VLSI and Circuits, Embedded and Hardware Systems Commons^™

Enercon Station Vacuum Pump Replacement, Clint Hembree, Jared D'Amico, Connor Moore, Paul Jeffrey Fontenot, Sydnee Castello, J.J. Clements

Senior Design Project For Engineers

This details the progress of the ENERCON pump replacement project as completed by the Kennesaw State University interdisciplinary senior design group. This project is a two-semester capstone effort for the engineering program at Southern Polytechnic School of Engineering, overseen by Dr. McFall during Fall 2020 and Dr. Khalid during Spring 2021 semesters. The 2020-2021 KSU Interdisciplinary Senior Design team was tasked with completing an Engineering Change Package (ECP) for existing vacuum pumps at ENERCON Station. The mechanical, electrical, and civil students worked together, performing evaluations on existing plant systems to ensure the plant could support the new vacuum pumps. By …

Autonomous Speed Control For Kia Optima, Andrew J. Combs, Kyle Fugatt, Kevin Mcfall

The Kennesaw Journal of Undergraduate Research

The standard method for speed control is the cruise control system built into most modern vehicles. These systems employ a PID controller which actuates the accelerator thus, in turn, maintains the desired vehicle speed. The main drawback of such a system is that typically the cruise control will only engage above 25 mph. The goal of this paper is to describe a system which we used to control vehicle speed from a stop to any desired speed using an Arduino microcontroller and a CAN BUS shield, from where autonomous features can be built upon. With this system, we were able …

Implementation Of Range Autofocus For Sar Radar Imaging, Nicholas J. Testin, Philip Davis

KSU Journey Honors College Capstones and Theses

The range calculation for an FMCW radar depends on accurate linear modulation. In some circumstances, linear modulation may not be available and must be corrected for. This paper describes an autofocus technique used to correct for phase error due to non-linearities in the components of a FMCW radar. Also described here is the algorithm used in calculating the phase error and application of the phase correction with triangle modulation. Known errors were calculated at certain distances and applied to correcting the phase of data taken at similar distances. The results given were generated using a SAR working outside linear ranges.

Data Logging System For A Synthetic Aperture Radar Unit, Nicholas J. Testin, Philip Davis, Ian Dorell, Alexander Gillespie

KSU Journey Honors College Capstones and Theses

A small, existing radar unit lacked the ability to automatically store the data it was receiving, which made its use clunky and cumbersome. A system was constructed to allow an on-board microprocessor to track distance traveled, and automatically store the data output from the radar unit to a portable memory unit for later data processing. Distance traveled is determined using a specially designed mobile cart, which electronically converts the rotation of a wheel into an electrical signal while also providing stability for taking accurate radar measurements. The output data from the radar unit is stored as a properly-formatted sound file …

Wirelessly Connected Sensor Acquisition System For Remote Nursing Applications, Yuhua Hu

Dissertations, Theses and Capstone Projects (Full IR Collection)

Taking advantage of the equipment used in the "Remote Nursing" project, nurses can watch patients' status remotely. The equipment, which is installed in the patient's ward or home, can monitor them and their environment. This project demonstrates this using a microcontroller system that interfaces to a video camera and temperature and humidity sensors in the room. Also a servomotor is installed to control the position of the camera. The microcontroller communicates wirelessly with a PC.

This project is focused on hardware rather than software. It is to test the video camera and sensors being used over the microcontroller through the …