Engineering Science and Materials Commons^™

Electrocatalytic Oxidation Of Glucose On Nano Pt/C Electrode, Cui-Lian Chen, Xiao-Lan Wei, Pei Kang Shen

Journal of Electrochemistry

Nano Pt/C electrocatalysts were prepared by intermittent microwave heating method.The electrooxidation of glucose on smooth Pt and～Pt/C electrodes has been studied and compared.The results showed that the electrochemical properties on nano Pt/C were improved due to the reduction of the overpotential and the increase in the kinetic rate.The surface area would be significantly increased when the particle size of the catalyst was reduced to nano-scale,resulting in the increase in the activity.The enhancement in the resistance to poisoning could be explained that the oxygen-containing species are easier to react with poisoning species on nano Pt/C and re-active the electrode.

Solid State Synthesis And Electrocatalysis Of Pt/Moo3 For The Oxidation Of Methanol, Qing Wang, Yi-Ming Zhou, Yang Shao, Yi-Gang Ji, Juan Xu, Ya-Wen Tang, Tian-Hong Lu, Tao Shen

Journal of Electrochemistry

The electrocatalyst, Pt/MoO₃ synthesized by solid state reaction, was used for the oxidation of methanol in direct methanol fuel cells. The X-Ray diffraction and cyclic voltammetry were employed to investigate the performance of the material. It was shown that the typical diffraction peaks for Pt appeared in XRD. And a good electrocatalysis for methanol oxidation was observed. The peak potential of the methanol oxidation appeared at ca. 0.63V(vs.SCE) and the peak current density for the oxidation was 78.1 mA⋅cm^-2.

Electrochemistry And Electrocatalysis Of A Novel Μ-Oxamido Copper(Ⅱ) Binuclear Complex, Gui-Lian Gao, Guo-Bao Li, Qiu-Xia Yang, Xue-Lin Wang

Journal of Electrochemistry

In this paper, the cyclic voltammetric and spectroelectrochemical behaviors of μ-oxamido Copper(Ⅱ) Binuclear Complex (deCu) in PBS were studied. Cyclic voltammograms of this complex in PBS (pH=9) exhibited two reductive peaks (E_pc1 =-0.25 V, E_pc2 = -0.50 V) at hanging mercury drop electrode(HMDE), peaks at -0.50 V and -0.25 V corresponded to the reduction of ligand and copper(Ⅱ) complex, respectively. The spectroelectrochimical experiments showed that there was a new absorption band at 440 nm, and the absorption peaks at 270 nm, 280 nm red shifted to 300 nm, 310 nm under potential of -0.75 V. It was meant …

The Mechanism Of Electrocatalytic Reduction Of Oxygen On Manganese Dioxide, Yu-Liang Cao, Han-Xi Yang, Xin-Ping Ai, Li-Fen Xiao

Journal of Electrochemistry

The oxygen electroreduction on the MnO₂ electrode was investigated by analysis of the polarzation properties of oxygen reduciton and its dependence on MnO₂ discharge state, in combination with the characterization of discharge intermediate and the kinetic parameters of the oxygen reduction. Based on the experimental observation and mechanistic analysis, it was suggested that the reduction of oxygen was closely related to the discharge behaviors of MnO₂. When MnO₂ was electrochimically reduced to MnOOH, it was immediately oxidized by oxygen molecules. Thus the oxygen reduction proceeds through continuous oxidation of the discharge product of MnO_{2 …}

Preparation Of Ti-Based Nanocrystalline Tio2 Film Electrode With High Activity, Dao-Bao Chu, Guang-Xia Shen, Xing-Fu Zhou, Chang-Jian Lin, Hua-Shui Lin

Journal of Electrochemistry

The potentiostatic electrosynthesis of Ti(EtO)₄ was studied by anodic dissolution of metal titanium(TA1) in solution of 0.005 mol·L^-1 (EtO)₄NBr in the ethanol (AR) in the presence negligible CH₃COCH₂COCH₃. The Ti-based nanocrystalline TiO₂ Film electrode (Ti/nano-TiO₂) was prepared by sol-gel method. By TEM, SEM and XRD, it has been shown that the anatase particle of TiO₂ was 10～35 nm in diameter and the film was 0.5 μm in thickness. The nanocrystalline film was composed of a three-diminsional network of interconnected particles. Reodx behavior and electrocatalytic activities of …

How Can Direct Mthanol Fuel Cell Benefit From Carbonate Media, Lin Zhuang, Yang Wang, Jun-Tao Lu

Journal of Electrochemistry

The kinetics of methanol oxidation and oxygen reduction in 0.5 mol/L K₂CO₃ were compared with those in 0.5 mol/L H₂SO ₄. Experiments revealed that carbonate media could be more beneficial to direct methanol fuel cell(DMFC). Firstly, both electrode reactions show better performance in the carbonate than in the acid; secondly, materials other than noble metals become possible to be used as the anodic and cathodic catalysts; thirdly, the potential dectease caused by methanol crossover could be depressed by using metal oxide catalysts not stable in acid, such as MnO₂.

Progresses In Surface Electrochemistry And Electrocatalysis ——A Review On The 1997 Joint International Meeting Of Electrochemistry And 97' International Meeting Of Surface Electrochemistry, Shigang Sun

Journal of Electrochemistry

The progresses in surface electrochemistry and electrocatalsis reported in the 1997 joint international meeting of electrochemistry and in the 97′ international meeting of surface electrochemistry were reviewed. The main trends described in this paper consisted of 7 aspects: 1) the studies employing single crystal electrodes, 2) the development of in situ methods of diverse spectroscpoy, 3) the innovation of new research techniques, 4) the preparaton of electrocatalyst of high performances, 5) the quantitative studies on kinetics of electrocatalytic reactions, 6) the investigation on the dynamic processes of surface by timeresolved methods, and 7) the theoretical modeling and simulation of surface …

The Preparation Of Heteropoly Compound Polypyrrole Film Modified Electrode And Its Electrochemical Properties, Weiqing Wang, Xiumei Zhang, Long Cheng, Baifeng Liu, Shaojun Dong

Journal of Electrochemistry

Electronically conducting polypyrrole doped with heteropolyanions K₁₀H₃[Nd(SiMo₇W₄)₂]·xH₂O(denoted as [Nd(SiMo₇W₄)₂]^13-) was synthesized by electrochemical polymerization. This modified electrode maintains the electrochemical and electrocatalytic properties of heteropolyanion, with having good stability and electrocatalytic activity on the reduction of nitric oxide in acidic aqueous solution.

A Investigation Of Hydrogen-Storage Alloy As Catalytic Electrode For Hydrogenation Of Nitrobenzene, Shigang Lu, Hanxi Yang, Changfa Wan

Journal of Electrochemistry

Since hydrogen-storage alloy ean not only absorb hydrogen atoms to form highlyreactive metal hydride as hydrogen source by electrolysis but also possesses a certain catalytic activityfor hydrogenation,it is thus feasible to utilize the allov as a novel electrode for electrolvtichydrogenation in organic electroreduction. This work employed misch metal AB₅ type alloy as acatalytic electrode and studied the electrochemical hydrogenation of nitrobenzene.

The hydrogen-storage electrode (MH) was a plastic bonded electrode sheet made from a paste of Mm(NiCoMnAl)₅ alloy powder and teflon emulsion. The electrolysis was performed at constantcurrent and controlled potential in a three electrode cell of H-type …