Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Publication
- File Type
Articles 1 - 3 of 3
Full-Text Articles in Digital Circuits
3d Printed Portable Automatic Pill Dispenser, Amber M. Ocasio
3d Printed Portable Automatic Pill Dispenser, Amber M. Ocasio
Publications and Research
Medication adherence is a major public health concern, particularly among patients with chronic illnesses. Reports from the National Institutes of Health indicate that adherence rates are significantly lower for chronic conditions, with patients taking only ~50% of medications prescribed. Unintentional non-adherence—such as forgetting doses—is more prevalent (62.9%, 47.1%, 46.9%) than intentional non-adherence, and the consequences include medication waste, disease progression, reduced functional abilities, lower quality of life, and increased reliance on medical resources. Because existing automatic pill dispensers cost over $100 on average, they remain inaccessible for many lower-income patients who could benefit from such technology. This project addresses this …
Improving 3d Printed Prosthetics With Sensors And Motors, Rachel Zarin
Improving 3d Printed Prosthetics With Sensors And Motors, Rachel Zarin
Honors Projects
A 3D printed hand and arm prosthetic was created from the idea of adding bionic elements while keeping the cost low. It was designed based on existing models, desired functions, and materials available. A tilt sensor keeps the hand level, two motors move the wrist in two different directions, a limit switch signals the fingers to open and close, and another motor helps open and close the fingers. All sensors and motors were built on a circuit board, programmed using an Arduino, and powered by a battery. Other supporting materials include metal brackets, screws, guitar strings, elastic bands, small clamps, …
3d Printed Smart Mobile, Bingfang Chen
3d Printed Smart Mobile, Bingfang Chen
Publications and Research
The goal of this research project is to design and build a prototype of a smart mobile robot to participate and compete in IEEE Micro-mouse and similar competitions. The robot has to find its way out of a maze as quickly as possible, by exploring and learning the paths in the maze. 3D printing technology will be used to build a lightweight robot frame so that it can move at a fast speed.