Metallurgy Commons^™

The Use Of Computerized Data Acquisition Techniques To Measure The Kinetics Of A Batch Flotation Process, Jose Antonio Barrera-Godinez

Masters Theses

"The flotation response of a lead ore was measured by utilization of a computer driven data acquisition system. A symmetric, fast and automatic froth removal and weighing system was attached to a conventional laboratory flotation cell. The rate controlling mechanisms were identified by manipulation of the froth removal rate, (FRR), froth layer thickness, (FT), and air flow rate, (AFR). The production of froth, water, solids and value in addition to value recovery and concentrate grade were determined as a function of time of flotation.

The flotation response was controlled by events dependent of AFR when using shallow froths of less …

Fundamental Study Of The Role Of Cathode Structure On Zinc Electrowinning, Horacio M. Aros

Doctoral Dissertations

"The influence of cathode macromorphology on the current efficiency of zinc electrowinning was determined.

The studies have shown that surface roughness affects current efficiency during zinc electrowinning, particularly when the electrolyte contains impurities such as nickel and antimony. Current efficiency does not change with surface roughness as long as the electrolyte is sufficiently pure.

Zinc deposited on smooth zinc cathodes tends to retain a more favorable structure and macromorphology, which is less sensitive to the effects caused by antimony and nickel. Glue helps to counteract the effect of the impurities; however, its presence in the electrolyte at certain combinations with …

Formability Of 356 Aluminum, Karol Krumrey Schrems

Masters Theses

"Although aluminum casting alloys are not often thought of as being formable, this thesis examines this possibility. Aluminum alloy 356 was cast in permanent molds and subsequently deformed by rolling (providing compressive loading) and bending (providing tensile loading). Cold forming was found to be very limited, while forming at elevated temperatures was comparatively easy and permitted reductions of up to 90%. Tensile properties and microstructures were examined in detail. Forming breaks up the eutectic silicon and intermetallic compounds. The yield strength and tensile strength increased almost linearly with increasing total percent reduction. The elongation at first increases with total percent …

Characterization Of The Fluid-Dynamic Mixing Of A Bottom Gas-Injected Channel Reactor Using Low-Temperature Modelling, Jay Bernett Gassel

Masters Theses

"Variables influencing the mixing in a single-phase (30.5 x 60 x 606 cm) and a two-phase (20 x 40 x 200 cm) channel reactor model were studied. Tracer and/or neutral density particle techniques were used to determine an eddy diffusivity, De, for the system(s). Three bubbler arrangements were investigated in the one-phase work. A separate apparatus was developed to withstand the corrosiveness of the tetrachloroethylene used in the two-phase work.

Both the electrical conductivity tracer technique and the neutral density particle technique were shown to be feasible experimental techniques for determining an eddy diffusivity in the systems studied. Decreasing liquid …