Open Access. Powered by Scholars. Published by Universities.®
- Discipline
-
- Electrical and Electronics (11)
- Electromagnetics and Photonics (10)
- Computer Engineering (9)
- Digital Communications and Networking (8)
- Signal Processing (7)
-
- Physical Sciences and Mathematics (5)
- Power and Energy (4)
- Biomedical Engineering and Bioengineering (3)
- Applied Mathematics (2)
- Computer Sciences (2)
- Mathematics (2)
- Non-linear Dynamics (2)
- Analytical, Diagnostic and Therapeutic Techniques and Equipment (1)
- Biomedical Devices and Instrumentation (1)
- Chemical Engineering (1)
- Computational Engineering (1)
- Data Science (1)
- Diagnosis (1)
- Dynamic Systems (1)
- Materials Science and Engineering (1)
- Medicine and Health Sciences (1)
- Other Computer Engineering (1)
- Other Electrical and Computer Engineering (1)
- Software Engineering (1)
- Keyword
-
- Circular polarization (6)
- Machine learning (4)
- Antenna (3)
- Microstrip antennas (3)
- Antennas (2)
-
- Bandwidth (2)
- Dual-frequency (2)
- Energy (2)
- Internet of Things (IoT) (2)
- Localization (2)
- Measurement (2)
- Microstrip patch antenna (2)
- Microwave imaging (2)
- Servers (2)
- Signal Processing (2)
- Source Separation (2)
- UWB (2)
- Vivaldi antennas (2)
- (GPS) (1)
- 5G mobile communication (1)
- Adaptive OFDM (1)
- Air (1)
- Algorithm . (1)
- Algorithms. (1)
- Anechoic (1)
- Angle of Arrival (AoA) estimation (1)
- Anharmonic oscillator (1)
- Antenna arrays (1)
- Antenna diversity (1)
- Antenna feeds (1)
Articles 61 - 74 of 74
Full-Text Articles in Systems and Communications
In-Silico Hyperthermia Performance Of A Near-Field Patch Antenna At Various Positions On A Human Body Model, Sergio Curto, Terrence See, Patrick Mcevoy, Max Ammann, Zhi Ning Chen
In-Silico Hyperthermia Performance Of A Near-Field Patch Antenna At Various Positions On A Human Body Model, Sergio Curto, Terrence See, Patrick Mcevoy, Max Ammann, Zhi Ning Chen
Articles
A compact patch applicator designed to enhance targeted energy coupling at 434 MHz is a key enabler for sensitizing temperature increments in body regions containing superficial tumours. A detailed FDTD body model is used to explore simulated RF coupling and temperature increments for typical clinical conditions. The antenna impedance matching, specific absorption rate and thermal distribution parameters are evaluated to identify applied performance outcomes. The analysis reveals physiological-RF coupling patterns for an optimised closely-coupled single element applicator.
Microstrip-Fed Wideband Circularly Polarized Printed Antenna, Xiulong Bao, Max Ammann, Patrick Mcevoy
Microstrip-Fed Wideband Circularly Polarized Printed Antenna, Xiulong Bao, Max Ammann, Patrick Mcevoy
Articles
A wideband circularly-polarized printed antenna is proposed, which employs an asymmetrical dipole and a slit in the ground plane which are fed by an L-shaped microstrip feedline using a via. The proposed antenna geometry is arranged so that the orthogonal surface currents, which are generated in the dipole, feedline and ground plane, have the appropriate phase to provide circular polarization. A parametric study of the key parameters is made and the mechanism for circular polarization is described. The measured results show that the impedance bandwidth is approximately 1.34 GHz (2.45 GHz to 3.79 GHz) and the 3 dB axial ratio …
Reconfigurable Antenna With Elevation And Azimuth Beam Switching, S. Shynu, Max Ammann
Reconfigurable Antenna With Elevation And Azimuth Beam Switching, S. Shynu, Max Ammann
Articles
A reconfigurable microstrip antenna is proposed for low-cost adaptive beam-switching applications. A small patch-slot-ring structure is used as the radiating element where an asymmetrical arrangement of p-i-n diodes is employed to switch the pattern in four directions. The antenna provides pattern switching of 65° and 45° in its fundamental mode for the elevation and azimuth planes, respectively. By maintaining the resonant frequency and beamwidth as relatively constant, beam switching is realized using a single feed point.
Miniature Ceramic Pifa For Uwb Band Group 3 And 6, David Kearney, Matthias John, Max Ammann
Miniature Ceramic Pifa For Uwb Band Group 3 And 6, David Kearney, Matthias John, Max Ammann
Articles
A ceramic chip planar inverted-F antenna (PIFA) is proposed for integration into a mobile handset providing UWB functionality across band groups 3 and 6. The antenna design exhibits a total efficiency of greater than 50% across the entire 6.39 GHz bandwidth while maintaining a very small volume of 57.6 mm^3 . The antenna uses a combination of the normal PIFA resonance and a second resonance due to the ceramic block to achieve a broad ultrawideband (UWB) bandwidth.
Influence Of Solar Heating On The Performance Of Integrated Solar Cell Microstrip Patch Antennas, Maria Roo Ons, S. Shynu, M Seredynski, Max Ammann, Sarah Mccormack, Brian Norton
Influence Of Solar Heating On The Performance Of Integrated Solar Cell Microstrip Patch Antennas, Maria Roo Ons, S. Shynu, M Seredynski, Max Ammann, Sarah Mccormack, Brian Norton
Articles
The integration of microstrip patch antennas with photovoltaics has been proposed for applications in autonomous wireless communication systems located on building façades. Full integration was achieved using polycrystalline silicon solar cells as both antenna ground plane and direct current power generation in the same device. An overview of the proposed photovoltaic antenna designs is provided and the variation characterised of the electromagnetic properties of the device with temperature and solar radiation. Measurements for both copper and solar antennas are reported on three different commercial laminates with contrasting values for thermal coefficient of the dielectric constant.
Directional Dual-Band Slot Antenna With Dual-Bandgap High-Impedance-Surface Reflector, Xiulong Bao, Giuseppe Ruvio, Max Ammann
Directional Dual-Band Slot Antenna With Dual-Bandgap High-Impedance-Surface Reflector, Xiulong Bao, Giuseppe Ruvio, Max Ammann
Articles
A compact dual-band high-impedance-surface EBG structure is employed as a reflector for a dual-band annular-slot antenna. The reflector comprises an array of miniaturized EBG cells which utilizes square patches augmented by four S-shaped corrugated arms to reduce the resonant frequency of the proposed EBG structure. In order to broaden the bandwidth and adjust the frequency ratio for the dual-band EBG structure, a log-periodic spacing between the S-shaped strips is introduced. The combination of microstrip-fed annular slot and EBG reflector provides directional properties for both frequency bands with reduced size and low-profile.
Zero-Broadening Measurement In Brillouin Based Slow-Light Delays, Andrzej Wiatrek, Ronny Henker, Stefan Preußler, Max Ammann, Andreas Schwarzbacher, Thomas Schneider
Zero-Broadening Measurement In Brillouin Based Slow-Light Delays, Andrzej Wiatrek, Ronny Henker, Stefan Preußler, Max Ammann, Andreas Schwarzbacher, Thomas Schneider
Articles
A novel method for the achievement of zero-broadening in a SBS based slow-light system is discussed in theory and demonstrated experimentally. The system is realized just with a single broadened Brillouin gain. It is shown, that if the gain bandwidth is much broader than the initial pulse width, the output pulse width decreases with increasing pump power. A compression of approximately 90 % of the initial pulse width was achieved in simulation and experiment.
High Performance Zno Varistors Prepared From Nanocrystalline Precursors For Miniaturised Electronic Devices, Suresh Pillai, Declan Mccormack, John Kelly, Raghavendra Ramesh
High Performance Zno Varistors Prepared From Nanocrystalline Precursors For Miniaturised Electronic Devices, Suresh Pillai, Declan Mccormack, John Kelly, Raghavendra Ramesh
Articles
An industrially viable solution-based processing route using minimal amounts of solvent has been used to prepare bulk quantity nanopowders (average particle size 15.3 nm) for the fabrication of ZnO varistors. The xerogels, calcined powders and sintered materials were fully characterised. The preparation of varistors from nanopowders has been optimised by studying the effect of temperature on grain growth, densification and breakdown voltage. The varistors are prepared by sintering at 1050 C for 2 hours, a temperature that is significantly lower than that used in the current industrial process. Highly dense varistor discs prepared from the sintered material produce devices, with …
Covert Encryption And Document Authentication Using Texture Coding, Jonathan Blackledge, Mary Hallot
Covert Encryption And Document Authentication Using Texture Coding, Jonathan Blackledge, Mary Hallot
Articles
With the improvements in the quality of Commercial-Off-The-Shelf (COTS) printing and scanning devices, the ability to counterfeit documents has become a widespread problem. Consequently, there has been an increasing demand to develop digital watermarking techniques which can be applied to both electronic and printed images (and documents) that can be authenticated, prevent unauthorized copying and withstand abuse and degradation. In this paper , a new approach to digital watermarking is presented and a range of possible applications are considered. The process is defined by using concepts and techniques borrowed from Cryptography. It is based on computing a 'scramble image' by …
Krylov Subspaces From Bilinear Representations Of Nonlinear Systems, Marissa Condon, Rossen Ivanov
Krylov Subspaces From Bilinear Representations Of Nonlinear Systems, Marissa Condon, Rossen Ivanov
Articles
For efficient simulation of state-of-the-art dynamical systems as arise in all aspects of engineering, the development of reduced-order models is of paramount importance. While linear reduction techniques have received considerable study, increasingly nonlinear model reduction is becoming a significant field of interest. From a circuits and systems viewpoint, systems involving micromachined devices or systems involving mixed technologies necessitate the development of reduced-order nonlinear models. From a control systems viewpoint, the design of controllers for nonlinear systems is greatly facilitated by nonlinear model reduction strategies. To this end, the paper proposes two novel model-reduction strategies for nonlinear systems. The first involves …
Integrated Antenna For Multiband Multi-National Wireless Combined With Gsm1800/Pcs1900/Imt2000 + Extension, Matthias John, Max Ammann
Integrated Antenna For Multiband Multi-National Wireless Combined With Gsm1800/Pcs1900/Imt2000 + Extension, Matthias John, Max Ammann
Articles
A printed triple-band monopole antenna appropriate for use as a terminal antenna in modern wireless multiband systems is proposed. The impedance bandwidth of each band has been optimised using a quasi-Newton technique and the bandwidth includes virtually all wireless bands. Various parameter sweeps are presented which improve our understanding of the antenna, in particular, the effect of groundplane-size and branch-off point on impedance bandwidth and radiation pattern.
Synthesis Of High-Temperature Stable Anatase Tio2 Photocatalyst, Suresh Pillai, Declan Mccormack, Michael Seery, Pradeepan Periyat, Steven Hinder, John Colreavy, Reenamol George, Hugh Hayden
Synthesis Of High-Temperature Stable Anatase Tio2 Photocatalyst, Suresh Pillai, Declan Mccormack, Michael Seery, Pradeepan Periyat, Steven Hinder, John Colreavy, Reenamol George, Hugh Hayden
Articles
In the absence of a dopant or precursor odification, anatase to rutile transformation in synthetic TiO2 sually ccurs at a temperature of 600 700 °C. Conventionally, metal oxide dopants (e.g., Al2O3 nd SiO2 are used o tune the anatase to rutile transformation. A simple methodology is reported here to extend the anatase utile transformation by employing various concentrations of urea. XRD and Raman spectroscopy were used uring thermal treatment. A significantly higher anatase phase (97%) as been obtained at 800 C with use of a 1:1 Ti(OPr)4 urea composition and 11% anatase composition is etained even after calcining …
Optimization Of Impedance Bandwidth For The Printed Rectangular Monopole Antenna, Matthias John, Max Ammann
Optimization Of Impedance Bandwidth For The Printed Rectangular Monopole Antenna, Matthias John, Max Ammann
Articles
This paper describes a printed rectangular-plate monopole fed by microstrip line. The effect of varying the plate width, feed-gap height, and feedline width on the impedance bandwidth is examined. It is shown that for a fixed ground-plane size, that optimization of these parameters can yield an impedance bandwidth ratio of 4.3:1, without using any broadbanding techniques.
An Explicit Mapping Between The Frequency Domain And The Time Domain Representations Of Nonlinear Systems, Marissa Condon, Rossen Ivanov
An Explicit Mapping Between The Frequency Domain And The Time Domain Representations Of Nonlinear Systems, Marissa Condon, Rossen Ivanov
Articles
Explicit expressions are presented that describe the input-output behaviour of a nonlinear system in both the frequency and the time domain. The expressions are based on a set of coefficients that do not depend on the input to the system and are universal for a given system. The anharmonic oscillator is chosen as an example and is discussed for different choices of its physical parameters. It is shown that the typical approach for the determination of the Volterra Series representation is not valid for the important case when the nonlinear system exhibits oscillatory behaviour and the input has a pole …