Open Access. Powered by Scholars. Published by Universities.®

Power and Energy Commons™

Open Access. Powered by Scholars. Published by Universities.®

2000

Discipline
Institution
Keyword
Publication
Publication Type

Articles 31 - 38 of 38

Full-Text Articles in Power and Energy

Studies Of The Preparation Of Electrodes From Lead Carbonate For Lead-Acid Battery Ⅱ. The Preparation Of Paste Electrodes, Zhong-Xu Dai, Di-Hua Wang, Hao-Hao Ke, Jin-Yun Zou, Yun-Hong Zhou Feb 2000

Studies Of The Preparation Of Electrodes From Lead Carbonate For Lead-Acid Battery Ⅱ. The Preparation Of Paste Electrodes, Zhong-Xu Dai, Di-Hua Wang, Hao-Hao Ke, Jin-Yun Zou, Yun-Hong Zhou

Journal of Electrochemistry

The positive and negative pastes were prepared by mixing PbCO3 and H2SO4 solution as well as relative additives, respectively. The effects of the various formation methods and the charge/discharge conditions on discharge capacity and active material utilization of both electrodes were examined. The results indicate that the performance of the positive electrode formed at 2.0 mA/cm2 is better than that formed at higher current density under the same charge/discharge condition, the PAM utilization reaches 74.4 % under discharging at 2.0 mA/cm2; and the property of the negative electrode formed by unsymmetrical square wave …

Go to article

Sprayed And Thermally Evaporated Carbon Films As Anodes For Lithium Ion Batteries, Shu-Gao Zhang, M.Schleich Donald Feb 2000

Sprayed And Thermally Evaporated Carbon Films As Anodes For Lithium Ion Batteries, Shu-Gao Zhang, M.Schleich Donald

Journal of Electrochemistry

Carbon films were made using spray-thermal evaporation from a kind of pyrolytic carbon powder. The films obtained with graphite structure were both potentio-statically and galvanostaically tested. Cycling patterns indicated a reduction peak on the first cycle corresponding to the formation of solid electrolyte interface, and the capacity values and x values were quite acceptable compared to theoretical ones when charging-discharging current density was suitable. Based on the experimental results, the obtained carbon films could be used as anode materials for relatively determining the electrochemical performances of cathode materials.

Go to article

Studies On Electrochemical Synthesis Of 4,5-Disubstituted-1,2- Benzoquinones And The Reaction Mechanism, Xian-Zhang Bu, Gui-Wu Xiao, Lin Ma, Xing-Chum He, Ling-Quan Gu Feb 2000

Studies On Electrochemical Synthesis Of 4,5-Disubstituted-1,2- Benzoquinones And The Reaction Mechanism, Xian-Zhang Bu, Gui-Wu Xiao, Lin Ma, Xing-Chum He, Ling-Quan Gu

Journal of Electrochemistry

The oxidation peak potentials (Ep) of alinine derivates and catechol in 0.1 mol/L KCl+15% alcohol solution were measured by cyclic voltammograms technique. The electrochemical oxidation condition was set according to the Ep. Three derivates of 4,5-disubstituted -1,2-benzoquinones were prepared via electrochemical oxidation-Michael addition reaction. The possible mechanism of electrochemical oxidation-Michael addition reaction is presented.

Go to article

The Study On Fabricating Thin Electrodes For Polymer Electrolyte Membrane Fuel Cells (Pemfc), Yong-Sheng Yang, Jing-Hua Liu, Chang-Peng Liu, Gong-Quan Sun, Chang-Zhi Li, Tian-Hong Lu Feb 2000

The Study On Fabricating Thin Electrodes For Polymer Electrolyte Membrane Fuel Cells (Pemfc), Yong-Sheng Yang, Jing-Hua Liu, Chang-Peng Liu, Gong-Quan Sun, Chang-Zhi Li, Tian-Hong Lu

Journal of Electrochemistry

To lower platinum loading in electrodes for polymer electrolyte membrane fuel cell, a new thin electrode fabrication technique (TEFT) was developed in this work. A series of low Pt loading electrodes with smooth and uniformed surface were fabricated by the TEFT. As a result, the maximum power density of the cell with platinum loading of 1 mg/cm2 and Nafion 117 membrane as electrolyte was up to 0.3 W.cm-2. Moreover, the effects of PTFE and Nafion content in cathodes on the performance of PEMFC with low Pt loading electrodes (1 mg Pt/cm2) were examined systematically.

Go to article

Electrochemical Characterization Of Ir-Ta-Ti Metal Oxide Coated Titanium Anodes, Ting-Yong Wang, Li-Kun Xu, Guang-Zhang Chen Feb 2000

Electrochemical Characterization Of Ir-Ta-Ti Metal Oxide Coated Titanium Anodes, Ting-Yong Wang, Li-Kun Xu, Guang-Zhang Chen

Journal of Electrochemistry

Ir-Ta-Ti metal oxide coated titanium anodes of variable composition were prepared by thermal decomposition. Their micro morphorogies and electrochemical properties were characterized by scanning electron microscope, open circuit potential, cyclic voltammetry, consumption rate measurements and accelerated life test. The SEM results indicated that all coatings were of a porous and cracked-mud microstructure influenced greatly by the composition of coatings. The electrochemical measurements showed that the Ir-Ta-Ti ternary oxide-coated anodes exhibited excellent electrochemical activity and electrochemical stability in both acidic media and seawater which were affected by the composition and microstructure of the coatings. Owing to good corrosion resistance and low …

Go to article

Fabrication And Examination Of Reduced Temperatrue Solid Oxide Fuel Cell Using A Supported Thin Ysz Electrolyte Substrate, Yi-Huang Zhang, Yong-Lei Dong, Yi Jiang, Zhi-Gui Lu, Jing-Wang Yan Feb 2000

Fabrication And Examination Of Reduced Temperatrue Solid Oxide Fuel Cell Using A Supported Thin Ysz Electrolyte Substrate, Yi-Huang Zhang, Yong-Lei Dong, Yi Jiang, Zhi-Gui Lu, Jing-Wang Yan

Journal of Electrochemistry

By using a cost-effective wet process,dense yttria stabilized zirconia (YSZ) films on Ni-YSZ anode substrates have been prepared successfully. The YSZ film was characterized to be around 10 μm in thickness, sufficiently dense, uniform and crack free. A single solid oxide fuel cell fabricated from the supported YSZ film electrolyte on the anode substrate and a LSM cathode prepared on the YSZ film was tested. The power density reached to 0.1 W/cm2 at 800 ℃, showing a reasonable performance. Further analysis on both electrodes shows that the anodic overpotential was much larger than IR drop (including YSZ resistance and …

Go to article

Electro-Oxidation Of Glyoxal To Glyoxalic Acid, Yin-Sheng Chen, Xin-Sheng Zhang, Jun Hu, Ying-Chun Dai Feb 2000

Electro-Oxidation Of Glyoxal To Glyoxalic Acid, Yin-Sheng Chen, Xin-Sheng Zhang, Jun Hu, Ying-Chun Dai

Journal of Electrochemistry

An investigation has been made to obtain the glyoxalic acid by the electrochemical oxidation of glyoxal solution with hydrochloric acid under various experimental conditions.The cell used consists of a lead cathode, a DSA anode and a cation-exchange membrane of model CM001. The current efficiency and yield for glyoxalic acid generation were 80.0% and 91.1% respectively, under optimal operating conditions: velocity of electrolyte flow 1.4 m·s-1 ,current density 450 A·m-2, temperature 30～40 ℃, initial concentration of glyoxal and hydrochloric acid 9.1%～16.0%, 4%～6%, respectively.

Go to article

A Comparative Analysis Of Two Independent Power Plants Under Different Ownership, Rangash Natarajan Jan 2000

A Comparative Analysis Of Two Independent Power Plants Under Different Ownership, Rangash Natarajan

Student Works (2000-2009)

Many governments have turned to private investors, especially Independent Power Producers (IPPs), to provide some or all of the nation's power requirements. The main reasons for this are: a) to eliminate the financial burden of the government, b) to promote competition in the generation sector to improve operating efficiency and reduce generating cost, and c) to transfer power generation technology, especially in the developing nations, at a rapid pace. In line with world trends, the Malaysian government, in 1993, deregulated its power generation sector. This was done in order to overcome the shortage of installed capacity due to an increase …

Go to article

First Prev