Materials Science and Engineering Commons^™

Direct Design Of A Portal Frame, Angel Fajardo Ugaz

Dissertations and Theses

This investigation was undertaken to develop plastic design aids to be used in the direct design of optimum frames. It uses the concept of minimum weight of plastically designed steel frames, and the concept of linear programming to obtain general solutions. Among the special characteristics of this study are: A. The integration of both gravity and combined loading conditions into one linear programming problem. B. The application of the revised simplex method to the dual of a parametric original problem. C. The application of A and B above in the development of design aids for the optimum design of symmetrical …

Comparative Study Of Lightweight And Normal Weight Concrete In Flexure, Mohammad Zareh

Dissertations and Theses

This investigation represents a comparative study of the flexural behavior of lightweight and normal weight concrete. Both theoretical and experimental moment-curvature characteristics of the tested specimens were used to study the flexural behavior.

A generalized computer program to determine the moment-curvature relationships of a singly reinforced rectangular concrete beam was developed.

For this limited study it was observed that lightweight concrete beams when compared to normal concrete beams achieve comparable moment capacity (about 92% of normal weight concrete) but exhibit higher deflections (about 40% more than normal weight concrete).

An Experimental Study Of Lateral Soil Pressures And Moments On Flexible Sheet Piles, James H. Donahue

Civil & Environmental Engineering Theses & Dissertations

In order to study the effect compaction has on lateral earth pressures exerted on and bending moments in steel sheet pile bulkheads, an experimental study was undertaken which employed the placement of a non-cohesive soil at two specific densities against three model piles of varying thicknesses. The soil was placed both in a loose and a dense state and the bending strains and deflections of the sheet piles were measured at various stages of backfill. Surface loadings were then placed after completion of the backfilling to observe the effects these loads had on the bending moments. The results of the …

Disposal Of Effluent From Piggeries, P Mcnamara

Journal of the Department of Agriculture, Western Australia, Series 4

ONE of the major problems associated with an intensive piggery is the disposal of the effluent; the nearer the piggery is to urban areas, the greater the problem.

Concrete In Dairies, D Roger Buchanan

Journal of the Department of Agriculture, Western Australia, Series 4

PRIME requirements for exposed concrete surfaces in dairies are that they should be easily cleansed and should not deteriorate in contact with milk and milk products.

In milking stalls, animal races and on loading platforms hardwearing surfaces which offer good foothold are also necessary.

Some Advances In Milking Shed Installations And Techniques, G W. Scott

Journal of the Department of Agriculture, Western Australia, Series 4

TklG improvements in milk quality and increases in the level of production have occurred in recent years.

This has been largely due to improved dairy premises, technical advances in machine milking and better shed husbandry.

Shearing Shed Design, W L. Mcgarry, D. A. Young, M. Butler

Journal of the Department of Agriculture, Western Australia, Series 4

PLANNING the layout of a shearing shed requires a good deal of thought to ensure its maximum working efficiency.

If the contemplated structure is to serve the dual purpose of storage-shearing shed, it is better to plan a shearing shed that can be used for storage, rather than a storage shed with a view to its utilisation as a shearing shed.

Department Of Agriculture Moved To South Perth, Department Of Agriculture, Western Australia

Journal of the Department of Agriculture, Western Australia, Series 4

After more than half a century in the historic but time-worn building, one of few adorned with the British Government crest of the Lion and the Unicorn, on the Eastern side of government gardens in St George's Terrace, the Departmnet of Agriculture has been transfred to a new location in South Perth.

Making Your Own Beehives, R S. Coleman

Journal of the Department of Agriculture, Western Australia, Series 4

THE publication of this article runs counter to my own principles to some extent as I have long maintained that most beekeepers will find it cheaper in the long run to purchase factory-made hives and frames.

I realise, however, that many apiarists possess both the skill and equipment to make hive-bodies, and that some at least can occupy slack periods profitably in this manner.

Stabilization Studies On Soil-Cement Mixtures For Experimental Lining--Logan Experimental Section--Logan, Utah, United States Department Of The Interior, Bureau Of Reclamation

Elusive Documents

Earth Materials Laboratory Report No. EM-170 covers the laboratory tests made on one type of soil from Logan, Utah, for the purpose of using the soil in soil-cement canal lining experiments. The intention was that two types of soil would be used for experimental linings at Logan, Utah; a fine sandy soil, poorly graded with little or no silt (Classification Symbol SP) and a fine sandy soil with excess silt (Classification Symbol SF-silty). These field test sections which will provide durability and permeability information gathered under natural conditions were carried out as part of a joint lower-cost canal lining experiment …

Aircraft Quality Casting Standards, Robert Katz, Robert Bolin , Depositor

Robert Katz Publications

These standards are to be used in connection with the Handbook for Instructions for Aircraft Designers, 8^th Edition …

In the radiography of aircraft castings, markings appearing on the film may be attributed to either the condition of the castings examined, or to some details of the radiographic process entirely unrelated to the quality of the castings, These latter patterns must be recognized and related to the radiographic process so that sound castings will not be unnecessarily rejected. Radiographs must be carefully compared with the surface irregularities of the casting they represent before an attempt is made to …