions in question are often found scattered across military bases and other facilities. These non-stockpile munitions are specifically targeted for identification using the mobile munitions assessment system. This program is being administered by the Idaho National Engineering Laboratory.

Optimization Of Torquer Coil Design For Use With The Small Satellite Attitude Control Simulator, David Deloyd Anderson

Undergraduate Honors Capstone Projects

This paper presents a procedure used to optimize the performance of a ferromagnetic core magnetic torquer coil design for use on the Space Dynamics Laboratory (Logan, UT) Small Satellite Attitude Control Simulator. The items of optimization include the primary goal of maximizing the coil 's magnetic moment while reducing power consumption and system mass within given power, mass, and dimensional constraints. The optimization process makes use of several simple equations to determine a few starting points for design, after which an iterative approach based on experimentation is used to produce the final design. It is found that optimal magnetic moment …

Advanced Rover Chassis, Eric Alan Poulson, Collin Lewis, Todd Graves

Undergraduate Honors Capstone Projects

Background:

The six wheeled rover vehicle detailed in this design is intended as an upgrade test bed for the sensor array and autonomous navigation algorithms in use by Utah State University's Center for Self-Organizing and Intelligent Systems (CSOIS). The CSOIS's sensor suite can successfully detect and avoid unnavigable obstacles up to five vehicle lengths in front of the vehicle. The center presently uses a modified RC type chassis and only supports two wheel drive. This chassis was adequate to bring the CSOIS's algorithms to a proof-of-principles state, but in order to place the system in any practical application, a full …

Final Design Report Of The Design Of A Climate Controlled Sleeping Chamber For Infants And Toddlers, Jennifer Stenger Stevens

Undergraduate Honors Capstone Projects

A climate controlled sleeping chamber, or air crib, for infants and toddlers is an alternative sleeping medium to the conventional crib. It is a chamber that is ventilated with air that is temperature and humidity controlled to provide an optimum sleeping environment for young children, ages 0 to 2 years. Its purpose is to enhance the psychological and physiological development of young children. Because it is easier to heat a small chamber than larger living quarters, the air crib also has economic advantages.

The design o climate controlled sleeping chamber must meet some minimum requirements. The system must provide an …

A Thermal Energy Storage Tank Model For Solar Heating, Robert Arthur Pate

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The results of a combined theoretical and experimental study of the kinetics of a hot-liquid energy-storage tank are presented. A physical model is developed which accurately describes the thermal stratification behavior in a storage tank. The governing differential equations are developed for the physical model. A numerical solution to the system of equations is presented. Some existing models were examined and the predicted results of each are discussed. The concepts developed can be used to predict the thermal stratification behavior in a storage tank under most conceivable operating conditions. These conditions include flow configurations at the top and the bottom …

The Formation And Properties Of Machining Burrs, Laroux K. Gillespie

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The formation of burrs in Machining Operations occurs by three Basic Mechanisms:

1) Lateral Extrusion of material

2) Bending of the chip

3) Tearing of the chip form the workpiece

Each of these mechanisms has been studied analytically and compared to experimental results. The agreement between predictions and measurements has been found to be close.

Drilling, milling, grinding, and turning burrs were produced in 303Se stainless steel and their properties were related to tool geometry, feedrates, and depth of cut. One thousand measurements were made and subsequently analyzed by analysis of variance techniques. The properties measured include burr length and …