Petroleum Engineering Commons^™

Application Of Benchtop Humidity And Temperature Chamber In The Measurement Of Water Vapor Sorption In Us Shales From Mancos, Marcellus, Eagle Ford And Wolfcamp Formations, Hesham Abdulelah, Berihun Mamo Negash, Atta Dennis Yaw, Tareq M. Al-Shami, Ahmed Al-Yaseri, Eswaran Padmanabhan

Research outputs 2022 to 2026

A benchtop humidity and temperature chamber was used to assess water vapor sorption in four US shale samples at 90 °C. Water sorption isotherms were measured at relative humidity ranging from 10 to 99% and temperature of 90 °C. Shale fractal properties were then evaluated, and capillary pressure (ranging from 1.70 to 386 MPa) was obtained using Kelvin relationship. The results show that Mancos shale, from the US, adsorbed more absorbed water due to its high clay concentration and low TOC. However, Wolfcamp shale, from the US, has the lowest TOC and clay concentration, adsorbing the lowest amount of water. …

A Systematic Multiscale Investigation Of Nanoparticle-Assisted Co2 Enhanced Oil Recovery (Eor) Process For Shale Oil Reservoirs, Dayo A. Afekare

LSU Doctoral Dissertations

Shale oil reservoirs are prolific on the short term due to hydraulic fracturing and horizontal drilling but experience significant production decline, leading to poor ultimate recovery and leaving billions of barrels of oil buried in the ground. In this study, a systematic multi-scale investigation of an enhanced oil recovery (EOR) process using relatively inexpensive silicon dioxide nanoparticles and carbon dioxide for shale oil reservoirs was conducted. Using the Tuscaloosa Marine Shale (TMS) as a case study, aqueous dispersions of nanosilica in conjunction with CO₂ were investigated at nano-to-core scales. At the nanoscale, atomic force microscope was used to investigate …

Impact Of Natural Fracture Induced Elastic Anisotropy On Completion And Hydraulic Fracturing Designs, Emre Can Dundar

Graduate Theses, Dissertations, and Problem Reports (ETD)

Shale has been usually recognized as a transverse isotropic (TI) medium in conventional geomechanical log interpretation due to its laminated nature. However, when natural fractures (NFs) exist in the rock body, additional elastic anisotropy can be introduced, converting Shale to an orthorhombic (OB) medium. Previous study illustrates that treating the naturally fractured shale rock as a TI medium by ignoring the NF-induced anisotropy can cause the erroneous estimation of the geomechanical properties (i.e. Young’s modulus, Poisson’s ratio, brittleness index, and etc.) and in-situ stress. In this paper, the study is extended to quantify the impact of NF-induced elastic anisotropy on …

Investigating The Performance Of High Viscosity Friction Reducers Used For Proppant Transport During Hydraulic Fracturing, Mohammed Salem Ba Geri

Doctoral Dissertations

"Over the last few recent years, high viscosity friction reducers (HVFRs) have been successfully used in the oil and gas industry across all premier shale plays in North America including Permian, Bakken, and Eagle Ford. However, selecting the most suitable fracture fluid system plays an essential role in proppant transport and minimizing or eliminating formation damage.

This study investigates the influence of the use of produced water on the rheological behavior of HVFRs compared to a traditional linear guar gel. Experimental rheological characterization was studied to investigate the viscoelastic property of HVFRs on proppant transport. In addition, the successful implication …

Diagenesis And Formation Stress In Fracture Conductivity Of Shaly Rocks; Experimental-Modelling Approach In Co2-Rock Interactions, Abiola Olukola Olabode

LSU Doctoral Dissertations

In large scale subsurface injection of carbon dioxide (CO₂) as obtainable in carbon sequestration programs and in environmentally friendly hydraulic fracturing processes (using supercritical CO₂), long term rock-fluid interaction can affect reservoir and seal rocks properties which are essential in monitoring the progress of these operations. The mineralogical components of sedimentary rocks are geochemically active particularly under enormous earth stresses, which generate high pressure and temperature conditions in the subsurface. While geomechanical properties such as rock stiffness, Poisson’s ratio and fracture geometry largely govern fluid flow characteristics in deep fractured formations, the effect of mineralization can …

Experimental Investigation Of Fracture Width Limitations Of Granular Lost Circulation Treatments, Mortadha Al-Saba, Runar Nygaard, Arild Saasen, Olav Magnar Nes

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

Drilling fluid losses into fractured shales is a major challenge. Lost circulation treatments are widely applied to mitigate the losses; however, the effectiveness of these treatments is affected by different physical properties of the used lost circulation materials (LCM). This paper presents an experimental investigation to study the effect of LCM type, concentration, particle size distribution, temperature, and LCM shape on the formed seal integrity, with respect to differential pressure, at different fracture widths. The overall objective of this study is to address the effectiveness of LCM treatments in sealing fractured shales, with specific application to the over consolidated Barents …

Analytical Modeling And Diagnosis Of Penetration Rate Performance Of Pdc Bits, Reza Rahmani

LSU Doctoral Dissertations

The high cost of drilling deep (15000+ ft) wells, due to slow rate of penetration (ROP) at depth, has severely limited the utilization and economic significance of deep hydrocarbon resources. The overall objective of this study was to obtain a better understanding of the major cause(s) of slow ROP in deep drilling. An analysis of field data demonstrated the impact of the problem and identified shale and limestone as the primary lithologies where slow ROP occurs at depth. Previous researchers have concluded that interactions between rock, drilling fluid, cuttings, and the bit control ROP. More specifically, several researchers have concluded …

Log-Derived Cation Exchange Capacity Of Shaly Sands : Application To Hydrocarbon Detection And Drilling Optimization, Gamze Ipek

LSU Doctoral Dissertations

Researchers at Louisiana State University, LSU, have introduced several petrophysical models expressing the electric properties of shaly sands. These models, to be used for hydrocarbon detection, are based on the Waxman and Smits concept of supplementing the water conductivity with a clay counterions conductivity. The LSU models also utilize the Dual Water theory, which relates each conductivity term to a particular type of water, free and bound, each occupying a specific volume of the total pore space. The main difference between these models and the other shaly sand models is that the counterion conductivity is represented by a hypothetical sodium …

Methods For Predicting Shale Durability In The Field, Paul Michael Santi, Jerry D. Higgins

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

Durability of shales and other weak rock is an important parameter describing the material's susceptibility to breakdown upon exposure to water or during construction work. While laboratory methods have been developed to measure durability, no correlations between laboratory results and simple field tests have been determined. The results of this study show that certain field parameters can predict slake durability with acceptable accuracy. The recommended field tests, in order of desirability, are slake index, jar slake, hammer rebound, and NGI "Q" value. Single variable and multiple variable linear regression equations are given, including equations conservatively modified so that 95% of …