Open Access. Powered by Scholars. Published by Universities.®

Other Engineering Science and Materials Commons™

Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics

Institution
Keyword
Publication Year
Publication
Publication Type

Articles 31 - 38 of 38

Full-Text Articles in Other Engineering Science and Materials

Influence Of Substrate Stage Temperature And Rotation Rate On The Magneto-Optical Quality Of Rf-Sputtered Bi2.1dy0.9fe3.9ga1.1o12 Garnet Thin Films, Mohammad E. Alam, Mikhail Vasiliev, Kamal Alameh Jan 2018

Influence Of Substrate Stage Temperature And Rotation Rate On The Magneto-Optical Quality Of Rf-Sputtered Bi2.1dy0.9fe3.9ga1.1o12 Garnet Thin Films, Mohammad E. Alam, Mikhail Vasiliev, Kamal Alameh

Research outputs 2014 to 2021

Highly bismuth-substituted iron garnet thin films are prepared on quartz substrates by using a radio frequency (RF) magnetron sputtering technique. We study the factors (process parameters associated with the RF magnetron sputter deposition technique) affecting the magneto-optical (MO) properties of ferrite garnet films of composition Bi2.1Dy0.9Fe3.9Ga1.1O12. All films show high MO response across the visible range of wavelengths after being annealed. In particular, the effects of substrate stage temperature and rotation rate on the various properties of films are studied. Experimental results reveal that the characteristics of garnet films of this type can be tuned and optimized for use in …

Go to article

Structure-Property Relationships Of Polyisobutylene-Block-Polyamide Thermoplastic Elastomers, Morgan Dunn Heskett Dec 2016

Structure-Property Relationships Of Polyisobutylene-Block-Polyamide Thermoplastic Elastomers, Morgan Dunn Heskett

Master's Theses

Thermoplastic elastomers (TPEs) are a class of polymer fit for a wide variety of applications due to their customizability. In the synthesis of these types of materials, an elastically-performing polymer, deemed the “soft block,” is combined with a stiffer “hard block” polymer, each of which can be selected based on their own specific properties in order to achieve desired material behavior in the final copolymer. Recently, the use of polyisobutylene as a soft block in combination with a polyamide hard block has been investigated for use in TPE synthesis. While the material showed some promising behavior, many properties were still …

Go to article

Direct Band Gap Gallium Antimonide Phosphide (Gasbxp1-X) For Solar Fuels., Harry Benjamin Russell May 2016

Direct Band Gap Gallium Antimonide Phosphide (Gasbxp1-X) For Solar Fuels., Harry Benjamin Russell

Electronic Theses and Dissertations

Photoelectrochemical water splitting has been identified as a promising route for achieving sustainable energy future. However, semiconductor materials with the appropriate optical, electrical and electrochemical properties have yet to be discovered. In search of an appropriate semiconductor to fill this gap, GaSbP, a semiconductor never tested for PEC performance is proposed here and investigated. Density functional theory (DFT+U) techniques were utilized to predict band gap and band edge energetics for GaSbP alloys with low amount of antimony. The overall objective of this dissertation is to understand the suitability of GaSbxP1-x alloys for photoelectrochemical water splitting application. Specifically, …

Go to article

Case Studies Of Cavity And External Wall Insulation Retrofitted Under The Irish Home Energy Saving Scheme: Technical Analysis And Occupant Perspectives, Aimee Byrne, Gerard Byrne, Garrett O'Donnell, Anthony Robinson Jan 2016

Case Studies Of Cavity And External Wall Insulation Retrofitted Under The Irish Home Energy Saving Scheme: Technical Analysis And Occupant Perspectives, Aimee Byrne, Gerard Byrne, Garrett O'Donnell, Anthony Robinson

Articles

The residential sector represents 27% of primary energy consumption in Ireland. This paper examines the case study of the Irish government’s national grant scheme to encourage energy efficiency retrofit in private housing. That is the Home Energy Saving (HES) Scheme, later rebranded the Better Energy: Homes (BEH) Scheme. The methodology involved monitoring several homes immediately before and after retrofit alongside discussions with occupants. The examination focused on specific measures commonly introduced through the HES/BEH programme − cavity and external wall insulation. It has been found that a significant decrease in heat loss through the walls was measured in all cases. …

Go to article

Derivation And Validation Of The Friction, Gravitational, And Air Forces Encountered During Installation Of Fiber Optic Cable, Faheed Olayemi Owokoniran Jan 2015

Derivation And Validation Of The Friction, Gravitational, And Air Forces Encountered During Installation Of Fiber Optic Cable, Faheed Olayemi Owokoniran

All Graduate Theses, Dissertations, and Other Capstone Projects

This paper presents an introduction to fiber optic cable and the fiber optic communication system. An important phase in the supply of this new technology is to transport the fiber optic cable to the vicinity of service. Cable pulling and cable blowing - laminar flow; piston type - are the two main methods of installing fiber optic cable. Both methods of installation have limiting factors that need to be evaluated in order to perform a successful installation. The limiting factors for laminar type cable blowing are further discussed in this paper. A method was proposed to determine the forces - …

Go to article

Lightweight Uav Launcher, Ben Miller, Christian Valoria, Corinne Warnock, Jake Coutlee Jun 2014

Lightweight Uav Launcher, Ben Miller, Christian Valoria, Corinne Warnock, Jake Coutlee

Mechanical Engineering

This report discusses the design, construction, and testing of a lightweight, portable UAV launcher. There is a current need for a small team of soldiers to launch a US Marine Tier II UAV in a remote location without transport. Research was conducted into existing UAV launcher designs and the pros and cons of each were recorded. This research served as a basis for concept generation during the initial design development stage. It was required that the design weigh less than 110 lbs, occupy a smaller volume than 48" x 24" 18" in its collapsed state, be portable by a single …

Go to article

Electrospinning Applications Air Filtration And Superhydrophobic Materials, Negar Ghochaghi, Adetoun Taiwo Jan 2014

Electrospinning Applications Air Filtration And Superhydrophobic Materials, Negar Ghochaghi, Adetoun Taiwo

Graduate Research Posters

Electrospinning is a widely applicable technique that generates non-woven fibers in the micro and nano range. In this project two of its applications are highlighted namely filtration media and enhancement of wettability. The first project demonstrates that electrospinning can be used to produce new fiber filtration media with controlled microstructure. The bimodal and unimodal orthogonal and random filters were made and characterized against their filtration efficiency and pressure drop. Figure of Merit (FOM) was also calculated and discussed. It is shown that the FOM increases when the electrospun fibers are arranged into alternating layers of aligned course and fine fibers. …

Go to article

Identifying Changes In Climatic Trends And The Fingerprints Of Landuse And Landcover Changes In The High Plains Of The Usa, Denis Mutiibwa Jul 2011

Identifying Changes In Climatic Trends And The Fingerprints Of Landuse And Landcover Changes In The High Plains Of The Usa, Denis Mutiibwa

Department of Agricultural and Biological Systems Engineering: Dissertations, Theses, and Student Research

Human activities such as conversion of natural ecosystem to croplands and urban-centers, deforestation and afforestation impact biophysical properties of land surface such as albedo, energy balance, and surface roughness. Alterations in these properties affect the heat and moisture exchanges between the land surface and atmospheric boundary layer. The objectives of this research were; (i) to quantitatively identify the High plains’ regional climate change in temperatures over the period 1895 to 2006, (ii) detect the signatures of anthropogenic forcing of LULC changes on the regional climate change of the High Plains, and (iii) examine the trends in evolving regional latent heat …

Go to article

First Prev