Open Access. Powered by Scholars. Published by Universities.®

Signal Processing Commons™

Open Access. Powered by Scholars. Published by Universities.®

OFDM

Electrical and Electronics

Articles 1 - 3 of 3

Full-Text Articles in Signal Processing

Distance Estimation Using Ofdm Signals For Ultrasonic Positioning, Kyman Huang Jun 2020

Distance Estimation Using Ofdm Signals For Ultrasonic Positioning, Kyman Huang

Master's Theses

This paper describes a method of estimating distance via Time-of-Flight (TOF) measurement using ultrasonic Orthogonal Frequency Division Multiplexing (OFDM) signals. Using OFDM signals allows the signals and their sub-carriers to remain orthogonal to each other while continuously transmitting. This estimation method is based on the change of phase of a traveling wave as it propagates through a medium (air for ultrasonic signals). By using signals containing multiple tones, the phase change between each frequency component is slightly different. This phase difference is dependent on the distance traveled and can thus be used to estimate distance. This paper studies the impact …

Go to article

An Optical Design Configuration For Wireless Data Transmission, Seyed Mohammad Amin Motahari Bidgoli Mar 2016

An Optical Design Configuration For Wireless Data Transmission, Seyed Mohammad Amin Motahari Bidgoli

FIU Electronic Theses and Dissertations

The concept of 2D barcodes is of great relevance for use in wireless data transmission between handheld electronic devices. In a typical setup, any file on a cell phone for example can be transferred to a second cell phone through a series of images on the LCD which are then captured and decoded through the camera of the second cell phone. In this research, a new approach for data modulation in 2D barcodes is introduced, and its performance is evaluated in comparison to other standard methods of barcode modulation. In the proposed method, Orthogonal Frequency Division Multiplexing (OFDM) modulation is …

Go to article

On-Chip Implementation Of High Resolution High Speed Floating Point Adder/Subtractor With Reducing Mean Latency For Ofdm, Rozita Teymourzadeh, Yazan Samir, Nooshin Mahdavi, Masuri Othman Dec 2009

On-Chip Implementation Of High Resolution High Speed Floating Point Adder/Subtractor With Reducing Mean Latency For Ofdm, Rozita Teymourzadeh, Yazan Samir, Nooshin Mahdavi, Masuri Othman

Dr. Rozita Teymourzadeh, CEng.

Fast Fourier transform (FFT) is widely applied in OFDM trance-receiver communications system. Hence Efficient FFT algorithm is always considered. This paper proposed FPGA realization of high resolution high speed low latency floating point adder/subtractor for FFT in OFDM trance-receiver. The design was implemented for 32 bit pipelined adder/subtractor which satisfied IEEE-754 Standard for floating-point Arithmetic. The design was focused on the trade-off between the latency and speed improvement as well as resolution and silicon area for the chip implementation. In order to reduce the critical path and decrease the latency, the novel structure was designed and investigated. Consequently, synthesis report …

Go to article