Open Access. Powered by Scholars. Published by Universities.®
VLSI and Circuits, Embedded and Hardware Systems Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in VLSI and Circuits, Embedded and Hardware Systems
Design Of A Bandgap Voltage Reference, Nicolaus Vail
Design Of A Bandgap Voltage Reference, Nicolaus Vail
Electrical Engineering Undergraduate Honors Theses
This thesis details the design process of a bandgap voltage reference (BGR) integrated circuit in a 180 nm CMOS process. A BGR provides a constant DC voltage across a range of operating temperatures and supply voltages. By its nature, the circuit is intended as a reference, not to provide current, so the output would be connected to a very high impedance, such as the gate of a transistor. At 27°C, this design provides a 955 mV reference voltage given a nominal VDD of 3 V. From 20°C to 175°C, the output voltage has a variance of 7.2 mV (approximately 0.8%) …
Design And Fabrication Of A Microstrip Bandpass Filter In Ltcc, Allison Rucker
Design And Fabrication Of A Microstrip Bandpass Filter In Ltcc, Allison Rucker
Electrical Engineering Undergraduate Honors Theses
The goal of the project was to design and fabricate a bandpass filter with a center frequency of 25GHz with a 2GHz bandwidth. The first step was to do the calculation to design a bandpass filter to meet these specifications along with the properties of the DupontTM GreenTapeTM 9K7. HFSS was then used to verify the results from the initial calculations. There was a significant error between the two results, so more tweaking was done to the calculations to get a better center frequency. After a final design was decided, the fabrication process started. Low-Temperature Co-Fired Ceramics (LLTC) …
Implementation Of Natural Switching Surface Control For A Flyback Converter, Ethan Storm Williams
Implementation Of Natural Switching Surface Control For A Flyback Converter, Ethan Storm Williams
Electrical Engineering Undergraduate Honors Theses
The flyback converter is an extremely common topology used for DC/DC power conversion. Widely used methods to control the flyback converter include voltage mode and current mode controllers. More recently, sliding mode control has been developed for the flyback converter. While these control methods may be considered adequate, the Natural Switching Surface (NSS) sliding mode control method detailed in this thesis presents a more robust controller. NSS control eliminates the effects presented from variations in components and design as well as minimizes the effects from external disturbances. This thesis steps through the complete design and implementation process of a NSS …