Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Institution
- Publication
- Publication Type
Articles 1 - 10 of 10
Full-Text Articles in Systems and Communications
Archimedean Spiral Antenna Array With Klopfenstein And Exponential Tapered Balun Feeds, Leo Joseph Alvelais Iv, Paul Obrecht, Naguib Abdulla, Preston Mavady, Collin Fan
Archimedean Spiral Antenna Array With Klopfenstein And Exponential Tapered Balun Feeds, Leo Joseph Alvelais Iv, Paul Obrecht, Naguib Abdulla, Preston Mavady, Collin Fan
Electrical Engineering
This project presents the design, fabrication, and experimental evaluation of a broadband 3x3 Archimedean spiral antenna array tile for 2.8-3.8 GHz. Each element combines a two-arm spiral on Rogers RO4350B, a printed 50 to 150 Ω tapered balun, and a conductive backplane. Klopfenstein and Exponential feed implementations were modeled in Ansys HFSS, generated and tuned with automated scripting, fabricated, and evaluated with calibrated network and anechoic-chamber measurements. The Klopfenstein-fed hardware met the -10 dB input-reflection criterion across the project band. The exponential array provided a broad matched response but reached approximately -8 dB near 2.95 GHz. Measured center-element patterns retained …
Design And Verification Of A Labview Automated Antenna Radiation Pattern Measurement System, Dylan C. Bloom
Design And Verification Of A Labview Automated Antenna Radiation Pattern Measurement System, Dylan C. Bloom
Master's Theses
In 2014, Toyon Research Corporation donated a 6’x6’x8’ anechoic chamber to the Cal Poly EE department to advance student education in the areas of antennas and wireless communications. An anechoic chamber is a room designed to suppress electromagnetic radiation reflections so that accurate measurement of radio frequency (RF) systems such as wireless radios and antennas can take place. Despite the fact that Cal Poly already has a larger anechoic chamber, primarily used for antenna characterization, it is the purpose of this project to design, code, and equip the new chamber so that it performs at least as good, or better …
The Silver Lining: A Novel, Inkjet-Printed Mesh Coplanar-Slot Antenna For The Uhf Band, Anastasios C. Karles
The Silver Lining: A Novel, Inkjet-Printed Mesh Coplanar-Slot Antenna For The Uhf Band, Anastasios C. Karles
UROP Posters
The Federal Communications Commission (FCC) is opening up frequencies within the television range (400MHz to 700MHz) of the Ultra High Frequency (UHF) band for use in emerging technologies, such as cognitive radio networks and machine-to-machine communication. In order for manufacturers to produce affordable antennas that can be used in these emerging technologies, inexpensive antennas are required that meet these new spectrum needs. This paper presents a mesh coplanar-slot bowtie patch antenna fabricated using commercially available inkjet-printing technology. Two antennas were fabricated: a 27x21cm copper FR4 antenna with .25mm lines and a 27x21cm silver antenna with 2mm lines fabricated using inkjet-printing. …
Investigation Of Mimo Communications, Rodrigo Mendez Olea, William C. Tran, Patrick C. Kezer, Jean M. Whitmore
Investigation Of Mimo Communications, Rodrigo Mendez Olea, William C. Tran, Patrick C. Kezer, Jean M. Whitmore
Electrical Engineering
This project focuses on the background of multiple input multiple output (MIMO) communication and its advantages over the other possible implementations. A background of wireless communication in regards to modulation types, information theory, antenna background and a hardware implementation using a VSA and VSG is provided. The theory is compared and verified with the hardware implementation with regards to the effect of the increase in the number of antennas and the parameter vector error magnitude.
Multi-Band Antenna Array Based On Double Negative Metamaterial For Multi Automotive Applications, Mohd Jamlos, Abdulrahman Alqadami,, Imtiaz Islam, Ping Soh, Rizalman Mamat, Khairil Khairi, Adam Narbudowicz
Multi-Band Antenna Array Based On Double Negative Metamaterial For Multi Automotive Applications, Mohd Jamlos, Abdulrahman Alqadami,, Imtiaz Islam, Ping Soh, Rizalman Mamat, Khairil Khairi, Adam Narbudowicz
Articles
Nowadays, the demand for antennas in wireless communication system for automotive applications is rising at a rapid rate [1, 2]. Their usage includes collision avoidance system (CAS), Vehicle-to-vehicle communications, pre-crash safety systems, Global Positioning Systems (GPS), tyre pressure monitoring system (TPMS), Wireless Local Area Network (WLAN), etc. To enhance its effectiveness in these new applications, a small, multi-band, multi-functional antenna is required instead of conventional single band antennas [2, 3]. Such multifunctional antennas with favourable radiation characteristics are more practical in addressing modern antenna design requirements. However, the achievement of the above mentioned antenna’s features using conventional materials and structures …
Path Loss Modeling For V2v Communication On A Slope, Pengyu Liu, David W. Matolak, Bo Ai, Ruoyu Sun
Path Loss Modeling For V2v Communication On A Slope, Pengyu Liu, David W. Matolak, Bo Ai, Ruoyu Sun
Faculty Publications
Path loss modeling for both regular and irregular terrains is still gaining significant attention from researchers. A sloped terrain is one specific kind of an irregular terrain that-as far as we are aware-has not been completely studied. Although some results have been published for slope path loss modeling in cellular communication, an adequate model for the case when the transmitter (Tx) and the receiver (Rx) both have low-height antennas and are located on or near a slope does not exist. In this paper, for complete analysis of such conditions, we consider four scenarios: 1) two vehicles are located at opposite …
Scalable System Design For Covert Mimo Communications, Jason R. Pennington
Scalable System Design For Covert Mimo Communications, Jason R. Pennington
Theses and Dissertations
In modern communication systems, bandwidth is a limited commodity. Bandwidth efficient systems are needed to meet the demands of the ever-increasing amount of data that users share. Of particular interest is the U.S. Military, where high-resolution pictures and video are used and shared. In these environments, covert communications are necessary while still providing high data rates. The promise of multi-antenna systems providing higher data rates has been shown on a small scale, but limitations in hardware prevent large systems from being implemented.
Optimized Monopole And Dipole Antennas For Uwb Asset Tag Location Systems, Antoine Dumoulin, Matthias John, Max Ammann, Patrick Mcevoy
Optimized Monopole And Dipole Antennas For Uwb Asset Tag Location Systems, Antoine Dumoulin, Matthias John, Max Ammann, Patrick Mcevoy
Articles
Miniaturized monopole and dipole antenna designs are reported with performances optimized for ultrawideband pulsed radio applications. The geometries are created using Bézier spline shapes, which have been refined with a genetic algorithm to simultaneously take account of both frequency- and time-domain criteria. Time-domain measurements of ultra wideband antennas with uniformly distributed energy across the full 3.1-10.6 GHz mask are reported for the first time and validate a new approach to minimization of pulse dispersion effects in the antenna designs.
Wireless Passive Power Transfer Using Wire Antennas, Sheng Da Zhang
Wireless Passive Power Transfer Using Wire Antennas, Sheng Da Zhang
Electrical Engineering
This project tests and analyzes the efficiency of directional and omnidirectional antennas in wireless power transfer for charging. The project demonstrates the steps of construction and properties of dipole, monopole, and Yagi Uda antennas. A low power high frequency DC rectifier circuit converts the received RF power from the antenna and stored it as DC voltage on a capacitor. The receiver circuit also estimates the power received by the antenna. Wireless RF power transmission proves to be inefficient for short distances. The best efficiencies of the antennas were under 50% even at 0.1meter. The near field attenuation starts at around …
Integration Of Antennas And Solar Cells For Autonomous Communication Systems, Maria Jose Roo Ons
Integration Of Antennas And Solar Cells For Autonomous Communication Systems, Maria Jose Roo Ons
Doctoral
Solar energy is becoming an attractive alternative for powering autonomous communication systems. These devices often involve the use of separate photovoltaics and antennas, which demand a compromise in the utilization of the limited space available. This thesis deals with the design, analysis, fabrication and validation of different techniques for the integration of antennas and solar cells in a single multifunctional device. Four different photovoltaic technologies are considered within this work, namely, polycrystalline silicon (poly-Si), monocrystalline (mono-Si) emitter-wrap-through (EWT) rear contact solar cells, amorphous silicon (a-Si) thin film on glass substrate, and bifacial solar cells. The use of a poly-Si solar …