Open Access. Powered by Scholars. Published by Universities.®
- Discipline
-
- Physical Sciences and Mathematics (6)
- Power and Energy (5)
- Computer Sciences (4)
- Signal Processing (4)
- Computer Engineering (3)
-
- Electrical and Electronics (3)
- Electromagnetics and Photonics (3)
- Artificial Intelligence and Robotics (2)
- Digital Communications and Networking (2)
- Optics (2)
- Physics (2)
- Applied Mathematics (1)
- Civil and Environmental Engineering (1)
- Computational Engineering (1)
- Controls and Control Theory (1)
- Databases and Information Systems (1)
- Electronic Devices and Semiconductor Manufacturing (1)
- Graphics and Human Computer Interfaces (1)
- OS and Networks (1)
- Other Computer Engineering (1)
- Structural Engineering (1)
- Keyword
-
- 5G mobile communication system; Base station; Butler matrix; Multibeam array antenna; Single-layer (1)
- 5G network (1)
- Adaptive neuro-fuzzy inference system (1)
- Backtracking search algorithm (1)
- Broadband communication (1)
-
- CTI (1)
- Civil structural monitoring (1)
- Clustering (1)
- Compressive sensing (1)
- Data forwarding (1)
- Device communication (1)
- Distributed Power Amplifier (DPA) (1)
- Distributed generation (1)
- Distribution system (1)
- Dual sink (1)
- Electrical network power system (1)
- Electricity price forecasting (1)
- Energy consumption (1)
- Erbium doped fiber amplifier (1)
- Fault current (1)
- Fault location (1)
- Feature selection (1)
- Ferranti Effect (1)
- Flat-gain (1)
- Hafnia bismuth-erbium co-doped fiber (1)
- Hybrid active fibers (1)
- Load Flow Study (1)
- Loss of power (1)
- MMIC technology (1)
- Mode-locked fiber laser (1)
Articles 1 - 14 of 14
Full-Text Articles in Systems and Communications
Multibeam Array Antenna For Base Station In The Fifth-Generation Mobile Communication System, Intan Izafina Idrus
Multibeam Array Antenna For Base Station In The Fifth-Generation Mobile Communication System, Intan Izafina Idrus
Student Works (2020-2029)
Research on the fifth-generation (5G) mobile communication system has been accelerated to meet the standardization of the International Telecommunications Union for higher data traffic and higher data rates. The main requirements of the 5G mobile communication systems are the utilization of millimeter waves, the deployment of small cells, and the use of multibeam array antennas for multiple-input multiple-output schemes. Multibeam array antennas play an important role in developing a new base station to enhance system capacity, improve network coverage, and reduce co-channel interference. The main objective of this thesis is to design a single-layer multibeam array antenna at 28 GHz …
Energy-Efficient Communications In Wireless Powered Cognitive Radio Networks Based On Game Theory, Fadhil Mukhlif Aswad Al-Obaidy
Energy-Efficient Communications In Wireless Powered Cognitive Radio Networks Based On Game Theory, Fadhil Mukhlif Aswad Al-Obaidy
Student Works (2020-2029)
There are challenging and prevalent problems related to spectrum resources with the interference of battery-based devices in future wireless networks. To address such challenges, this thesis proposes a theoretical framework for designing and analyzing the distributed power control algorithms in modern 5G cognitive networks. Previous experiments have shown that game theory tools can be used as a suitable and efficient technique to build scalable, balanced, and energy efficient for the distributed power control schemes in order to use it practically in battery-based devices in wireless networks. In reality, the power control issue is constructed as a non-cooperative game for which …
Analysis Of Protection System Setting In 11kv Distribution System, Alamshah Ammar
Analysis Of Protection System Setting In 11kv Distribution System, Alamshah Ammar
Student Works (2020-2029)
One of the fundamental protections used in electrical network power system is Overcurrent and Earth Fault (OCEF) protection. They have to be both sensitive and quick in minimizing the electrodynamic and thermal stress imposed on the equipment during the fault time interval. It is utmost important for the relays to be capable of removing only the faulty section while keep up the flexibly to solid areas in the system. In order to achieve this objective, correct relay coordination setting is important to prevent the system from suffering catastrophic effects. These days, the consumer is enforcing raising performance demands by reducing …
Hybrid Microwave Power Amplifiers For Broadband Communication, Sangaran Pragash
Hybrid Microwave Power Amplifiers For Broadband Communication, Sangaran Pragash
Student Works (2020-2029)
The software-defined radio is the future of radio technology. The development of a broadband power amplifier is the most challenging radio component to design in achieving software-defined radio goals due to the PA gain-bandwidth limitation. The distributed power amplifier (DPA) overcomes the limitation by combining output power from several transistors in an additive fashion. Matrix Amplifier (MA) consists of two or more DPA stacked together in a multiplicative manner. In this project, a high power and high gain DPA for a two-way radio system is demonstrated. The DPA exhibits 10W output power and 32dB gain across the frequency range of …
Fault Location In Distribution System Based On Voltage Sag Analysis, Ahmad Muhamad Firdaus
Fault Location In Distribution System Based On Voltage Sag Analysis, Ahmad Muhamad Firdaus
Student Works (2020-2029)
Fault in the distribution system is something that cannot be avoided. It is a recurring event that occurs due to various factors such as natural occurrence, mechanism failure, or human error. All this contributes to the phenomenon that will affect the stability of the system and result in the loss of power to the consumers. However, such a fault is something that happens unexpectedly, and it is difficult to be eliminated. Therefore, various research work has been done over the years to overcome the problem. All research is done to find the most effective method of finding the fault location …
Organic Materials As Saturable Absorber For Pulse Generation At Telecommunication Window, Mohammed Hussein Sameer Salam M.H.
Organic Materials As Saturable Absorber For Pulse Generation At Telecommunication Window, Mohammed Hussein Sameer Salam M.H.
Student Works (2020-2029)
This thesis demonstrates several types of fiber lasers based on newly developed organic materials as saturable absorbers (SAs). We used these SAs in all-fiber based erbium-doped fiber laser (EDFL) ring cavity to produce Q-switched and mode-locked pulses at telecommunication window, at ~ 1560 nm. Three different organic materials were used in this thesis: Bis[2-(4,6-difluorophenyl)pyridinato-C2 ,N](picolinato)iridium(III) (FIrpic), bis(8-hydroxyquinoline)zinc (Znq2) and Tris(8-hydroxyquinoline)aluminum (Alq3). Finding new materials is still one of the defining characteristics of nonlinear optics field, as the rapid development of SAs has provided several new opportunities for nonlinear optics. Throughout this work, organic material showed a very interesting performance in …
A Multicriteria Aware Optimal Routing Approach For Enhancing Quality Of Service In Device To Device Communication, Tilwari Valmik
A Multicriteria Aware Optimal Routing Approach For Enhancing Quality Of Service In Device To Device Communication, Tilwari Valmik
Student Works (2020-2029)
As the world is moving towards the digitalization era, increasing demands of higher data rates, energy effiffifficiency, and seamless connectivity are skyrocketing. Device-to-Device (D2D) communication is one of the key technologies for future Fifth Generation (5G) network. D2D communication technology enhances network coverage, boosts spectral efficiency, has low latency, and enables the devices to communicate with each other, with partial or none involvement of network infrastructure. Therefore, factors of such nature make D2D communication a promising medium guarantying reliability to several telecommunications scenarios. D2D caters to all the needs of it’s users, from the high demand of peer-to-peer users for …
Multimode-Interference Based Optical Fiber Sensor For Civil Structures Monitoring, Sue Ping Chew
Multimode-Interference Based Optical Fiber Sensor For Civil Structures Monitoring, Sue Ping Chew
Student Works (2020-2029)
The thesis describes the experimental investigations on the multimode interferencebased fiber sensors using single mode multimode single mode (SMS) and multimode single mode multimode (MSM) structures as a sensing device for structural health monitoring (SHM) applications. Both sensor structures were fabricated, characterized and tested for detecting strain and vibration in civil infrastructures. The proposed SMS structure comprises of a short segment of multimode fiber (MMF), which were fusionspliced by two single mode fibers (SMFs) at both terminals. On the other hand, MSM was fabricated by splicing SMF with MMF at both ends. A new packaging technique for the SMS structure …
Optimal Network Reconfiguration And Distributed Generation Sizing With Consideration Of Protection System, Abdul Rahim Mohamad Norshahrani
Optimal Network Reconfiguration And Distributed Generation Sizing With Consideration Of Protection System, Abdul Rahim Mohamad Norshahrani
Student Works (2020-2029)
Research on network reconfiguration (NR) considering distributed generation (DG) commonly focus on the issues of power loss, voltage deviation, DG sizing and its placement. These works are important and required in the planning stage of the distribution networks. In most of the past works, the protection system is neglected in this stage although it is essential to prevent the network from damages during operation. Without proper consideration of protection system settings and coordination during NR, the protection system may operate inaccurately. This happens due to changes in current flow and fault level when the network changes its configuration. As a …
Power System Study For Oil And Gas Platform Connected To Onshore Grid, Taharim Rosshidi Hezrimi
Power System Study For Oil And Gas Platform Connected To Onshore Grid, Taharim Rosshidi Hezrimi
Student Works (2020-2029)
Normally for oil and gas offshore platform, the electrical power supply is generated from the generator either using gas turbine generator, gas engine generator and diesel engine generator. The main power supply is backup by diesel engine generator in case emergency or during black start of the platform. As the design of oil and gas platform become complex, the size of generator keeps increasing. A new concept is being explored to mitigate this problem. Oil and gas company is looking to provide power generation from onshore and supplying the electrical power to a substation platform offshore and then distributed it …
Energy-Efficient Data Transmission With Clustering And Compressive Sensing In Wireless Sensor Networks, Alagirisamy Mukil
Energy-Efficient Data Transmission With Clustering And Compressive Sensing In Wireless Sensor Networks, Alagirisamy Mukil
Student Works (2020-2029)
One of the most important application of wireless sensor network is environmental monitoring. The application involves lifetime of sensor nodes for longer duration associating its energy module. Wireless sensor nodes deployed in sensing field aggregate enormous amount of sensed data and transfer them to the sink. The inherent limitation of energy carried within the battery of sensor nodes fetches extreme difficulty to acquire adequate network lifetime, becoming a bottleneck in forwarding data to sink. Hence the motivation is to reduce the amount of data transfer and attain energy efficiency. This is achieved by clustering and compressive sensing techniques. First objective …
Wideband And Flat-Gain Optical Amplifier With Hafnia-Bismuth Erbium Co-Doped Fiber, Abduljabbar Al-Azzawi Alabbas Ahmed
Wideband And Flat-Gain Optical Amplifier With Hafnia-Bismuth Erbium Co-Doped Fiber, Abduljabbar Al-Azzawi Alabbas Ahmed
Student Works (2020-2029)
A compact optical amplifier with a flat-gain characteristic is demonstrated using hafnia bismuth-erbium co-doped fiber (HB-EDF) as the gain medium. The HB-EDF was recently fabricated using a modified chemical vapor deposition (MCVD) process in conjunction with solution doping (SD) technique. The fiber has an Erbium ions concentration of 12500 wt. ppm, which was realized due to the co-doping with Hafnium and Aluminum ions. Firstly, the proposed amplifier was investigated for both single and double-pass configurations. It is found that the 0.5m long HB-EDF is the optimum length for the C-band region. For double-pass HB-EDFA, at input signal power of -10 …
Short-Term Electricity Price Forecasting In Deregulated Electricity Market Based On Enhanced Artificial Intelligence Techniques, Pourdaryaei Alireza
Short-Term Electricity Price Forecasting In Deregulated Electricity Market Based On Enhanced Artificial Intelligence Techniques, Pourdaryaei Alireza
Student Works (2020-2029)
Electricity price forecasting is considered as one of prime factors for operation, planning and scheduling of price-setter market participants. However, possessing time variant, non-linear and non-stationary behaviors make the electricity price a complex signal. The main challenge in this area is providing highly accurate and efficient day-ahead price forecasting. A suitable feature selection technique, which is able to model the interacting features and nonlinearities of the forecast processes, is still required although researches have been performed for day-ahead forecasting. In this research, a hybrid electricity price forecasting methodology is proposed using two-stage feature selection method and optimization using adaptive neuro-fuzzy …
Ultra-Wideband Power Amplifier Design For Large Signal Application, Ragavan Krishnamoorthy
Ultra-Wideband Power Amplifier Design For Large Signal Application, Ragavan Krishnamoorthy
Student Works (2020-2029)
Broadband power amplifier design has become one of the most critical enabling block in today’s wireless communication technology. Numerous research efforts have been carried out throughout the years to establish high efficiency over wideband RF transmitter. This research work presents two approaches in achieving ultra-broadband power amplifier for RF transmitter. Firstly, a new technique for the design of ultra-broadband RF power amplifier is introduced, in which a combination of the reactance compensation and third-harmonic tuning are adopted. The design goal is to achieve 40 dBm (10W) output power across a wide frequency bandwidth operation. Theoretical design equations were developed to …