Other Engineering Science and Materials Commons^™

Experience Of Creation The Combined Power Complexes On The Basis Of Renewable Energy Sources, R.A. Zakhidov, A.I. Anarbaev, D.B. Kodirov, F.H. Mukhtarov

Irrigation and Melioration

At the article the combined energy complexes based on renewable energy sources implemented in various countries is analyzed. The regime issues of the most efficient use of maximum generation of electrical energy from solar, wind, biogas sources at reserved diesel station are given. Designs of generator modules based on a kinetic energy buffer storage device for preserving the quality of electricity from renewable energy sources with frequent changes in electrical loads of consumers are considered.

Analysis Of Results Of Researches Of Electrotechnological Treatment Of The Cotton Trouble Up To The First Crop Collection, A. Muhammadiev, A.I. Pardaev

Irrigation and Melioration

This article discusses the electrophysical characteristics of plants, more precisely the disclosure of the mechanism of electrical action on the plant through the study of the specific electrical resistance, as well as the task of developing the technological parameters of the electro-technological processing of crops. Knowledge of current value is given, passing through the minted and the rest of the cotton, determination of the negative impact of electrotechnological stamping of cotton on growth and development, yield, by electrotechnological method, including studies of the minted part of cotton, the death of the leaves, the seeds of the pests, the absence of …

Importance Of Creating A System Of Land And Cadastral Data For Subjects Of Agriculture, К. Rakhmonov

Irrigation and Melioration

The generation of electronic data using the land plot scheme while maintaining the land cadastre provides significant convenience for users. Based on this concept, the author explains the conditions, factors and elements of the formation of the contours of land within the land, which plays an important role in the land cadastral work. In particular, the elements of the contour of the earth, that is, the conditions and composition of the border, the area and the order of formation of numbers, are reflected in a separate figure. It is known that the composition of agricultural land plays an important role …

Nonhydrostatic Modeling Of Flow Interactions With Highly Flexible Vegetation, Navid Tahvildari, Ramin Familkhalili, Gangfeng Ma

Civil & Environmental Engineering Faculty Publications

Improving our understanding of the interactions between gravity waves, currents, and coastal vegetation, which are nonlinear in nature, enables coastal engineers and managers to better estimate hydrodynamic forces on coastal infrastructure and utilize natural elements to mitigate their impacts. Aquatic vegetation is ubiquitous in coastal waters and it is well-known that flow loses energy over vegetation. Computational modeling of wave-vegetation interaction has been the subject of numerous recent studies and many improvements have been achieved in reducing limitations applied on wave and vegetation behavior in these models. Mechanisms for highly flexible vegetation have been incorporated in a Boussinesq-type model and …

Modelling The Addition Of Limestone In Cement Using Hydcem, Niall Holmes, Denis Kelliher, Mark Tyrer

Conference papers

Hydration models can aid in the prediction, understanding and description of hydration behaviour over time as the move towards more sustainable cements continues.

HYDCEM is a new model to predict the phase assemblage, degree of hydration and heat release over time for cements undergoing hydration for any w/c ratio and curing temperatures up to 450C. HYDCEM, written in MATLAB, complements more sophisticated thermodynamic models by predicting these properties over time using user-friendly inputs within one code. A number of functions and methods based on up to date cement hydration behaviour from the literature are hard-wired into the code along with …

Costs And Benefits Of Flood Mitigation In Louisiana, Arash Taghi Nezhad Bilandi

LSU Doctoral Dissertations

Assessing the costs and benefits of hazard mitigation efforts is an essential component of disaster management, planning, and resilience assessment. These calculations are particularly important in locations vulnerable to multiple hazards with high frequencies, such as coastal Louisiana. This study aims to provide an improved understanding of the costs and benefits of flood mitigation efforts in Louisiana funded by federal government grants between 2005 and 2015. Project data provided by the Governor’s Office of Homeland Security and Emergency Preparedness (GOHSEP) were summarized and missing values were imputed using robust statistical approaches. Elevation project cost was investigated for prediction by statistical …

Simplified Approach For Structural Evaluation Of Flexible Pavements At The Network Level, Mena Souliman, Stefan Romanoschi, Samer Dessouky

Publications

Currently, there are few available simple procedures to identify structurally weak pavement sections utilizing Falling Weight Deflectometer (FWD) data at the network level (e.g., city, state or province). A simple method is required to determine the structural condition of pavement sections that can be directly implemented and automated in current pavement databases. The objective of this research study is to develop a simple analysis method to determine the structural condition of pavement sections utilizing the currently available non-destructive testing (NDT) deflection measurement devices at the network level that can be directly implemented and automated in the database of a typical …

Modeling Sulfate Attack In Modern Concrete For Building Sustainable And Resilient Infrastructure, Zachary Grasley

Publications

External sulfate attack is a complex phenomenon and is manifested in the form of large expansion, cracking, and spalling depending on the exposure solution and material constituent properties. Several models were developed in the past to demonstrate sulfate attack mechanisms that account for the diffusion of sulfate ions into the porous concrete and the successive deformation triggered by the chemical reaction and precipitation of expansive agents. However, none of these models accounts for the effect of the migration of solvent water from the low solute concentration solution to high solute concentration solution driven by the osmotic pressure. Osmotic pressure is …

Development Of Self-Healing Mechanisms For Asphalt Pavements, Max Abelardo Aguirre Deras

LSU Doctoral Dissertations

Self-healing mechanisms, such as microcapsules or hollow-fibers, filled with an asphalt rejuvenator present an emerging technology that would enhance an asphalt mixture’s resistance to cracking damage caused by vehicular and environmental loading. The objectives of this study were to: (a) Evaluate the effects of asphalt rejuvenators on hot-mix asphalt mixtures in order to test its effects on the fundamental engineering properties of the mixtures at high and intermediate temperatures; (b) Develop a synthesis procedure for production of microcapsules and hollow-fibers containing an asphalt rejuvenator; (c) Evaluate the self-healing efficiency of double-walled microcapsules and hollow-fibers filled with an asphalt rejuvenator, through …

Case Studies Of Cavity And External Wall Insulation Retrofitted Under The Irish Home Energy Saving Scheme: Technical Analysis And Occupant Perspectives, Aimee Byrne, Gerard Byrne, Garrett O'Donnell, Anthony Robinson

Articles

The residential sector represents 27% of primary energy consumption in Ireland. This paper examines the case study of the Irish government’s national grant scheme to encourage energy efficiency retrofit in private housing. That is the Home Energy Saving (HES) Scheme, later rebranded the Better Energy: Homes (BEH) Scheme. The methodology involved monitoring several homes immediately before and after retrofit alongside discussions with occupants. The examination focused on specific measures commonly introduced through the HES/BEH programme − cavity and external wall insulation. It has been found that a significant decrease in heat loss through the walls was measured in all cases. …

Cement Based Batteries And Their Potential For Use In Low Power Operations, Aimee Byrne, Niall Holmes, Brian Norton

Articles

This paper presents the development of an innovative cement-electrolyte battery for low power operations such as cathodic protection of reinforced concrete. A battery design was refined by altering different constituents and examining the open circuit voltage, resistor loaded current and lifespan. The final design consisted of a copper plate cathode, aluminium plate anode, and a cement electrolyte which included additives of carbon black, plasticiser, Alum salt and Epsom salt. A relationship between age, temperature and hydration of the cell and the current it produced was determined. It was found that sealing the battery using varnish increased the moisture retention and …

Preliminary Investigation Into The Rate Of Carbonation Of Concrete Blocks Under Normal Production Yard Conditions, Aimee Byrne, Eanna Nolan

Conference papers

The release of CO2 from calcination during the manufacture of cement can be partially or fully offset by the CO2 it naturally absorbs during its lifetime. This paper reports results from a preliminary investigation into the rate of carbonation in concrete blocks stacked in a production yard over a period of 6 months. The blocks were stacked in a normal manner under natural exposure conditions. Carbonation progress was determined by splitting the blocks and spraying the freshly exposed surface with a phenolphthalein solution at intervals over the test period. It was found that the rate of the carbonation front progression …

An Overview Of The Development Of Cement-Based Batteries For The Cathodic Protection Of Embedded Steel In Concrete, Aimee Byrne, Niall Holmes, Brian Norton

Conference papers

This paper presents an overview of the cement-based batteries developed in DIT for use in the cathodic protection of embedded steel in reinforced concrete undergoing chloride-induced corrosion. Cathodic protection delivers an external current (approximately 20mA per m2 of embedded steel) which effectively polarises the internal current generated during corrosion. The batteries developed in DIT comprise of a cement-based electrolyte containing different additives including sand, aggregate, salts, carbon black and plasticiser with protruding anode and cathode metal plates. These batteries produced an initial electrical output of 1.5V and 23mA through a 10 resistor as measured using data acquisition units and a …

Mode I Fracture Toughness Of Eight-Harness-Satin Carbon Cloth Weaves For Co-Cured And Post-Bonded Laminates, Josh E. Smith

Master's Theses

Mode I interlaminar fracture of 3k 8-Harness-Satin Carbon cloth, with identical fill and weft yarns, pre-impregnated with Newport 307 resin was investigated through the DCB test (ASTM D5528). Crack propagations along both the fill and weft yarns were considered for both post-bonded (co-bonded) and co-cured laminates. A patent-pending delamination insertion method was compared to the standard Teflon film option to assess its applicability to mode I fracture testing. The Modified Beam Theory, Compliance Calibration method, and Modified Compliance Calibration method were used for comparative purposes for these investigations and to evaluate the validity of the proposed Equivalent Stiffness (EQS) method. …

Plastic Deformation Of Astm A36 Steel Using Two-Stage Light Gas Gun, Shawoon Kumar Roy

College of Engineering: Graduate Celebration Programs

To characterize material deformation in high velocity impact. To validate material models for computation simulation purposes.

This ongoing research is an attempt to study the plastic deformation of A36 steel plate (0.5” thick) under hypervelocity impact. Plastic deformation of the target plate was simulated using finite element software LS-DYNA.

Laboratory And Field Evaluation Of Two Warm-Mix Additives In Connecticut And Validation Of An Alternative Moisture Susceptibility Test, Alexander K. Bernier

Master's Theses

The first official state Warm-Mix Asphalt (WMA) pavement project in Connecticut was constructed between July 20th and 22nd, 2010 and it involved three experimental sections, i.e. one section with a conventional HMA (control section) and two WMA sections with different technologies, wax and foamed asphalt. All three sections are located on Route 70 in central Connecticut. The materials were collected in loose form and reheated and compacted in laboratory conditions (laboratory fabricated specimens). This paper discusses the effect of mix type on the results from several tests conducted in the laboratory, such as Semi-Circular Bending, Hamburg Wheel Tracking, Indirect Tensile, …

Development Of A Structured Concrete Thermocline Thermal Energy Storage System, Bradley M. Brown

Graduate Theses and Dissertations

The past couple of decades have shown a concern when considering the way the world obtains its power. The focus has been switching from fossil fuels that have been used for hundreds of years to renewable energy sources, such as the sun. Solar energy is readily and infinitely available for harnessing. One problem with solar energy, though, is its inability to be used during the night time and during cloud covered weather. A solution to this problem is the use of energy storage mechanisms. For solar plants that use solar thermal energy (concentrating solar power plants), thermal energy storage (TES) …

Identifying Changes In Climatic Trends And The Fingerprints Of Landuse And Landcover Changes In The High Plains Of The Usa, Denis Mutiibwa

Department of Agricultural and Biological Systems Engineering: Dissertations, Theses, and Student Research

Human activities such as conversion of natural ecosystem to croplands and urban-centers, deforestation and afforestation impact biophysical properties of land surface such as albedo, energy balance, and surface roughness. Alterations in these properties affect the heat and moisture exchanges between the land surface and atmospheric boundary layer. The objectives of this research were; (i) to quantitatively identify the High plains’ regional climate change in temperatures over the period 1895 to 2006, (ii) detect the signatures of anthropogenic forcing of LULC changes on the regional climate change of the High Plains, and (iii) examine the trends in evolving regional latent heat …