Other Engineering Science and Materials Commons^™

Investigation Of Multiple Torch Paw-Based Additive Manufacturing, Nathan Huft

Graduate Theses & Non-Theses

PAW Print 3D (PP3D), a wire and arc additive manufacturing (AM) system was developed. PP3D comprises three plasma arc welding torches arranged radially around a central wire feed. Using three torches was hypothesized to eliminate sensitivity to travel direction. Two deposition modes were developed – continuous, which deposited continuous beads, and dabber, which deposited discreet “dabs” of material. Dabber was hypothesized to provide favorable solidification conditions that would refine the as-deposited grain structure. Three sets of process parameters for each deposition mode were developed. Ineffective workpiece melting was observed and investigated during process development. Using COMSOL Multiphysics software and experimental …

Continuous Flow Process For Recovery Of Metal Contaminants From Industrial Wastewaters With Magnetic Nanocomposites, David Hutchins

Graduate Theses & Non-Theses

Remediation of metal-containing industrial effluents presents both a technical challenge and an economic opportunity. Many industrial waste streams contain low levels of metal ions requiring treatment prior to discharge. Existing treatment technologies are frustrated by disparate compositions and low metal concentrations. Chemical precipitation is effective; however, it requires excessive reagents and discourages selective recovery. Ion-exchange enables recovery, but requires a batch process with extensive operational and maintenance demands, and is rarely implemented in large-scale applications. A continuous flow process capable of selective recovery would present many advantages over existing technologies.

This research examines and develops a continuous flow process for …

3d Printing Of 316l Stainless Steel And Its Effect On Microstructure And Mechanical Properties, Rawn Penn

Graduate Theses & Non-Theses

Laser powder bed fusion or 3D printing is a potential candidate for net shape forming and manufacturing complex shapes. Understanding of how various parameters affect build quality is necessary. Specimens were made from 316L stainless steel at 0°, 30°, 60°, and 90° angles measured from the build plate. Three tensile and four fatigue specimens at each angle were produced. Fracture morphology investigation was performed to determine the fracture mode of specimens at each build angle. Microstructural analysis was performed on one of each orientation. The average grain size of the samples was marginally influenced by the build angle orientation. Tensile …

Adsorption Of Salicylhydroxamic Acid On Selected Rare Earth Oxides And Carbonates, Greer Galt

Graduate Theses & Non-Theses

Adsorption behavior of the anionic collector salicylhydroxamic acid (SHA) on a selected group of rare earth oxides (REOs) and carbonates (RECs) was studied via experimental methods and modelling software. Synthetic oxide and carbonate powders of the rare earth elements cerium (Ce), praseodymium (Pr), europium (Eu), and terbium (Tb) were tested for this research. Studies were conducted at different pH levels to analyze the kinetics of collector adsorption onto the oxide and carbonate surfaces in attempts to optimize recovery parameters for commercial flotation processes using SHA. In addition, thermodynamic software StabCal was implemented to compare theoretical adsorption behavior of collectors SHA …