Controls and Control Theory Commons^™

Novel Locomotion Methods In Magnetic Actuation And Pipe Inspection, Adam Cox

Mechanical Engineering Research Theses and Dissertations

There is much room for improvement in tube network inspections of jet aircraft. Often, these inspections are incomplete and inconsistent. In this paper, we develop a Modular Robotic Inspection System (MoRIS) for jet aircraft tube networks and a corresponding kinematic model. MoRIS consists of a Base Station for user control and communication, and robotic Vertebrae for accessing and inspecting the network. The presented and tested design of MoRIS can travel up to 9 feet in a tube network. The Vertebrae can navigate in all orientations, including smooth vertical tubes. The design is optimized for nominal 1.5" outside diameter tubes. We …

Modeling, Control And Estimation Of Reconfigurable Cable Driven Parallel Robots, Adhiti Raman Thothathri

All Dissertations

The motivation for this thesis was to develop a cable-driven parallel robot (CDPR) as part of a two-part robotic device for concrete 3D printing. This research addresses specific research questions in this domain, chiefly, to present advantages offered by the addition of kinematic redundancies to CDPRs. Due to the natural actuation redundancy present in a fully constrained CDPR, the addition of internal mobility offers complex challenges in modeling and control that are not often encountered in literature.

This work presents a systematic analysis of modeling such kinematic redundancies through the application of reciprocal screw theory (RST) and Lie algebra while …

Hypoxic Incubation Chamber, Simone Lisette Helfrich, Makenzie Nicole Jones

Biomedical Engineering: Graduate Reports and Projects

This paper describes the design, manufacturing, and testing of a novel controllable hypoxic incubator with fully functional oxygen gas control and temperature control in a humid environment. On the current market, a majority of the few hypoxic incubators use pre-mixed gas that does not offer precise control over gas concentration. The objective for this project was to create a chamber that allows the user to set the O2 concentration to varying set points of % O2 while maintaining the chamber at a constant body temperature, CO2 level, humidity, and sterility. To start the project, multiple concepts were developed for the …

Hypoxic Incubation Chamber, Simone Lisette Helfrich, Makenzie Nicole Jones

Master's Theses

This paper describes the design, manufacturing, and testing of a novel controllable hypoxic incubator with fully functional oxygen gas control and temperature control in a humid environment. On the current market, a majority of the few hypoxic incubators use pre-mixed gas that does not offer precise control over gas concentration. The objective for this project was to create a chamber that allows the user to set the O2 concentration to varying set points of % O2 while maintaining the chamber at a constant body temperature, CO2 level, humidity, and sterility. To start the project, multiple concepts were developed for the …

Multi-Robot Symbolic Task And Motion Planning Leveraging Human Trust Models: Theory And Applications, Huanfei Zheng

All Dissertations

Multi-robot systems (MRS) can accomplish more complex tasks with two or more robots and have produced a broad set of applications. The presence of a human operator in an MRS can guarantee the safety of the task performing, but the human operators can be subject to heavier stress and cognitive workload in collaboration with the MRS than the single robot. It is significant for the MRS to have the provable correct task and motion planning solution for a complex task. That can reduce the human workload during supervising the task and improve the reliability of human-MRS collaboration. This dissertation relies …

Project Khepri: Mining Asteroid Bennu For Water, Erika Frost, Gowtham Boyala, Adam Gremm, Ahmet Gungor, Amirhossein Taghipour, Massimo Biella, Jiawei "Jackson" Qiu, Athip Thirupathi Raj, Arjun Chhabra, Adam Gee, Saanjali Maharaj, Erin Richardson, Julia Empey, Haidar Ali Abdul-Nabi, Lindsay Richards, Ariyaan Talukder, Aaron Groh, Brie Miklaucic, Jd Carlson, Kristina Kim, Maverick Cue

Undergraduate Student Research Internships Conference

Deep space asteroid mining presents the opportunity for the collection of critical resources required to establish a cis-lunar infrastructure. In specific, the Project Khepri team has focused on the collection of water from asteroid Bennu. This water has the potential to provide a source of clean-energy propellant as well as an essential consumable for humans or agriculture on crewed trips to the Moon or Mars. This would avoid the high costs of launching from Earth - making it a highly desirable element for the future of cis-lunar infrastructure. The OSIRIS-REx mission provided a complete survey of asteroid Bennu and is …

Developing A Miniature Smart Boat For Marine Research, Michael Isaac Eirinberg

Computer Engineering

This project examines the development of a smart boat which could serve as a possible marine research apparatus. The smart boat consists of a miniature vessel containing a low-cost microcontroller to live stream a camera feed, GPS telemetry, and compass data through its own WiFi access point. The smart boat also has the potential for autonomous navigation. My project captivated the interest of several members of California Polytechnic State University, San Luis Obispo’s (Cal Poly SLO) Marine Science Department faculty, who proposed a variety of fascinating and valuable smart boat applications.

Model-Based Design Of An Optimal Lqg Regulator For A Piezoelectric Actuated Smart Structure Using A High-Precision Laser Interferometry Measurement System, Grant P. Gallagher

Master's Theses

Smart structure control systems commonly use piezoceramic sensors or accelerometers as vibration measurement devices. These measurement devices often produce noisy and/or low-precision signals, which makes it difficult to measure small-amplitude vibrations. Laser interferometry devices pose as an alternative high-precision position measurement method, capable of nanometer-scale resolution. The aim of this research is to utilize a model-based design approach to develop and implement a real-time Linear Quadratic Gaussian (LQG) regulator for a piezoelectric actuated smart structure using a high-precision laser interferometry measurement system to suppress the excitation of vibratory modes.

The analytical model of the smart structure is derived using the …

Manual Material Handling Lift-Assist System For Occupational Exoskeleton, Erik Goes, Daniel Guthrie, Trevor Ward

Honors Capstones

It is no secret that lifting heavy objects is one of the premier causes of workplace injury, and the modern worker needs help to remain healthy. Workers need something they always have with them that makes their work safer as well as easier; our solution is an active lift-assist exoskeleton. The proposed exoskeleton design includes a military backpack exoskeleton frame, on which two actuators pull cables attached to end effectors that the operator will be holding. This system can adjust to conform to a wide variety of operator sizes, without restricting any of their range of motion. This leads to …

Control, Decision-Making, And Learning Approaches For Connected And Autonomous Driving Systems With Humans-In-The-Loop, Fangjian Li

All Dissertations

By virtue of vehicular connectivity and automation, the vehicle becomes increasingly intelligent and self-driving capable. However, no matter what automation level the vehicle can achieve, humans will still be in the loop despite their roles. First, considering the manual driving car as a disturbance to the connected and autonomous vehicles (CAVs), a novel string stability is proposed for mixed traffic platoons consisting of both autonomous and manual driving cars to guarantee acceptable motion fluctuation and platoon safety. Furthermore, humans are naturally considered as the rider in the passenger vehicle. A human-centered cooperative adaptive cruise control (CACC) is designed to improve …

Development Of A Compliant Gripper Driven By 3 Dof Soft Robot, Derek M. Price Ii, Ricardo Ramirez, Pt Angel Tran

Symposium of Student Scholars

Industrial robots are moving toward automation, which makes it increasingly necessary to replace the functions traditionally performed by humans with robotics. Pick and place operation is a prime example of such automation. Robots that pick up and place objects mimic the human action of picking an object up and placing it in a targeted location. It has led to the development of robotic end-effectors that have a human-like feel. Grippers can be articulated in various ways depending on their application area and well-defined desired tasks. As compliant and soft links deflect more under the same load than their rigid body …

The Effects Of Reference-Command Preview On The Strategies That Humans Use In Command-Following Tasks, Amelia J. S. Sheffler

Theses and Dissertations--Mechanical Engineering

This thesis presents results from an experiment in which 22 human subjects each interact with a dynamic system 40 times over a one-week period. For each interaction, a subject performs a command-following task, where the reference command is the same for all 22 subjects but different on each trial. The subjects are divided into 2 groups of 11 subjects. One group performs the command-following task without reference-command preview. The other group is provided with 1-s preview of the reference command. The experimental results are used to examine the effects of reference-command preview. For the group with 1-s reference-command preview, the …

Experimental Comparison Of Two Sampled-Data Adaptive Control Algorithms For Rejecting Sinusoidal Disturbances, William Grayson Woods

Theses and Dissertations--Mechanical Engineering

We review two adaptive control algorithms that address the problem of rejecting sinusoids with known frequencies that act on an unknown asymptotically stable linear time-invariant system. We present modifications to the algorithms that address the problems of sensor noise and actuator saturation. We demonstrate the effectiveness of the algorithms and compare the performance of the algorithms via numerical simulation and experimental testing.

Formation Control With Bounded Controls And Collision Avoidance: Theory And Application To Quadrotor Unmanned Air Vehicles, Zachary S. Lippay

Theses and Dissertations--Mechanical Engineering

This dissertation presents new results on multi-agent formation control and applies the new control algorithms to quadrotor unmanned air vehicles. First, this dissertation presents a formation control algorithm for double-integrator agents, where the formation is time varying and the agents’ controls satisfy a priori bounds (e.g., the controls accommodate actuator saturation). The main analytic results provide sufficient conditions such that all agents converge to the desired time-varying relative positions with one another and the leader, and have a priori bounded controls (if applicable). We also present results from rotorcraft experiments that demonstrate the algorithm with time-varying formations and bounded controls. …

Model Predictive Control Of Energy Systems For Heat And Power Applications, Chethan Ramakrishna Reddy

Dissertations, Master's Theses and Master's Reports

Building and transportation sectors together account for two-thirds of the total energy consumption in the US. There is a need to make these energy systems (i.e., buildings and vehicles) more energy efficient. One way to make grid-connected buildings more energy efficient is to integrate the heating, ventilation and air conditioning (HVAC) system of the building with a micro-scale concentrated solar power (MicroCSP) sys- tem. Additionally, one way to make vehicles driven by internal combustion engine (ICE) more energy efficient is by integrating the ICE with a waste heat recovery (WHR) system. But, both the resulting energy systems need a smart …

Modeling Human Control Behavior In Command-Following Tasks, Sajad Koushkbaghi

Theses and Dissertations--Mechanical Engineering

Humans interact with a variety of complex dynamic systems on a daily basis. However, they are often the lesser understood component of human-in-the-loop (HITL) systems. In this dissertation, we present the results of two HITL experiments to investigate the control strategies that humans use when performing command-following tasks. The first experiment is designed to investigate the control strategies that humans use to interact with nonlinear dynamic systems. Two groups of human subjects interact with a dynamic system and perform a command-following task. One group interacts with a linear time-invariant (LTI) dynamic system and the other group interacts with a Wiener …