Open Access. Powered by Scholars. Published by Universities.®
Other Civil and Environmental Engineering Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Keyword
Articles 1 - 2 of 2
Full-Text Articles in Other Civil and Environmental Engineering
Using Stream Restoration To Mitigate Stormwater Runoff In An Urban Watershed: A Case Study, Jonathan M. Brantley
Using Stream Restoration To Mitigate Stormwater Runoff In An Urban Watershed: A Case Study, Jonathan M. Brantley
Theses and Dissertations--Biosystems and Agricultural Engineering
The goal of this case study was to evaluate the effectiveness a 275 m regenerative stream restoration design to mitigate stormwater runoff in a highly urbanized watershed. The restoration resulted in a wide, wetland-like floodplain, comprised of a rock base that was overtopped with a filtration media (approximately 30% woodchips and 70% topsoil). The creation of the floodplain-wetland complex in tandem with filtration media lead to increased storage capacity and an increase in hyporheic exchange within the system. Significant reductions were found for the storm hydrograph parameters volume, peak discharge, and time to peak. Reductions in baseflows were also noted …
Load And Pressure Distribution As A Function Of Dynamic Contact Stress At The Railroad Crosstie-Ballast Interface, Habib Abdil Unluoglu
Load And Pressure Distribution As A Function Of Dynamic Contact Stress At The Railroad Crosstie-Ballast Interface, Habib Abdil Unluoglu
Theses and Dissertations--Civil Engineering
Excessive crosstie wear and abrasion and ballast wear and fouling are two of the fundamental problems contributing to inadequate railroad track performance. This adversely affects the attainment and long-term maintenance of desired track geometric requirements. The magnitudes and distribution of the stresses at the crosstie-ballast (CT-B) interface must be known to determine the stress distribution on the ballast. However, the stresses at the top of the ballast often vary significantly. This study examines a new approach to predicting dynamic contact pressures at the interface of crosstie and ballast using the ‘square wave theory.’ A data set of in-track CT-B interfacial …