Civil and Environmental Engineering Commons^™

User's Manual For The Software "Tfpi" That Implements The Traffic Forecasting Procedure For Indiana, Sunil K. Saha, Jon D. Fricker

JTRP Technical Reports

A program has been written in Microsoft QuickBASIC to implement the traffic models developed for both rural and urban Indiana state highway segments during a two-phase HPR Project carried out for the Indiana Department of Transportation. The report ''TRAFFIC VOLUME FORECASTING METHODS FOR RURAL STATE HIGHWAYS" describes the models developed in Phase 1 of the study, while the report "THE DEVELOPMENT OF A PROCEDURE TO FORECAST TRAFFIC VOLUMES ON URBAN SEGMENTS OF THE STATE AND INTERSTATE HIGHWAY SYSTEMS" describes the models developed in Phase 2. For rural interstates, new models have been developed in Phase 2 that supercede the Phase …

Micromechanics Of Granular Materials And Its Relation To Wave Velocity, Tarun K. Agarwal

Civil & Environmental Engineering Theses & Dissertations

The macro characters of the granular materials depend upon micromechanical parameters such as the void ratio, particle shape, contact force distribution, and initial state of the fabric of the assembly. Since it is difficult to evaluate these internal parameters from laboratory experiments, a macro measure is desired which depends directly on these internal parameters. One such measure has been shown to be dynamic shear modulus but it was incomplete in predicting directional changes in the internal parameters. Therefore, it is hypothesized here that the complete elastic moduli matrix will have more direct information about the internal parameters, especially the dynamic …

Continuum Modeling Methodology For Dynamic Behavior Of Towers, Khaled A. Obeid

Civil & Environmental Engineering Theses & Dissertations

A very common problem in Civil Engineering is the analysis and design of lattice structures. These types of structures generally consist of repetitive sections and have been utilized in the erection of transmission and communication towers, space roof trusses, solar energy collectors, and space platforms. Since lattice structures consist of a significantly large number of members and subsequently a large number of nodes, the classical discrete technique of analysis can be very expensive even on today's modern computers. This study applies a rational approach which capitalizes on the repetitive nature of towers to develop the equivalent continuum model for the …

A Pc Based Computer Model With A Postprocessor For The Movement Of Groundwater, Joseph Byra

Theses

Currently available computer programs that model groundwater flow are inherently limited in their capabilities, in one way or another. Additionally, many of these computer programs are relatively inaccessible to the general user because they operate off of mainframe computers and sophisticated plotters. As a result, a simple to use computer program called 2DFLOW has been modified so it can be run on a personal IBM compatible computer. It models steady-state fluid flow through saturated porous media. In addition, a postprocessor called 2DPLOT has been developed. The postprocessor generates the equipotential contours and the flux vectors that describe the physics of …

Irish Building Services News

Building Services Engineering

No abstract provided.

Irish Building Services News

Building Services Engineering

No abstract provided.

Irish Building Services News

Building Services Engineering

No abstract provided.

A Critical Analysis On Cogeneration Policy, R. Tjahjokartiko Gondokusumo

Theses

It could be difficult to understand electricity problems without knowing its history; how a combine of legal, administration, and financial means effects electricity in the development. The recent public law on energy-related issues traceable by this study is the Renewable Energy and Energy Efficiency Technology Competitiveness Act of 1989.

In short, cogeneration was proposed to utility (as public property) from industry (as private property) under PURPA (of which National Energy Act is the legislative history). Thus, it should be clear that the problems of cogeneration is not pro or contra issues. It is a national issue. Then, a cogeneration planner …

Density Currents In Circular Wastewater Treatment Tanks, David M. Laliberte

Dissertations and Theses

Deviations from ideal flow and settling occur in circular wastewater treatment tanks because of tank geometry, flow conditions, and density currents caused by variations in suspended solids concentration and temperature distributions. Thermally induced density currents were investigated in this study. Under winter, low flow conditions, measurements were made of vertical and radial temperature distributions in the circular chlorination tank at Lake Oswego, Or., and in the circular primary and secondary clarifiers at Bend, Or. Thermistor arrays were used to collect the data which exhibited both vertically well-mixed and a two-layer flow regime. Inlet geometry and suspended solids in the secondary …

Irish Building Services News

Building Services Engineering

No abstract provided.

Transport Matrices Of Finite Beams Resting On Elastic Foundations, M. W. Giger

Tanzania Journal of Engineering and Technology (TJET)

A method of derivation of the coefficients of the transport matrix for a finite element resting on one and two-parameter elastic foundation soils is outlined. The coefficients are summarized for both the Bernoulli–Euler and the Timoshenko beam model in tabular form, for general reference. In addition, bounds on the parameters describing beam/soil flexure, beam and soil shear, which govern the validity of the two-parameter elastic solutions are provided in graphical form.

A Study Of Load Bearing Capacity Of Piles Driven In The Zanzibar Harbour Submarine Soils, A. M. Dubi

Tanzania Journal of Engineering and Technology (TJET)

The rehabilitation of the Zanzibar Port involved, among other things, driving piles into the submarine soils. Pile driving fractures the coral and as a result creates a gap filled with loose fractured coral between the unfractured coral and the pile. Grouting of the external surface of the pile is done to strengthen the fractured coral. In this paper, two grouted working piles (TP6 & TP61), randomly chosen from the pile group, were load tested to twice the design load. The test results indicate adequacy of the bearing capacity of the grouted piles.

Force Displacement Relationship For The Prediction Of Structural Fluttering, Ladislaus Lwambuka

Tanzania Journal of Engineering and Technology (TJET)

A new presentation of force displacement relationship for the prediction of structural fluttering is discussed in this paper. This topic is limited to a detailed discussion of the derivation of the equations of motion for the rigid streamlined airfoil/flat plate system of three degrees of freedom, which yields expressions for aerodynamic resultant forces due to a steady air flow. The equations of motion presented herein are derived from the conventional classical complex presentation transformed into real matrix equations. This new presentation of the equations of motion constitutes the foundation for the latest state-of-the-art of predicting critical wind loads on the …

Freight Transport Management In India Railways Through Improved Wagon Utilization, T Krishna Kumar, D M Pradyumna, R D Saklani

IIMB Management Review

Application of management concepts and tools to the service sector, particularly in the public sector, is of very recent origin. Such applications to rail freight transport, particularly in developing countries, are very few. This paper presents such an application to the problem of freight transport management in Indian Railways. The problem considered is that of efficient utilization of the scarce rolling stock -wagons. The plan of the paper is as follows. Section 2 gives a brief background of Indian Railways. A brief review of freight management models is presented in Section 3. The same section also gives a description of …

Irish Building Services News

Building Services Engineering

No abstract provided.

Calcium Bentonite In Containment Structures, Ramnarayan K. Tirumala

Theses

Experiments were conducted on calcium bentonite from different sources to determine its suitability as a material for slurry wall. The emphasis was placed on cement-bentonite types of materials. A few tests were conducted on specimens consisting of soil-bentonite materials. Permeability, swelling potential, and immersion tests were conducted. Specimens were initially permeated with water to determine which variety of bentonite was most suitable and later with chemicals. In cement bentonite specimens, the effect of addition of blast furnace slag, fly ash, and sand were also studied. Addition of slag cement lowered the permeability value by an order of magnitude, and with …

Behavior Of Slender High Strength Reinforced Columns Under Biaxially Eccentric Loading, Pei-Shiun Wu

Theses

The advantage of using high strength concrete is to reduce column sizes and to increase stiffness. At present there are not any available design aids and the code provisions that provide adequate guidelines for the design of slender columns in high strength concrete.

A total of four 3 in. by 3 in. dimension, 4 ft. length high strength concrete specimens were casted, cured and tested till failures in a vertical pinned-ended configuration.The experimental results were compared with the analysis using Hsu failure surface equation.

Moment, curvature and load deflection cures were obtained successfully from the present experimental tests. These curves …

Investigation Of Mixed-Made Fracture In Concrete, Stylianos C. Aniftos

Theses

This study is aimed at evaluating the failure characteristics of concrete in the notched beam configuration. In general, for Mode I failure tension is commonly encountered. However, in the area of high shear stress, it remains to be a question whether shear or Mode II failure exists. Researches carried out in the past decade confirmed the existance of both Mode I and Mode II failure. It is the objective of this investigation to clarify this failure characteristics using FRANC an interactive fracture mechanics software.

The investigation carried out in this study used the experimental results of Bazant and Pfeiffer (3) …

Construction Cost Estimating In Project Management, Kalpit N. Patel

Theses

The primary objective of Cost Estimating is to support the timely generation of bid or alternative estimates. Cost Estimating also supports management analysis of estimate accuracy, reasonableness and project risk through the generation of summary reports and analysis. Estimates also provide a base of information during construction for such items as scope changes to the contract, variations in costs of the project cost, total project cost, feedback for scheduling etc.

Contruction cost estimating is the process of identifying and compiling the many items of cost that will enter into a construction project. This is a procedure that requires very detailed …

Experimental Evaluation Of Process Zone Deformation In Concrete, Cherng-Maou Meng

Theses

Concrete structures are often subjected to a variety of loading conditions. Under ultimate load design, concrete structures can resist these loads without evident deformation. However, under service, tension cracks will develop and depending on their location, they may impair load carrying capacity.

It is generally believed that microcrack development is preceeded by formation of a relatively long microcracked region. A large number of studies have indicated that due to formation of this process zone (microcracked zone), Linear Elastic Fracture Mechanics (LEFM) principles are not applicable to concrete. However, a number of nonlinear models can be developed if the length of …

Prestressed Concrete Columns Under Bending And Axial Load, Ajit Chiplunkar

Theses

A general analysis and design equation for slender and nonslender prestressed concrete columns subjected to uniaxial or biaxial moments combined with axial load is proposed. The proposed equation is an extension to the one developed by Hsu for reinforced concrete columns. The analytical results of the ultimate loads of eccentrically loaded slender prestressed columns are compared with the experimental results reported by Brown and Hall and Aroni respectively. The comparative study shows that the proposed equation of interaction diagram is in good agreement with the actual tests.

The ultimate loads of biaxially loaded short columns are also compared with the …

Shear Behavior Of Steel Fiber Reinforced Concrete Beams Under Monotonic And Cyclic Loads, June Suh

Theses

Up to now relatively few tests have been reported on shear behavior in fiber reinforced concrete beams. Even less experiments have been carried out under fatigue loading. In the present experiment, the reinforced concrete beams with 1 percent and 2 percent steel fiber volume fraction are investigated. Conventional stirrups are included in number of beams at certain intervals. Beams are loaded under monotonic and cyclic loads. The strength of beams are determined and the behavior of beams under each loading are observed in order to determine some advantages of adding steel fibers to reinforced concrete beams.

It has been found …

Study Of Essential Factors Affecting The Efficiency Of Sludge Digestion, I-Chang Tsao

Theses

The sludge produced by wastewater treatment plant has some major characteristics such as high COD ( 52093 mg/1 - 79683 mg/1) and VS ( 19247 mg/1 - 44178 mg/1). The present laboratory investigation has indicated that successful treatment and purification of the subject of sludge is possible using multiple-stage anaerobic digestion system.

The multiple-stage system is capable of degrading 40-55% of COD and 50 to 60% of VS. The conventional digestion system degrades 30-45% of COD and 40-50% of VS. After treated by conventional system and multiple-stage system, the concentration of COD and VS are still high (21200 mg/1 - …

Behavior Of Slender High Strength Steel Fiber Reinforced Concrete Columns Under Combined Biaxial Bending And Axial Compression, Tzuoh-Jaw Wu

Theses

A total of four slender high strength steel fiber ( 20 vol. hooked ends 1 in and 2 in ) reinforced concrete columns were casted, cured and tested to failure under biaxially eccentric load us—KT MTS testing system. The experimental load-deflection behavior exhibits not only the ascending branch but also the descending branch of the load and deformation curves.

The experimental ultimate load capacity was analyzed by the equation of Failure Surface Method developed by Hsu. recently, the result shows that the analysis method is able to predict the ultimate load value for biaxially loaded slender concrete columns.

For biaxially …

Effects Of Fly Ash And Kiln Dust On The Compressive Strength Of Cement Mortar, Yitao Yu

Theses

Fly ash generated from coal-burning power plants has been an increasing problem to the utility company in terms of storage and disposal in compliance with the environmental regulations. Presently, fly ash has been widely used in the concrete mix. Research shows that fly ash can improve many properties of fresh and harden concrete. Landfill is another significant usage of fly ash. Usually, fly ash is stored in dry and weathered conditions. The properties of fly ashes from different sources and in different storage conditions are different.

In this research, the compressive strength of mortar containing cement replacement of Deep Hollow, …

The Frontal Method For Finite Element Analysis On Ibm-3090 Vector Computer, Chaerul Kamal

Civil & Environmental Engineering Theses & Dissertations

In this report, a Finite Element program based on the Frontal method was implemented on the IBM-3090 to exploit the vector capabilities offered by modern high performance vector computers. The overall computational speed for the Frontal Finite Element program was increased by 30% when the vector instructions were introduced. The Frontal solution for a system of simultaneous linear equations, however, has shown only minor improvement when vector instructions were used. More improvement in computational speed and memory storage can be expected by using the Parallel Frontal method with Substructures.

Irish Building Services News

Building Services Engineering

No abstract provided.

Nonproportionally Loaded Steel Beam-Columns And Flexibly-Connected Nonsway Frames, Siva Prasad Darbhamulla

Civil & Environmental Engineering Theses & Dissertations

A theoretical study of the inelastic stability of nonproportionally loaded steel beam-columns and flexibly-connected frames is conducted. Specifically, solution techniques are formulated to predict the nonlinear behavior of cross sections, spatial beam-columns, and nonsway plane frames under the combined influence of imperfections, flexible connections, and nonproportional loads. A set of new inelastic slope-deflection equations for imperfect members are derived and their use illustrated through in-depth studies of flexibly-connected portal and two-bay two-story frames. These equations are derived from a system of nonlinear ordinary differential equations. The member studies are carried out using a second-order finite-difference solution to a set of …

Irish Building Services News

Building Services Engineering

No abstract provided.

Irish Building Services News

Building Services Engineering

No abstract provided.