Petroleum Engineering Commons^™

The Effect Of Different Fracturing Fluids On The Productivity Of Multi-Staged Fractured Marcellus Shale Horizontal Wells, Vida Gyaubea Matey-Korley

Graduate Theses, Dissertations, and Problem Reports (ETD)

While hydraulic fracturing has undeniably improved the production from oil and gas reservoirs, this technology is not without limitations. The primary hurdles lie in the areas of proppant transport, fluid rheology, and stress management. Despite the extensive research conducted in this domain, there remains a considerable amount of work to be done for comprehensive solutions that account for the complex interactions among fracturing fluid, proppant distribution, and geomechanical conditions. Achieving this will then make room for a holistic and efficient hydraulic fracturing strategy.

This study addresses the above-mentioned problem by examining the impact of fluid type on proppant transport and …

Fundamentals Of Microgel Flooding And Nanoparticles-Stabilized Foams In Enhanced Oil Recovery, Shuaijun Li

Dissertations and Theses

For centuries oil has remained a critical energy source for human civilization. After years of extraction, many oil fields have reached or are reaching a decline stage of production, even though up to a half of the total crude oil reserves in these fields has not been recovered yet. One reason is due to the structural heterogeneity of the oil reservoirs—reservoirs may consist of regions of higher permeability with larger pore size and regions of lower permeability with smaller pore size. Displacing fluids tend to flow through large permeability zones only without reaching the oil trapped in low permeability region; …

Droplets In An Electric Field: Surface Rheology, Coalescence And Rebound, Yu Han

Dissertations and Theses

Electrocoalescence is the process in which pairs of conducting droplets suspended in a continuous dielectric (nonconducting) liquid phase are drawn together and merge upon the application of an electric field. The electric field polarizes each of the droplets in the field direction. The polarization causes the drops to deform and drives a dipolar attraction which forces them to approach each other and coalesce. Many technologies use electric fields to manipulate fluid dispersions. Electrocoalescence is an essential unit operation for separating water droplets in a crude oil. This water in oil emulsion is stabilized by surfactants, such as asphaltenes, resins and …

The Desorption Kinetics Of Methane From Nonaqueous Fluids For Enhanced Well Control, James Lee Nielsen Jr.

LSU Master's Theses

The mass transfer of a dissolved gas evolving to return to the gaseous phase from a liquid is governed by many parameters. This process affects the development of an oil and gas well due to the possibility of gas contamination occurring from either an influx entering the wellbore, or drilling through gas-bearing formations. Once this dissolved hydrocarbon gas circulates up the wellbore, it will begin to evolve from solution and poses a potential risk to drilling equipment, the environment, and personnel at a drilling rig. Being able to predict the behavior of gas desorption based on a known set of …

Void Fraction Measurements In Large (0.3 M) Diameter Bubble Column Using Wire Mesh Sensor And Pressure Transducers- Effect Of Sparger, Afolabi Gabriel Ojo

Dissertations and Theses

The importance of the accurate temporal and spatial measurements of the two-phase flow parameters in bubble columns is very well known. The aim of this research work is to report the spatial measurements of the void fraction distribution in a 30 cm diameter cylindrical bubble column using Wire Mesh Sensor (WMS) tomography and Pressure Transducers. Pair of WMS sensors, with a 64×64 wire configuration of each sensor, were installed which are separated by a distance along the axis of the bubble column. Wire Mesh Sensors and PTs Data were collected for time-averaged and transient with a sampling frequency of 1000 …

Gas Hold-Up Measurements In 0.3 M Diameter Bubble Column: Effect Of Electrolytes, Heber Blanco De Brand

Dissertations and Theses

The present work reports the axial, radial and temporal gas hold-up profiles in a 0.3 m diameter batch bubble column using a pair of Wire Mesh Sensors and six pressure transducers.

Experimental And Numerical Investigation Of Liquid-Assisted Gas-Lift Unloading, Renato Peixoto Coutinho

LSU Doctoral Dissertations

The case for a unique form of gas-lift unloading, termed “Liquid-Assisted Gas-Lift (LAGL),” is presented. This work demonstrates that the injection of a gas-liquid mixture allows transport of gas to a deep injection point utilizing injection pressure considerably lower than single-phase gas injection. The LAGL is demonstrated in a 2,880 ft deep test well. The test well is kicked-off using an injection pressure that would normally be lower than the pressure for single-point single-phase gas injection at this depth. Experimental results indicate that the LAGL can lower the injection pressure by up to 75%.

This work breaks the LAGL system …

Mobility Of Nano-Particles In Rock Based Micro-Models, Jagannath Upadhyay

LSU Doctoral Dissertations

A confocal micro-particle image velocimetry (C-μPIV) technique along with associated post-processing algorithms is detailed for obtaining three dimensional distributions of nano-particle velocity and concentrations at select locations of the 2.5D (pseudo 3D) Poly(methyl methacrylate) (PMMA) and ceramic micro-model. The designed and fabricated 2.5D micro-model incorporates microchannel networks with 3D wall structures with one at observation wall which resembles fourteen morphological and flow parameters to those of fully 3D actual reservoir rock (Boise Sandstone) at resolutions of 5 and 10 μm in depth and 5 and 25 μm on plane. In addition, an in-situ, non-destructive method for measuring the geometry of …

Pore-Scale Analysis Of Interfacial Instabilities And Impact Of Heterogeneity On Relative Permeability By Lattice Boltzmann Method, Zhipeng Zhu

LSU Master's Theses

Interfacial instabilities occur often during immiscible fluid flow through porous media and their understanding is essential for waterflooding operations or other oil recovery processes. Although many studies including experimental and numerical have been done to reproduce and analyze the interfacial instabilities in porous median, there is still significant knowledge gap in fundamental understanding of these flow instabilities at the pore-scale. In order to better understand the interfacial instabilities phenomenon, the pore-scale simulations are performed. In this study, Lattice Boltzmann Method is used to simulate two different types of interfacial instabilities: viscous fingering and capillary fingering in irregular sphere packs by …

High-Temperature, High-Pressure Viscosities And Densities Of Toluene, Aaron J. Rowane

Theses and Dissertations

High-temperature, high-pressure (HTHP) conditions are exemplified in ultra-deep petroleum reservoirs and can be exhibited within diesel engines. Accurate pure component hydrocarbon data is essential in understanding the overall behavior of petroleum and diesel fuel at these conditions. The present study focuses on the HTHP properties of toluene since this hydrocarbon is frequently used to increase the octane rating of gasoline and toluene occurs naturally in crude oil. In this thesis experimental densities and viscosity are presented to 535 K and 300 MPa extending the database of toluene viscosity data to higher temperature than previous studies. The data is correlated to …

Coalescence-Induced Jumping Of Droplet: Inertia And Viscosity Effects, Samaneh Farokhirad, Jeffrey F. Morris, Taehun Lee

Publications and Research

The problem of coalescence-induced self-propelled jumping of droplet is studied using three-dimensional numerical simulation. The focus is on the effect of inertia and in particular the effect of air density on the behavior of the merged droplet during jumping. A lattice Boltzmann method is used for two identical, static micro-droplets coalescing on a homogeneous substrate with contact angle ranging from 0◦ to 180◦. The results reveal that the effect of air density is significant on detachment of the merged droplet from the substrate at the later stage of the jumping process; the larger the air density, the larger the jumping …