Civil and Environmental Engineering Commons^™

The Electrical Resistance Of Metals In Their Hard And Soft States, Eugene A. Avery

Bachelors Theses and Reports, 1928 - 1970

Many investigations have shown that the electrical resistance of soft annealed metals is usually smaller than that of metals in their hard, cold worked state. By annealing cold-worked metals, the electrical resistance decreases to a minimum and then increases upon continued annealing at higher temperatures. The work performed in this investigation upon silver, aluminum, copper, nickel, and soft steel corroborates this idea.

Effect Of Impurities Upon Current Efficiency In The Electrolysis Of Zinc Sulphate Solution, Robert Jess Smith

Bachelors Theses and Reports, 1928 - 1970

There are many elements which are detrimental to the current efficiency in the electrolysis of zinc sulphate solution. Fortunately the majority of these elements are easily removed in the purification process and cause no further trouble. The elements that are likely to cause trouble in ordinary plant operations are antimony, arsenic, cobalt, nickel, manganese and germanium. The following tests were made to determine the mutual effect on the current efficiency when several of the impurities were present in the electrolyte.

A Study Of The Composition Of Zinc Complex Cyanide Solutions By The Conductometric Method, Robert James Woody

Bachelors Theses and Reports, 1928 - 1970

As the method or analysis used up to the present time has failed to give quantitative results in determining the composition of zinc cyanide baths, conductometric methods were adopted in this study. Supplementary tests were also carried out in this investigation.

The Leaching Of Electrodeposition Of Iron, Emmett G. Simmons

Bachelors Theses and Reports, 1928 - 1970

Electrolytic iron as deposited is brittle and therefore must be annealed. After annealing, the material is ductile and closely resembles copper in its behavior under work. It is claimed to be more resistant to corrosion than dead soft iron. It also has the advantage of corroding uniformly ( or­dinary soft iron develops pin holes which shorten its life considerably).

The extreme purity of electrolytic iron namely makes it very suitable as a base metal for alloys. Its ductility opens up a field for use in the manufacture of cold rolled strip, seamless tubes, and wire.

The Recovery Of Copper In Sulphide Ores By Roasting, Leaching, And Electrolysis, Jack S. Greenough

Bachelors Theses and Reports, 1928 - 1970

Sulphide ores of copper are insoluble in dilute sulphuric acid leaching solutions, but a very high extraction can be obtained if the copper ore is in the oxidized condition. The problem is to convert the sulphide into the oxide form. This can be done by giving the sulphide ore an oxidizing-sulphatizing roast. Copper sulphate is soluble in water, so acid will be saved in the leaching process if copper sulphate is present. The iron in the copper sulphide ores is present as pyrite, or in combinations as bornite, or chalcopyrite.

The Effect Of The Fe2: Fe3 Ratio Upon The Current Efficiency In The Electrolysis Of A Copper Sulfate Solution Containing Iron Sulfate, Roy Macfarland

Bachelors Theses and Reports, 1928 - 1970

In the treatment of copper ores by hydro-electro-metallurgical methods, not only is copper deposited, but other metals are also dissolved. In practice it has been found* that iron, under certain conditions, causes the copper to deposit on the cathode as a nonadherent precipitate and also that the iron in solution causes a great decrease in current efficiency, es­pecially when the electrolysis is conducted by operating with a higher current density at the cathode than at the anode.

The present investigation deals with the effects of the two valences of iron on the current efficiency and endeavors to determine whether or …

Some Notes On The Composition Of "Copper Pitch", Richard R. Matthew

Bachelors Theses and Reports, 1928 - 1970

A supply of so-called "copper pitch" ore was received by the Montana Bureau of Mines and Geology in response to a request by them from a resident of Kalispell, who had previously sent a specimen to the Bureau for a mineralogical analysis.

Since this material was little known and had apparently received but little study under a reflec­ting microscope, it was thought that such a study might throw some light on the mineralogical and chemical composition of the material.

The Aplitic Body Bordering Roosevelt Drive South Of Butte, Montana, Edward B. Trueworthy Jr.

Bachelors Theses and Reports, 1928 - 1970

The area studied consists of a large body of aplite situated 12 miles south of Butte. It extends eastward almost to the Butte-Pipestone road, southward to Lime Kiln Hill and westward a distance of 3000 feet.

The petrographic work was supplemented by a map of the area. Special attention was given to those frequent "Limonite Specks" found in the aplite.

Joint Planes In The Rhyolites Of The Butte District, Montana, John B. Hopkins

Bachelors Theses and Reports, 1928 - 1970

The problem herein discussed deals with the pointing planes found in the area of rhyolite located in the northwestern portion of the Butte District. The question to be determined was whether or not the pointing planes in the rhyolites could be class­ified with the Butte Ore fissure systems.

A Bentonite Deposit Near Warm Springs, Montana, R. H. Larson

Bachelors Theses and Reports, 1928 - 1970

This report deals with a bentonite deposit recently developed, approximately seven miles northeast of Warm Springs, Montana. A group of claims have been staked on the deposit and are owned by the Lincoln Mining Company of Anaconda, Montana. The company also has several claims prospected for silver one mile from its present site of operations, but the silver prospects have failed to produce. The bentonite deposit was discovered incidentally during the course of other development work, and at present two adits have been driven into the side of a mountain, each crosscutting a vein-like mass of bentonite varying from two …

The Effect Of Hydrogen Overvoltage On The Electrolytic Deposition Of Zinc, John M. Munzenrider, Kenneth O. Sweeney

Bachelors Theses and Reports, 1928 - 1970

In the deposition of metallic zinc by electro­lysis from neutral or acid solution, little difficulty is experienced provided certain impurities are absent from the electrolyte. The use of the process has long been considered as a potential source, patents on the process having been issued as early as 1880. However, the early experimenters failed to realize the importance of impurities in the electrolyte, and for this reason, the process suffered several severe setbacks when commercial plants were built.

The Electrolytic Deposition Of Chromium Upon Aluminum, E. Fults, L. D. Voerge

Bachelors Theses and Reports, 1928 - 1970

The purpose or this investigation is primarily to determine the best conditions for plating chromium on aluminum. The work was carried out with the hope of obtaining coherent deposits, and of determin­ing the conditions under which such deposits may be duplicated.

Preliminary Construction Of A Photo-Electric Cell Concentrator, Stanley S. Williams

Bachelors Theses and Reports, 1928 - 1970

The separation of the valuable portion from the waste portion of an ore is an individual problem for every ore. However, the various methods for accomplishing this end, more or less classify themselves by the physical properties of the constituents of the ore. Most of the properties of minerals have been utilized in some way or other to affect the separation of the valuable from the invaluable parts. Practically nothing has been done so far with color and luster to attain this purpose.

It is believed that the photo—electric cell could also be used in concentrating a certain class of …

A Preliminary Study Of The Separation Of The Copper Sulfides From Sphalerite And The Effect Of Certain Reagents On Some Of The Pure Copper Minerals In Synthetic Mixtures, Gailen T. Vandel

Bachelors Theses and Reports, 1928 - 1970

The problem of separating the copper sulfide minerals from sphalerite, in copper - zinc ores, has been a difficult one. This is largely due to the lack of adequate research and the small amount of data obtainable on the behavior of copper and zinc sulfide minerals in flotation circuits.