Metallurgy Commons^™

A Study Of The Deformation Texture And Its Variation In Cold Drawn Nickel Rods, Krishan Kumar Tangri

Doctoral Dissertations

"The production of rods by cold drawing is a development of recent years as compared to other methods of fabrication. Though a good many investigations correlating the observed mechanical properties to the mill practices employed have been reported, the results nevertheless are more of a qualitative and empirical nature. It is well known that the physical properties of a metal product are related to its deformation textures which are characteristic of the metal and the fabricating method used. Thus a study of the deformation textures of cold-drawn rods, specially by x-ray diffraction techniques should provide a much more precise and …

The Rate Of Dissolution Of Aluminum In Hydrofluoric Acid, Yen-Ngen Wang

Doctoral Dissertations

"Pure aluminum has a relatively low strength, and its use is, therefore, rather limited. However, the resistance of pure aluminum to the attack of acids and many neutral solutions is higher than that of less pure aluminum or most of the aluminum-base alloys. For this reason, alclad alloy sheets, are made with a coating of pure aluminum on one or both sides of an aluminum alloy core. The coating is metallurgically bonded to the core over the entire area of contact. Thus the coating electrochemically protects the core from corrosive attack.

Aluminum is more negative in the electrochemical series than …

A Study Of The Dissolution Of Titanium In Acids With Ammonium Fluoride Added, Charles Burroughs Gill

Doctoral Dissertations

"Titanium can no longer be considered a rare metal, even though the modern era of its production came into being only a few years ago. The first discovery of titanium was in 1791 by an English clergyman, the Reverend William Gregor, and the name titanium became universally adopted when so called by a German mineralogist, Martin Klaproth, who rediscovered titanium three years later. Not until 1887 was the relatively pure, 75 percent, metal prepared by L. F. Nilson and O. Pettersson, whose experiments were repeated in 1910 by M. A. Hunter. Hunter is given credit for producing the first metallic …

An Investigation Of The Deformation Textures Of Titanium, Dean Nesbit Williams

Doctoral Dissertations

"With the increase in production of titanium in recent years has come a great interest in the mechanical properties and in the possible uses of this metal. Due to the affinity of titanium for oxygen, nitrogen, carbon, and hydrogen, and the market effect of these elements on the mechanical properties, much of the work previously reported is unreliable. As purer commercial grades of titanium and high purity iodide titanium have become available for examination, research has been undertaken to correct and expand the knowledge of the properties of titanium. Although the uses of titanium are limited at the present time, …

Precise Lattice Parameter Determinations Of Diamond Silicon And Germanium By The Asymmetric Method, Esrefettin Zeki Aka

Doctoral Dissertations

"The construction of the apparatus for production of powder patterns at a definite temperature and the technique for evaluation of x-ray powder patterns by the asymmetric method are described in detail, and the mode of error elimination is discussed.

A new scanning device is designed for use in x-ray diffraction work.

A modified method is described for the determination of densities of solids, which eliminates some of the difficulties interfering with other similar methods thus far proposed. Formulae are derived for the calculation of density as well as for reduction of density at a desired temperature.

The following conclusion are …

The Volatility Of Metallic Sulfides And Their Treatment By Vacuum Metallurgy, Chi-Mei Hsiao

Doctoral Dissertations

"The purpose of this investigation is to determine the vapor pressure or volatility of the sulfides of the following metals by Langmuir's method: a) Zinc b) Cadmium c) Mercury d) Manganese e) Tin f) Lead g) Arsenic h) Antimony i) Molybdenum J) Iron k) Cobalt l) Nickel m) Copper n) Silver o) Calcium p) Aluminum.

The relation of this property to the position of the metals in the periodic table will be discussed, thus the vapor pressure or volatility of the remaining metals can be predicted as to the order of magnitude if the law of periodicity holds.

The possible …

A Study Of The Dissolution Of Titanium In Acids With Emphasis On Hydrofluoric Acid, Ping-Chao Chen

Doctoral Dissertations

"Titanium is practically a new metal. Although it was discovered by W. Gregor in 1791, the pure metal was not prepared until 1910 by M. A. Hunter, and it is only very recently that tremendous interest has been focused on this new metal, as evidenced by the activities of numerous leading laboratories and pilot plants.

The reasons that Ti is gaining increasing attention may be attributed to the natural abundance of Ti ores in reasonable concentration and, what is more important, to its unusual combination of physical and chemical properties. According to F. W. Clark’s classical geochemical data, Ti amounts …

Measurement Of Flotation Rate As A Function Of Particle Size, Thomas Martin Morris

Doctoral Dissertations

“The Problem. The rate of flotation of solid particles determines the percentage recovery of these particles which can be obtained during a given time interval. An examination of operating data from a flotation plant shows that percentage recovery varies with the size of particle.

Many investigators have explored the problem of measuring flotation rate. In most cases the results obtained were expressed qualitatively. The results obtained by one worker were often at variance with results reported by another worker.

This investigation was undertaken with the object of (1) quantitatively measuring the rate of flotation of various sizes of particles and …

A Study Of Certain Ferromagnetic Alloys In The Systems Copper-Manganese-Indium And Copper-Manganese-Gallium, Frederick Arthur Hames

Doctoral Dissertations

"In 1898 F. Heusler discovered that certain alloys containing only copper, manganese, and tin are ferromagnetic. Since that time, ferromagnetic alloys have been reported to occur in the ternary systems copper-manganese-aluminum, copper-manganese-arsenic, copper-manganese-boron, copper-manganese-antimony, copper-manganese-zinc, silver-manganese-aluminum, and silver-manganese-tin. Such ferromagnetic alloys containing only non-ferromagnetic elements have come to be called "Heusler alloys."

From the metallographic standpoint, the ferromagnetic copper-manganese-aluminum and copper-manganese-tin alloys have been the most fully investigated of the Heusler alloys. These alloys owe their ferromagnetism to the beta phases in their respective systems. The structure of the beta phase is based on a body-centered cubic lattice.

In view …