Structural Materials Commons^™

Finite Element Analysis Of Structures With Constrained Viscoelastic Layer Damping, Yung Chen

Mechanical & Aerospace Engineering Theses & Dissertations

It has been demonstrated that constrained viscoelastic layer damping treatments provide an effective means of passive control for structural vibration. These treatments dissipate vibrational energy by inducing shear strain in a thin layer of viscoelastic material. Our interest is in adding passive damping to a structure as an augmentation to active control. For such applications it is desirable to achieve high damping performance in a given frequency range with a minimum of added weight. Most damping treatments employ spatially continuous constraining layers over the entire viscoelastic layer. Plunkett and Lee have shown that the effectiveness of the damping treatment can …

A Systematic Procedure For The Analysis And Design Of Deployable Space Structures, Praveen Kumar

Mechanical & Aerospace Engineering Theses & Dissertations

An integrated graph theory and a symmetry-based approach have been developed for the type synthesis of deployable truss structures. Using this systematic approach, a bay of a deployable structure may be looked upon as being built around an axis or a plane of symmetry, including anti-symmetry. By providing a fictitious joint along this axis, the problem of structural design and analysis can be reduced to the study of one plane or face of the given structure. Each face is considered to be an assemblage of structural links connected by joints which form a closed kinematic chain. The conventional graph representation …

Stability Design Of A Slender Column With Curved Longitudinal Stiffeners, Mark S. Lake

Mechanical & Aerospace Engineering Theses & Dissertations

This thesis presents the results of a stability design study of a slender column with curved longitudinal stiffeners for large space structure applications. The stiffened column concept is attractive because it allows the buckling load of a slender column to be increased at a fairly low cost in increased mass, and at no change in the column packaged size. Linear stability analyses are performed using a "linked-plate" representation of the stiffeners to determine stiffener local buckling stresses. Results from a set of parametric analyses are used to determine an approximate explicit expression for stiffener local buckling in terms of its …

The Use Of Complex Versus Normal Modes In Structural Model Improvement, Chih Lin

Mechanical & Aerospace Engineering Theses & Dissertations

In the past, normal modes approximation to complex modes was employed by most researchers or users in the process of identification or modification of structural systems. This is true, of course for simple structures with no or proportional damping. For complex structures with nonproportional damping, even level of which is small, it will be shown that applying this approximation is inadequate. Use of complex modes instead of approximated normal modes is justified.

An algorithm is presented that computes a set of normal modes from the corresponding measured complex modes. The computed normal modes are then used in the Berman's technique …

Studies Of Fracture And Deformed Surfaces Of High Strength Aluminum Alloys By X-Ray Diffraction, Tamma K. Kumar

Mechanical & Aerospace Engineering Theses & Dissertations

X-ray observations of fatigue fracture and deformed surfaces of 7075-T6 aluminum were conducted in this study. The (111) and (222) diffraction peaks were obtained from the fractured and deformed surfaces. It was observed that in comparison with the base metal, the fracture exhibited line broadening similar to that due to cold working. The broadening is indicative of plastic deformation in the vicinity of the advancing crack tip during the fracture process. Also the different regions of fracture exhibited varying degrees of line broadening. With respect to the fatigue crack, the slow crack growth region showed a greater broadening, and, hence, …