Petroleum Engineering Commons^™

Upcycling Waste To Wealth: Cuo-Sio₂/Reduced Graphene Nanocomposite From Pomegranate Peels For One-Pot Low-Temperature Conversion Of Waste Oils Into Valuable Fatty Acid Monomers, Attia Attia, Shahenda Mahran Dr., Maria Centeno Prof., Basudeb Saha

Petroleum Engineering and Gas

and hence reduce the price of the fatty acid monomers. This study reports for the first time a novel, environmentally benign, highly active copper oxide-silica oxide/reduced graphene oxide (CuO-SiO2/RGO), heterogeneous nano-catalyst derived from waste pomegranate peels, for the one-pot, low-temperature synthesis of fatty acid monomers from high-acid-value waste vegetable oil (WVO). The synthesised nano-catalyst was extensively characterised using XRD, FT-IR, TEM, SEM, EDX and TGA-DTA. Further, it was utilised to synthesise fatty acidrich oleic phenoxypropyl acrylate (OPA) monomer from high acid value WVO via a single-step reaction.

Rheological, Interfacial, And Filtration Behavior Of Lignocellulosic Nanomaterials In Suspension And Emulsion Drilling Fluids, Meen Sung Koo

LSU Doctoral Dissertations

In recent years, the rheological aspects of suspensions/emulsions applied by cellulose nanomaterials (CNMs) have been gained considerable interests due to high gel-forming properties ascribed by hydrophilicity, crystallinity, ease functionalization, and high aspect ratio. Introducing residual lignin in CNMs (LCNMs) seemed to be capable of achieving various advantages in the application of CNMs ascribed by hydrophobicity, binding effects, and abundant aromatic groups derived from complexity of lignin. This dissertation dedicates to the characterizations of (L)CNMs, and rheological properties of (L)CNMs applied fluids (i.e., suspension and emulsion). In the suspension system, the presence of lignin in LCNMs decreased gel strength, viscosity, and …

Experimental Study For Improving Oil Recovery Using Organic Alkaline And Nano-Silica For An Egyptian Oil Field, Attia Attia, Mohamed Sadek Hamedi Al, Mayar Abdelrahman Hassan Eng.

Petroleum Engineering and Gas

The oil and gas industry continually seeks innovative methods to enhance hydrocarbon recovery due to the declining productivity of conventional techniques. Current recovery methods, such as water flooding and chemical flooding, often face limitations like high interfacial tension, unfavorable wettability, and reduced mobility of oil, especially under harsh reservoir conditions of high salinity. To address these challenges, this study explores the implementation of nanotechnology in enhanced oil recovery (EOR), focusing on the distinct and unique properties of nanoparticles. Nanoparticles, particularly SiO2, were chosen for their ability to significantly decrease interfacial tension, alter wettability, and improve oil mobility. SiO2 nanoparticles exhibit …

A Comparative Study On Natural Vs. Synthesized Polymers Combined With Silica Nanoparticles To Maximize Secondary Oil Recovery, Attia Attia, Mohamed Sadek Hamedi Al, Waleed Abd-Alsabour Ali Eng., Zeyad Tamer Elshony Eng.

Petroleum Engineering and Gas

Polymer flooding is a well-established technique for enhancing oil recovery from reservoirs. In this study, we investigate the performance of two different polymers, Xanthan Gum, and HPAM for secondary oil recovery in the sand pack. The effects of polymer concentration and high salinity on oil recovery are studied. The polymers are characterized using various measurements and tests, including viscosity, shear rate, and interfacial tension. The sand pack flooding experiments are conducted under various conditions, including varying polymer slugs, and nanosilica (silicon dioxide SiO2) concentration. The results are analyzed to determine the optimal conditions for polymer flooding for enhanced oil recovery. …

Cfd Study On Two-Phase Flow Patterns In A Pipe With 90º Elbow In Different Operating Conditions, Hagar Alm-Eldin Bastawissi, Mohammed Ahmed Khafagy, E. A. El Shenawy Prof. Dr., Ahmed M. Salem Dr

Journal of Engineering Research

Recently, CFD has offered a technological solution for modelling multi-phase flow in which we can make endless simulations with reduced expenses and effort in high accuracy results; we shall also mention that experimental studies have limitations for safety considerations when experimenting with flow in high temperature or pressure values or medium nature as in nuclear or chemical flows.In this paper, we used the ANSYS FLUENT CFD program to simulate the two-phase flow in a pipe to study the effect of attaching a 90-degree elbow fitting to the piping system, seeking to find out the change in the pattern and resulting …

Enhancing Pipeline Simulations Through Artificial Intelligence And Machine Learning: A Smart Proxy Modelling Approach, Afeez Shittu

Graduate Theses, Dissertations, and Problem Reports (ETD)

ABSTRACT

Enhancing pipeline simulations is essential for improving operational efficiencies and effectively managing risks in the oil and gas industry. Traditional pipeline simulators, relying heavily on mathematical modeling assumptions, often face limitations due to their high energy and computational demands. This thesis addresses these challenges by introducing an innovative approach that integrates artificial intelligence (AI) and machine learning (ML) through a smart proxy model, offering a more efficient, cost-effective, and flexible alternative to conventional full-physics models used in pipeline simulation software.

The primary aim of this research is to develop and implement a smart proxy model capable of accurately predicting …

The Effect Of Different Fracturing Fluids On The Productivity Of Multi-Staged Fractured Marcellus Shale Horizontal Wells, Vida Gyaubea Matey-Korley

Graduate Theses, Dissertations, and Problem Reports (ETD)

While hydraulic fracturing has undeniably improved the production from oil and gas reservoirs, this technology is not without limitations. The primary hurdles lie in the areas of proppant transport, fluid rheology, and stress management. Despite the extensive research conducted in this domain, there remains a considerable amount of work to be done for comprehensive solutions that account for the complex interactions among fracturing fluid, proppant distribution, and geomechanical conditions. Achieving this will then make room for a holistic and efficient hydraulic fracturing strategy.

This study addresses the above-mentioned problem by examining the impact of fluid type on proppant transport and …

Fundamentals Of Microgel Flooding And Nanoparticles-Stabilized Foams In Enhanced Oil Recovery, Shuaijun Li

Dissertations and Theses

For centuries oil has remained a critical energy source for human civilization. After years of extraction, many oil fields have reached or are reaching a decline stage of production, even though up to a half of the total crude oil reserves in these fields has not been recovered yet. One reason is due to the structural heterogeneity of the oil reservoirs—reservoirs may consist of regions of higher permeability with larger pore size and regions of lower permeability with smaller pore size. Displacing fluids tend to flow through large permeability zones only without reaching the oil trapped in low permeability region; …

Droplets In An Electric Field: Surface Rheology, Coalescence And Rebound, Yu Han

Dissertations and Theses

Electrocoalescence is the process in which pairs of conducting droplets suspended in a continuous dielectric (nonconducting) liquid phase are drawn together and merge upon the application of an electric field. The electric field polarizes each of the droplets in the field direction. The polarization causes the drops to deform and drives a dipolar attraction which forces them to approach each other and coalesce. Many technologies use electric fields to manipulate fluid dispersions. Electrocoalescence is an essential unit operation for separating water droplets in a crude oil. This water in oil emulsion is stabilized by surfactants, such as asphaltenes, resins and …

Scale Model Equations And Optimization For Annular Flow Of Non-Newtonian Fluids Between Eccentric And Rotating Cylinders, Wei Zhang, Pooya Khodaparast, Amin Mehrabian Dr., Amir Shojaei

Progress in Scale Modeling, an International Journal

A broad range of engineering applications involves helical flow of non-Newtonian fluids between two eccentric cylinders. These applications often require estimation of the frictional pressure losses along the axes of the cylinders. Laboratory flow loops are commonly used to study the flow characteristics at smaller scales of investigation. This study uses the laws of similarity and dimensional analysis to obtain a set of scaling equations between the laboratory and prototype scales of the described annular flow. These equations are derived for four types of fluid rheology including Newtonian, power-law, Bingham-plastic, and yield power-law.

Results are expressed through a set of …

Investigative Study Of Microalgal And Electrochemical Wastewater Treatment Systems And Modeling Of The Wafer-Enhanced Electrodeionization Using Supervised Learning, Humeyra Betul Ulusoy Erol

Graduate Theses and Dissertations

Wastewater has a serious impact on environment and public health due to its high concentration of nutrients and toxic contaminants. Without proper treatment, excess nutrients discharged in wastewater can cause a damage to the ecosystem such as undesirable pH shifts, cyanotoxin production, and low dissolved oxygen concentrations.

Main objectives of this dissertation work were to investigate i) the biofuel potential of P. cruentum when grown in swine wastewater, ii) the influence of four most commonly used ion exchange resins on the system efficiency and selectivity for the removal of sodium, calcium, and magnesium ions, and iii) the modeling of wafer-enhanced …

An Improved Foam Modeling Technique And Its Application To Petroleum Drilling And Production Practice, Yanfang Wang

LSU Doctoral Dissertations

Foam is one of the most common used multiphase fluid in Underbalanced Drilling (UBD) and Managed Pressure Drilling (MPD). Because of its low density, high capacity of lifting and carrying cuttings, low cost and compatibility with formations, foam has become more superior than the conventional drilling mud when depleted reservoir pressure, severe lost circulation, or unstable borehole are encountered. In general, the success of foam applications rely on the understanding of the fundamentals of foam rheology in downhole conditions.

Foam rheology has been studied for decades. Conventional foam rheological models such as Power Law, Bingham Plastic, Herschel-Bulkley to explain foam …

Microfluidic Study Of The Electrocoalescence Of Aqueous Droplets In Crude Oil, Thomas Leary, Mohsen Yeganeh, Charles Maldarelli

Publications and Research

In electrocoalescence, an electric field is applied to a dispersion of conducting water droplets in a poorly conducting oil to force the droplets to merge in the direction of the field. Electrocoalescence is used in petroleum refining to separate water from crude oil and in droplet-based microfluidics to combine droplets of water in oil and to break emulsions. Using a microfluidic design to generate a two-dimensional (2D) emulsion, we demonstrate that electrocoalescence in an opaque crude oil can be visualized with optical microscopy and studied on an individual droplet basis in a chamber whose height is small enough to make …

The Desorption Kinetics Of Methane From Nonaqueous Fluids For Enhanced Well Control, James Lee Nielsen Jr.

LSU Master's Theses

The mass transfer of a dissolved gas evolving to return to the gaseous phase from a liquid is governed by many parameters. This process affects the development of an oil and gas well due to the possibility of gas contamination occurring from either an influx entering the wellbore, or drilling through gas-bearing formations. Once this dissolved hydrocarbon gas circulates up the wellbore, it will begin to evolve from solution and poses a potential risk to drilling equipment, the environment, and personnel at a drilling rig. Being able to predict the behavior of gas desorption based on a known set of …

Effect Of Surfactant, Oil:Water Ratio And Temperature On The Rheology Of Emulsion-Suspension Complex Fluids: Implications For Oil-Based Drilling Fluids, Gilles Landry Numkam

LSU Doctoral Dissertations

Drilling fluids are non-Newtonian mixtures that play a critical role in the timely and successful completion of oil and gas wells. In the particular case of offshore operations, proper design of drilling fluids is of paramount importance in the constant quest to lower break-even prices. Most downhole problems are directly or in-directly related to the rheological and physical properties of drilling fluids, thereby calling for a better understanding of the underlying changes of these properties with respect to drilling fluid composition and external conditions.

The current stance in the design of drilling fluids involves the selection of components and their …

Mobility Of Nano-Particles In Rock Based Micro-Models, Jagannath Upadhyay

LSU Doctoral Dissertations

A confocal micro-particle image velocimetry (C-μPIV) technique along with associated post-processing algorithms is detailed for obtaining three dimensional distributions of nano-particle velocity and concentrations at select locations of the 2.5D (pseudo 3D) Poly(methyl methacrylate) (PMMA) and ceramic micro-model. The designed and fabricated 2.5D micro-model incorporates microchannel networks with 3D wall structures with one at observation wall which resembles fourteen morphological and flow parameters to those of fully 3D actual reservoir rock (Boise Sandstone) at resolutions of 5 and 10 μm in depth and 5 and 25 μm on plane. In addition, an in-situ, non-destructive method for measuring the geometry of …

A Study On The Heavy Crude Oil Viscosity Reduction With The Dissolution Of Nitrogen And Carbon Dioxide, Abdurahman Ajumobi

Dissertations and Theses

World's energy challenges would be greatly improved upon if half of the world's heavy oil and extra heavy oil could be made to ow in pipelines. Viscosity reduction of heavy oils is the key to solving this problem. In this study, aside from injecting pure nitrogen and pure carbon dioxide separately into the oil, two different compositions of the mixture of the two gases were also injected. In the first mixture, varied quantities of the two gases were used; 62:5%, 82:2% and 86:4% of the mixture was nitrogen while 37:5%, 17:8% and 13:6% was carbon dioxide at total test pressures …

Coalescence-Induced Jumping Of Droplet: Inertia And Viscosity Effects, Samaneh Farokhirad, Jeffrey F. Morris, Taehun Lee

Publications and Research

The problem of coalescence-induced self-propelled jumping of droplet is studied using three-dimensional numerical simulation. The focus is on the effect of inertia and in particular the effect of air density on the behavior of the merged droplet during jumping. A lattice Boltzmann method is used for two identical, static micro-droplets coalescing on a homogeneous substrate with contact angle ranging from 0◦ to 180◦. The results reveal that the effect of air density is significant on detachment of the merged droplet from the substrate at the later stage of the jumping process; the larger the air density, the larger the jumping …

Measurements And Modeling Of Hydrocarbon Mixture Fluid Properties Under Extreme Temperature And Pressure Conditions, Babatunde A. Bamgbade

Theses and Dissertations

Knowledge of thermodynamic fluid properties, such as density and phase behavior, is important for the design, operation, and safety of several processes including drilling, extraction, transportation, and separation that are required in the petroleum. The knowledge is even more critical at extreme temperature and pressure conditions as the search for more crude oil reserves lead to harsher conditions. Currently, there is dearth of experimental data at these conditions and as such, the predictive capability of the existing modeling tools are unproven. The objective of this research is to develop a fundamental understanding of the impact of molecular architecture on fluid …