Mechanical Engineering Commons^™

Developing A Sensing System For The Measurement Of Oxygen Concentration In Liquid Pb-Bi Eutectic: Quarterly Progress Report (Aug. 01 – Oct. 31, 2002), Yingtao Jiang, Bingmei Fu, Woosoon Yim

Transmutation Sciences Materials (TRP)

After two month intensive work in LANL, some preliminary sensor calibration curves have been obtained. Further data analysis shall be performed to assess the theoretical and measured data. Also, a new experimental apparatus shall be designed and located in UNLV to continue the left work.

Technical Progress:

• A set of calibration curves of voltage vs. temperature ranging from 300⁰C to 500⁰C under various oxygen concentrations in liquid LBE for the YSZ oxygen sensor has been obtained and has been reported in one paper.

• A meeting with LBE committee and other faculty members in AAA …

Use Of Positron Annihilation Spectroscopy For Stress-Strain Measurements: Quarterly Progress Report (June 1 – August 31, 2002), Ajit K. Roy

Transmutation Sciences Materials (TRP)

The purpose of this collaborative research project involving the University of Nevada Las Vegas (UNLV), the Idaho State University (ISU), and the Los Alamos National Laboratory (LANL) is to evaluate the feasibility of determining residual stresses in cold-worked, plastically-deformed, and welded materials using a nondestructive method based on positron annihilation spectroscopy. This technique uses γ-rays from a small MeV electron Linac to generate positrons inside the sample via pair production. This method is known to have capabilities of characterizing defects in thick specimens, that could not be accomplished by conventional positron technique or other nondestructive methods. The generated data will …

Design And Analysis For Melt Casting Metallic Fuel Pins Incorporating Volatile Actinides, Xiaolong Wu

UNLV Theses, Dissertations, Professional Papers, and Capstones

Fundamental issues related to the selection of a metallic fuel casting furnace design are presented and discussed including heating mechanisms, casting issues, crucible design, and issues related to the mass transport of americium. The process of evaluating all of these different criteria is undertaken to select a concept that would have the greatest chance of success for casting americium in a metallic fuel rod. Based on this evaluation process, a concept for the casting of metallic fuel pins containing high vapor pressure materials is selected and discussed. The important physics of this concept include mass transport of americium from the …

Developing A Sensing System For The Measurement Of Oxygen Concentration In Liquid Pb-Bi Eutectic: Quarterly Progress Report (May 01 – July 31, 2002), Yingtao Jiang, Bingmei Fu, Woosoon Yim

Transmutation Sciences Materials (TRP)

Accurate measurement of the oxygen concentration in liquid Lead-Bismuth Eutectic (LBE) cooling system is critical in the active control of the corrosion at the interface between LBE and the stainless steel of transport tubes. Currently, LANL (Los Alamos National Laboratory) scientists have employed an automobile-style YSZ (Yttria Stabilized Zirconia) oxygen sensor unit to measure oxygen levels in an engineeringscaled LBE test system. Although the theoretical model for calculating oxygen concentration based on voltage measurement of YSZ sensor in static conditions is well understood, there is an urgent and strong need to obtain a complete set of calibration curves for YSZ …

Development Of A Model For Induction Heating, Randy Clarksean, Yitung Chen

Fuels Campaign (TRP)

There are two coupled equations that must be solved in order to determine the power deposition. The numerical solution of these equations is needed in order to apply a source term within the energy equations. These equations have previously solved in FIDAP. That implementation used modified versions of the momentum and energy equations to provide a mechanism for the solution of two coupled equations. Currently, we want to solve for the induction heating field in addition to the flow field and the energy equation. In order to do this, a mechanism has to be defined within FIDAP to solve these …

Use Of Positron Annihilation Spectroscopy For Stress-Strain Measurements, Ajit K. Roy

Transmutation Sciences Materials (TRP)

The purpose of this collaborative research project involving the University of Nevada, Las Vegas (UNLV) and Idaho State University (ISU) is to evaluate the feasibility of determining residual stresses of welded (after pre-straining) engineering materials using a new nondestructive technique based on positron annihilation spectroscopy. The proposed technique is to use γ-rays 2 from a small MeV electron Linac to generate positrons inside the sample via pair production. This method can be used for materials characterization and investigation of defects in thick samples that could not be accomplished by conventional positron techniques or other nondestructive methods. The data generated will …

Report Of The State Nuclear Safety Advisor Submitted To The Governor And 120th Legislature As Of January 15, 2001, Paula M. Craighead

Maine Collection

Report of the State Nuclear Safety Advisor submitted to the Governor and 120th Legislature As of January 15, 2001

Paula M. Craighead, State Nuclear Safety Advisor, Executive Department, Maine State Planning Office, Augusta, Maine, 2001.

Contents: Introduction and Executive Summary / I. Maine Yankee Decommissioning / II. Portsmouth Naval Shipyard (PNS) / III. Low-Level Radioactive Waste (LLRW) / IV. High Level Radioactive Waste / V. Transport Routes and Safety Response / VI. Shipments / VII. Status of Federal and State Legal and Administrative Proceedings / References and Resources / Glossary

Chp And Energy Conservation, Jim Mcgovern

Articles

The principles of the use of 'combined heat and power' (CHP) for the achievement of fuel energy conservation, minimisation of environmental impact and economic advantage are explained. A distinction is made between the two types of outputs: heat and work. It is argued that an efficiency value that is defined as the sum of the heat and work outputs divided by the energy of the fuel used is not very meaningful. An alternative, rational, efficiency is explained. It is concluded that CHP is an option to be considered where both heating and power are required, but is not a general …

Stubble : Friend And Foe, Department Of Agriculture And Food, Western Australia

Journal of the Department of Agriculture, Western Australia, Series 4

Several articles in this issue of the Journal of Agriculture discuss some of the important issues of stubble management. The articles are condensed from some of the papers presented at a stubble workshop at Geraldton in 1991.

Stubble Handling Begins At Harvest, Ed Blanchard

Journal of the Department of Agriculture, Western Australia, Series 4

Long stubble left in the paddock after harvest causes major difficulties at seeding time. To demonstrate the benefits of having short stubble at seeding, the Trayning Land Conservation District Committee created four stubble treatments at harvest in 1988 and sowed into these stubble treatments in 1989.

Cost Effective Stubble Retention Practices, Andrew Green, Ed Blanchard

Journal of the Department of Agriculture, Western Australia, Series 4

To increase the rate of adoption of stubble retention farming systems the Grains Research and Development Corporation is funding a three-year project with the Farm Machinery Unit to develop low cost, stubble handling systems from harvest to seeding

Coke Oven Emissions: A Case Study Of Technology-Based Regulation, John D. Graham, David R. Holtgrave

RISK: Health, Safety & Environment (1990-2002)

After examining and analyzing the experience with coke ovens, the authors conclude that attempts to force technology beyond its demonstrated competence can be both expensive and ineffective in controlling hazards. They also suggest implications for pending proposals to further control air pollution.

The Development Of An Efficient Lupin Harvesting Front, E D. Blanchard

Journal of the Department of Agriculture, Western Australia, Series 4

Harvest losses represent a significant reduction in lupin production and farm productivity.

Since 1984, the Department's Farm Machinery Research and Liaison Unit at the Dryland Research Institute has studied the lupin harvesting operation to improve its mechanical efficiency. An experimental and a prototype harvesting front were built and tested in the field. Guidlines for efficient lupin harvesting were produced, and commercial modifications developed.

Feasibility Study Of Maine's Small Hydropower Potential, James D. Sysko

Maine Collection

Feasibility Study of Maine's Small Hydropower Potential

Prepared by James D. Sysko, Small Hydro East, for the Maine State Planning Office, Maine Office of Energy Resources, January 1989.

"This study focuses on finding potential hydropower sites of approximately 50 kw to 1000 kw in capacity."

Improved Fertilizing Practices On The Peel-Harvey Catchment, P T. Arkell

Journal of the Department of Agriculture, Western Australia, Series 4

Broad-acre farmers in the Peel-Harvey catchment have met a challange and achieved a great deal since the fertilizer extension programme started in 1983.

The main objective of the extension programme has been to ensure that every year three-quarters of the farmers make economically and technically sound fertilizer decisions, thus causing a minimum amount of phosphorus to enter the waterways of the Peel-Harvey estuarine system.

The Effects Of A Mandatory Early Shutdown Of Maine Yankee, Maine State Planning Office

Maine Collection

The Effects of a Mandatory Early Shutdown of Maine Yankee

Maine State Planning Office - Richard Silkman, Director (September 1987).

Contents: Introduction / Legal Issues / Economic Issues / Health and Environmental Issues / Conclusions / Appendices

Maine Yankee Shutdown Assessment: A Report To Governor Joseph E. Brennan, Maine State Planning Office

Maine Collection

Maine Yankee Shutdown Assessment: A Report to Governor Joseph E. Brennan

Maine State Planning Office, Maine Office of Energy Resources, Maine Public Advocate

Executive Department - May 1986

Contents: Legal Process / Decommissioning Constraints and Costs / Public and Economic Costs and Benefits / Apprendices

Fundy Tidal Power Development : Preliminary Evaluation Of Its Environmental Consequences To The Resources Of The State Of Maine, Bigelow Laboratory For Ocean Sciences

Maine Collection

Fundy Tidal Power Development : Preliminary Evaluation of Its Environmental Consequences to the Resources of the State of Maine

A Report to the Maine State Planning Office by the Bigelow Laboratory for Ocean Sciences, April, 1984.

"Technical Report No. 35 - Bigelow Laboratory for Ocean Sciences, West Boothbay Harbor, Maine - A Division of Northeastern Research Foundation, Inc."

Contents: Executive Summary / Introduction / Methods / Physical and Biological Consequences / Socio-Economic Consequences / Research Needs / Bibliography / Appendix I. Written Comments on Greenberg Model

Development Of An Integrated Program Of Water Reuse In A Pulp And Paper Mill, Zafar M. Chaudhri

Masters Theses

No abstract provided.

The Economics Of Solar Water Heaters : A Guide For Evaluating The Cost-Effectiveness Of Active Solar Water Heating Systems In Maine, Maine Office Of Energy Resources

Maine Collection

The Economics of Solar Water Heaters : A Guide for Evaluating the Cost-Effectiveness of Active Solar Water Heating Systems in Maine

State of Maine, Executive Department, Office of Energy Resources,

Augusta, Maine (July, 1979).

Contents: Section I: Introduction / Section II: Economic Method: The Life Cycle Cost Analysis / Section III: Factors Affecting the Decision to Buy / Section IV: Explanation of the Tables / Table I - Table IIIA

Innovations In Heat Pumps, Ronald Hunter Howell, Harry J. Sauer Jr.

UMR-MEC Conference on Energy / UMR-DNR Conference on Energy

The status of the residential heat pump industry is reviewed. Some potential improvements in energy efficiency, operational reliability, and initial cost are described and delineated. These possible innovations include two-speed or variable speed compressors, reliable defrost initiation and termination, improved system components, modifications to the basic thermodynamic cycle, add-on-heat pumps, solar assisted heat pumps, annual cycle energy system, chemical heat pumps, and gas fired heat pumps.

University Of Missouri--Rolla Wood Energy Research, Yildirim Omurtag, V. J. Flanigan, Nathan E. Welch

UMR-MEC Conference on Energy / UMR-DNR Conference on Energy

The overall objective of this project is to conduct a research and development program which will lead to the early commercialization of wood gasification technology to process wood residues typical of those found in the Ozark region.

An Annotated Bibliography Of Ocs Documents In Maine, Maine State Planning Office

Maine Collection

An Annotated Bibliography of OCS Documents in Maine

Outer Continental Shelf Memorandum 1

Compiled by Edward H. Shenton & Charles S. Colgan

Maine Coastal Program, Maine State Planning Office, Augusta, Maine, 1977.

Contents: 1. Introduction / 2. OCS - General / 3. OCS - Federal Regulations / 4. Economic Aspects / 5. Environmental Studies / 6. Oil Spills - Effects and Studies / 7. Onshore Effects / 8. The North Sea Experience / 9. Legal Aspects / 10. Petroleum Drilling Technology

Bulletin No 3883 - Dairying In W.A., Western Australian Department Of Agriculture

Bulletins - 3000 - 3999

Western Australia has a small dairy industry compared with its other rural production. However, the industry has consolidated over recent years.

Tree clearing and pasture development on existing holdings and the amalgamation of small dairy farms has led to a rapid increase in the area of pasture per farm. The trend in Western Australia is towards bigger herds, more efficient dairies, more fodder conservation and increasing production per cow and per· hectare.

Opposed Disc Plough Furrows Hard Kimberley Soils, Department Of Agriculture, Western Australia

Journal of the Department of Agriculture, Western Australia, Series 4

THE work of reclaiming the eroded areas of the Ord River catchment has posed special problems for field staff of the Department of Agriculture engaged on this large scale project.

Thousands of miles of furrows must be contour-ploughed and seeded in extremely hard ground over big areas of eroded country.

A Practical Guide To Building Contour Banks With A Road Grader, J E. Watson

Journal of the Department of Agriculture, Western Australia, Series 4

THOUSANDS of miles of contour banks have been built in Western Australia, and most of this earthmoving has been done by tractor and disc plough* or by road grader.

This article describes the technique recommended for bank construction with the road grader.

Water Conservation On The Farm, John W. Lewis

Journal of the Department of Agriculture, Western Australia, Series 4

SMALL scale conservation of water for agricultural use is becoming increasingly important throughout Australia.

As land development intensifies, it is natural that farmers turn to more dams and earthen tanks for stock water and irrigation.

Adequate water is essential to supply the carrying capacities made possible by improved pastures, and where greater quantities of water can be stored, fodder crops, pastures, orchards and vegetables can be irrigated.

Automatic Waterers For Day Old Chickens, P Smetana, W. Ward

Journal of the Department of Agriculture, Western Australia, Series 4

ONE of the most tedious and time consuming tasks on a poultry farm is the provision of water to chicks from day old up to the age of three or four weeks.

Most poultry farmers use half-gallon glass fonts with metal bases for the first few weeks, until the chicks are old enough to use the automatic watering system usually situated along one wall of the brooder house.

This cumbersome glass font system can be replaced by the cheap and easily installed automatic watering system described below. This system has already been adopted by several local poultry farmers.

Sewer System More Than A Million Years Old, Department Of Library Special Collections

Research Collections

Article about the sewer system in early Bowling Green that used fissures in the limestone as a natural sewer; it then flows out to the river. Henry Jameson is shown and an outcropping of oolitic limestone in Reservoir Hill park.