Digital Circuits Commons^™

Statistical Monitoring Of Hard Faults In Digital Systems, Dany Akshay Deep Isukapalli

Electrical Engineering Theses and Dissertations

Achieving a high test coverage is crucial for helping to ensure that integrated circuits are working correctly and are non-defective. Although scan-based structural tests are used throughout the industry, high-level functional tests may be needed to detect some defects— especially those that are environmentally sensitive. Unfortunately, the character of functional test makes it difficult to obtain high coverage, and it is even hard to estimate coverage because fault simulation times of large circuits are long. As a result, some method is required for predicting the ability of a functional test that has not been fault simulated to detect defects. In …

Towards Multipronged On-Chip Memory And Data Protection From Verification To Design And Test, Senwen Kan, Jennifer Dworak

Computer Science and Engineering Theses and Dissertations

Modern System on Chips (SoCs) generally include embedded memories, and these memories may be vulnerable to malicious attacks such as hardware trojan horses (HTHs), test access port exploitation, and malicious software. This dissertation contributes verification as well as design obfuscation solutions aimed at design level detection of memory HTH circuits as well as obfuscation to prevent HTH triggering for embedded memory during functional operation. For malicious attack vectors stemming from test/debug interfaces, this dissertation presents novel solutions that enhance design verification and securitization of an IJTAG based test access interface. Such solutions can enhance SoC protection by preventing memory test …

Using A Light-Based Power Source To Defeat Power Analysis Attacks, Remus Valentin Tumac

Computer Science and Engineering Theses and Dissertations

Power analysis attacks exploit the correlation between the information processed by an electronic system and the power consumption of the system. By powering an electronic system with an optical power source, we can prevent meaningful information from being leaked to the power pins and captured in power traces. The relatively constant current draw of the optical power source hides any variability in the power consumption of the target system caused by the logic gates' switching activity of the system as observed at the power pins. This thesis will provide evidence to show that using an optical power source should make …

A 2.56 Gbps Serial Wireline Transceiver That Supports An Auxiliary Channel And A Hybrid Line Driver To Compensate Large Channel Loss, Xiaoran Wang

Electrical Engineering Theses and Dissertations

Serial transceiver links are widely used for high-speed point-to-point communications. This dissertation describes two transceiver link designs for two different applications.

In serial wireline communications, security is an increasingly important factor to concern. Securing an information processing system at the application and system software layers is regarded as a necessary but incomplete defense against the cyber security threats. In this dissertation, an asynchronous serial transceiver that is capable of transmitting and receiving an auxiliary data stream concurrently with the primary data stream is described. The transceiver instantiates the auxiliary data stream by modulating the phase of the primary data without …

Heuristic-Based Threat Analysis Of Register-Transfer-Level Hardware Designs, Wesley Layton Ellington

Electrical Engineering Theses and Dissertations

The development of globalized semiconductor manufacturing processes and supply chains has lead to an increased interest in hardware security as new types of hardware based attacks, called hardware Trojans, are being observed in industrial and military electronics. To combat this, a technique was developed to help analyze hardware designs at the register-transfer-level (RTL) and locate points of interest within a design that might be vulnerable to attack. This method aims to eventually enable the creation of an end-to-end design hardening solution that analyzes existing designs and suggests countermeasures for potential Trojan attacks. The method presented in this work uses a …

Investigating The Effect Of Detecting And Mitigating A Ring Oscillator-Based Hardware Trojan, Lakshmi Ramakrishnan

Electrical Engineering Theses and Dissertations

The outsourcing of the manufacturing process of integrated circuits to fabrications plants all over the world has exposed these chips to several security threats, especially at the hardware level. There have been instances of malicious circuitry, such as backdoors, being added to circuits without the knowledge of the chip designers or vendors. Such threats could be immensely powerful and dangerous against confidentiality, among other vulnerabilities.

Defense mechanisms against such attacks have been probed and defense techniques have been developed. But with the passage of time, attack techniques have improved immensely as well. From directly observing the inputs or outputs, adversaries …

Improving System-On-Chip Test Networks For: Bandwidth, Security, And Power, Saurabh Gupta

Computer Science and Engineering Theses and Dissertations

Modern System-on-Chips (SoCs) provide benefits such as reduction in overall system cost, and size, increased performance, and lower power consumption. Increasing complexity of these Integrated Circuits (ICs) has resulted in a higher probability of manufacturing defects. Manufacturing defects can result in the faulty operation of a system. Thus, it is essential to test an IC after it is manufactured to detect any possible faults in it. These SoCs include on-chip embedded instruments that can be used for test, debug, diagnosis, validation, monitoring, characterization, configuration, or functional purposes. IEEE 1687 Std. (IJTAG) provides a standard interface for the reconfigurable access and …

Implementation Of Switching Circuit Models As Vector Space Transformations, David Kebo Houngninou

Computer Science and Engineering Theses and Dissertations

Modeling of switching circuits is the foundation for many Electronic Design Automation (EDA) tasks and is commonly used at various phases of the design flow for tasks such as simulation, justification, and other analyses. State-of-the-art simulation tools are based on discrete event algorithms using switching algebraic models and are highly optimized and mature. Symbolic simulation may also be implemented using a discrete event approach, or other approaches based on extracted functional models. The common foundation of modern simulation tools is that of a switching or Boolean algebraic model that may be augmented with timing information. Justification using switching circuit models …

Genetic Algorithms Vs. Simulated Annealing: A Comparison Of Approaches For Solving The Circuit Partitioning Problem, Theodore W. Manikas, James T. Cain

Computer Science and Engineering Research

An important stage in circuit design is placement, where components are assigned to physical locations on a chip. A popular contemporary approach for placement is the use of simulated annealing. While this approach has been shown to produce good placement solutions, recent work in genetic algorithms has produced promising results. The purpose of this study is to determine which approach will result in better placement solutions.

A simplified model of the placement problem, circuit partitioning, was tested on three circuits with both a genetic algorithm and a simulated annealing algorithm. When compared with simulated annealing, the genetic algorithm was found …