Engineering Mechanics Commons^™

The Use Of Complex Versus Normal Modes In Structural Model Improvement, Chih Lin

Mechanical & Aerospace Engineering Theses & Dissertations

In the past, normal modes approximation to complex modes was employed by most researchers or users in the process of identification or modification of structural systems. This is true, of course for simple structures with no or proportional damping. For complex structures with nonproportional damping, even level of which is small, it will be shown that applying this approximation is inadequate. Use of complex modes instead of approximated normal modes is justified.

An algorithm is presented that computes a set of normal modes from the corresponding measured complex modes. The computed normal modes are then used in the Berman's technique …

Studies Of Fracture And Deformed Surfaces Of High Strength Aluminum Alloys By X-Ray Diffraction, Tamma K. Kumar

Mechanical & Aerospace Engineering Theses & Dissertations

X-ray observations of fatigue fracture and deformed surfaces of 7075-T6 aluminum were conducted in this study. The (111) and (222) diffraction peaks were obtained from the fractured and deformed surfaces. It was observed that in comparison with the base metal, the fracture exhibited line broadening similar to that due to cold working. The broadening is indicative of plastic deformation in the vicinity of the advancing crack tip during the fracture process. Also the different regions of fracture exhibited varying degrees of line broadening. With respect to the fatigue crack, the slow crack growth region showed a greater broadening, and, hence, …