Open Access. Powered by Scholars. Published by Universities.®
Electronic Devices and Semiconductor Manufacturing Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Keyword
-
- Semiconductor (2)
- COMSOL (1)
- Discrete Dipole Approximation (1)
- Distributed modeling (1)
- Electrical properties of matter (1)
-
- Electrical resistor (1)
- Energy (1)
- Energy conversion (1)
- GaN HEMT (1)
- Law of Conservation of Energy (1)
- Membrane Separations (1)
- Metals (1)
- Microdialysis (1)
- Microfluidics (1)
- Mm-wave transistors (1)
- Nanoantennae (1)
- Nanocrystals (1)
- Nanostructure (1)
- Noble Metal (1)
- Semiconductor device modeling (1)
- Thermal analysis (1)
- Thermal properties of matter (1)
- Thermal resistor (1)
- Wave propagations (1)
- Publication Type
Articles 1 - 5 of 5
Full-Text Articles in Electronic Devices and Semiconductor Manufacturing
Distributed Modeling Approach For Electrical And Thermal Analysis Of High-Frequency Transistors, Amirreza Ghadimi Avval
Distributed Modeling Approach For Electrical And Thermal Analysis Of High-Frequency Transistors, Amirreza Ghadimi Avval
Graduate Theses and Dissertations
The research conducted in this dissertation is focused on developing modeling approaches for analyzing high-frequency transistors and present solutions for optimizing the device output power and gain. First, a literature review of different transistor types utilized in high-frequency regions is conducted and gallium nitride high electron mobility transistor is identified as the promising device for these bands. Different structural configurations and operating modes of these transistors are explained, and their applications are discussed. Equivalent circuit models and physics-based models are also introduced and their limitations for analyzing the small-signal and large-signal behavior of these devices are explained. Next, a model …
Development Of A Comsol Microdialysis Model, Towards Creation Of Microdialysis On A Chip With Improved Geometries And Recovery, Patrick Pysz
Development Of A Comsol Microdialysis Model, Towards Creation Of Microdialysis On A Chip With Improved Geometries And Recovery, Patrick Pysz
Graduate Theses and Dissertations
Microdialysis (µD) sampling is a diffusion-limited sampling method that has been widely used in different biomedical fields for greater than 35 years. Device calibration for in vivo studies is difficult for current non-steady state analytes of interest correlated with both inflammatory response and microbial signaling molecules (QS); which exist in low ng/mL to pg/mL with molecular weights over a wide range of 170 Da to 70 kDa. The primary performance metric, relative recovery (RR), relating the collected sample to the extracellular space concentration varies from 10% to 60% per analyte even under controlled bench-top conditions. Innovations in microdialysis device design …
Interfacial Contact With Noble Metal - Noble Metal And Noble Metal - 2d Semiconductor Nanostructures Enhance Optical Activity, Ricardo Raphael Lopez Romo
Interfacial Contact With Noble Metal - Noble Metal And Noble Metal - 2d Semiconductor Nanostructures Enhance Optical Activity, Ricardo Raphael Lopez Romo
Graduate Theses and Dissertations
Noble metal nanoparticles and two-dimensional (2D) transition metal dichalcogenide (TMD) crystals offer unique optical and electronic properties that include strong exciton binding, spin-orbital coupling, and localized surface plasmon resonance. Controlling these properties at high spatiotemporal resolution can support emerging optoelectronic coupling and enhanced optical features. Excitation dynamics of these optical properties on physicochemically bonded mono- and few-layer TMD crystals with metal nanocrystals and two overlapping spherical metal nanocrystals were examined by concurrently (i) DDA simulations and (ii) far-field optical transmission UV-vis spectroscopic measurements. Initially, a novel and scalable method to unsettle van der Waals bonds in bulk TMDs to prepare …
Energy Transformation And Conservation Investigation, Mike Jackson, Holly Haney
Energy Transformation And Conservation Investigation, Mike Jackson, Holly Haney
High School Lesson Plans
Students will use a thermoelectric generator module to analyze the relationship between thermal and electrical energies. Using data collection sensors and analysis software, students will investigate the relationship between the temperature gradient across a thermoelectric generator module and the resulting electrical potential. Students will then use their data and analysis to solve problems relating to waste thermal energy in electrical systems and communicate their work to their peers and teacher.
Properties Of Matter, Mike Jackson, Holly Haney
Properties Of Matter, Mike Jackson, Holly Haney
High School Lesson Plans
Students will investigate the relationship(s) between thermal and electrical properties of matter. First, students will use a multimeter and temperature probe to investigate the relationship between electrical resistance and temperature of an electrical resistor composed of metals. They will then graph collected data to analyze the relationship and draw a conclusion as to their relationship. They will then perform the same investigation on a thermal resistor made of a semiconducting substance and analyze that collected data. Finally, using ClaimEvidence-Reasoning (CER) structure, students will use their experimental evidence to state the similarities and differences between the electro-thermal properties of metals and …