VLSI and Circuits, Embedded and Hardware Systems Commons^™

The Design Of Cmos Front-End Amplifiers For Electrical Impedance Applications, Yueh-Ching Teng

Dartmouth College Ph.D Dissertations

Electrical Impedance Tomography (EIT) is a medical imaging methodology that does not need any kind of ionizing radiation. It is significantly cheaper and smaller than Computerized Tomography (CT) or Magnetic Resonance Imaging (MRI). These advantages make EIT particularly suitable for emerging applications like the continuous medical imaging and telemonitoring of organ function. Current bench-top EIT systems are bulky and require shielded cables to interface with measurement electrodes. The cable introduces parasitic capacitances which shunt the desired signals and degrade the accuracy of the measurements. A EIT system based on application-specific integrated circuits (ASICs) can reduce the parasitic and stray capacitance …

5-Bit Dual-Slope Analog-To-Digital Converter-Based Time-To-Digital Converter Chip Design In Cmos Technology, Jojoe S. Sagoe

LSU Master's Theses

Time-to-Digital Converters (TDC) have gained increasing importance in modern implementations of mixed-signal, data-acquisition and processing interfaces and are used to perform high precision time intervals in systems that incorporate Time-of-Flight (ToF) or Time-of-Arrival (ToA) measurements. The linearity of TDCs is very crucial since most Digital Signal Processing (DSP) systems require very linear inputs to achieve high accuracy.

In this work, a TDC has been designed in the 0.5 μm n-well CMOS process that can be used for on-chip integration and in applications requiring high linearity. This TDC used a Dual-Slope-ADC-based architecture for the time-to-digital conversion and consists of the following …

Cmos Radioactive Isotope Identification With Multichannel Analyzer And Embedded Neural Network, Samuel Murray

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

A radiation detection and identification system is designed and implemented to perform gamma ray spectroscopy on radioactive sources and identify which isotopes are present in the sources. A multichannel analyzer is implemented on an ASIC to process the signal produced from gamma rays detected by a scintillator and photomultiplier tube and to quantize the gamma ray energies to build a histogram. A fast, low memory embedded neural network is implemented on a microcontroller ASIC to identify the isotopes present in the gamma ray histogram produced by the multichannel analyzer in real time.

Advisors: Sina Balkir and Michael W. Hoffman

Low Voltage Cmos Sar Adc Design, Ryan Hunt

Electrical Engineering

This project centers on the design of a single ended 10-bit successive approximation register analog to digital converter (SAR ADC for short) that easily interfaces to a micro-controller, such as an Arduino. With micro-controller interfacing in mind, the universal data transfer technique of SPI proved an easy way to communicate between the ADC and the micro-controller. The ADC has a range of 1V (highest code value) to 0V (lowest code value) and operates from a single voltage rail value of 1.8V. Typical SPI clock speeds run on the order of 2MHz and with a 10-bit ADC this means a sampling …

Cmos Smart Camera With Focal Plane Neighborhood-Parallel Image Processing, Joseph A. Schmitz

Department of Electrical and Computer Engineering: Dissertations, Theses, and Student Research

A neighbhorhood-based smart camera architecture is designed and implemented in a 0.13 μm CMOS technology. Each 8 × 8 region of pixels contains a small processor with local memory, which are tiled to form a full-resolution camera. Each processor operates in parallel, enabling high-speed image processing suitable for tracking and recognition tasks. The architecture features the programming flexibility of designs us- ing chip-level and row-level processors while preserving the scalability of pixel-parallel processing elements. The neighborhood processors are implemented physically be- tween the pixel photodiodes, creating multiple design challenges that are discussed in detail.

Advisors: Sina Balkir and Michael W. …

Design Techniques To Improve Time Dependent Dielectric Breakdown Based Failure For Cmos Circuits, Emanuel S. Tarog

Master's Theses

This project investigates the failure of various CMOS circuits as a result of Time Dependent Dielectric Breakdown (TDDB) and explores design techniques to increase the mean time to failure (MTTF) of large-scale circuits. Time Dependent Dielectric Breakdown is a phenomenon where the oxide underneath the gate degrades as a result of the electric field in the material. Currently, there are few well documented design techniques that can increase lifetime, but with a tool chain I created called the MTTF Analyzing Program, or MAP, I was able to test circuits under various conditions in order to identify weak links, discover relationships, …