Other Chemical Engineering Commons^™

Fluidization Characteristics Of Group C+ Particles: Fine Powder With Nanoparticle Modulation, Yandaizi Zhou

Electronic Thesis and Dissertation Repository

Geldart Group C particles become increasingly attractive in industry because of their small particle sizes and large specific surface areas. The main challenge in the flow and fluidization of Geldart Group C particles is their cohesive nature due to strong interparticle forces. The “nanoparticle modulation” technique was adopted to reduce the interparticle forces of Group C particles and thus significantly improved their flow and fluidization quality. Group C⁺ particles, a new type of fine particles with drastically reduced or insignificant interparticle forces, were created using the nano-modulation technique.

Fundamental studies provided a comprehensive understanding of the fluidization quality of …

Bubble Dynamics In A Sand Fluidized Bed In The Presence Of Biomass Pellets, Nicolas Torres Brauer

Electronic Thesis and Dissertation Repository

Given the worldwide concerns regarding fossil fuel availability, global warming, water, and air pollution and economy needs, there is an urgent requirement to develop and implement alternative energies. Biomass gasification can consume vegetal waste to produce syngas, which is a mix of carbon monoxide, hydrogen, and carbon dioxide. When biomass gasification is carried out in a fluidized bed, the process is highly efficient.

The experimental study of the present Ph.D. dissertation took place in a Plexiglas 0.44 m diameter unit, equipped with a CREC Optiprobe system and a video camera. The unit was filled with 200-900 µm sand particles and …

Improvement Of Fluidization Ability For Group A Powders By Fine Powder Additives, Xiaowei Zhang

Electronic Thesis and Dissertation Repository

Group A powders are widely utilized in the industry because of the great quality of fluidization, which can be affected by the fine content. This project investigates the feasibility that employing the fine powders (≤ 20 μm) as additives to further improve the fluidization ability of Group A powders. Three additives, Coal-15, GB-6, and SiO₂-5 are added into FCC-76, based on various volume fractions. The minimum fluidization velocity (U_mf), bed expansion ratio (BER), and dense phase expansion ratio (DER) are tested to evaluate the quality of fluidization. Coal-15 can slightly improve the fluidization quality. High …

Numerical Investigations Of Bubble Column Equipped With Vertical Internals In Different Arrangements, Tuntun Gaurav

Electronic Thesis and Dissertation Repository

Bubble columns are multiphase contactors with wide applications in industrial processes. Often they are equipped with longitudinal tube bundles to facilitate heat exchange. Studying effects of these internals on column hydrodynamics is vital for the design of these internals. Computational Fluid Dynamic (CFD) simulations provide an understanding of the complex two-phase flow enabling the study of the effects of the internals on the column hydrodynamics. In the present work, an Eulerian-Eulerian based two-fluid model (TFM) coupled with a population balance model (PBM) is used to simulate the gas-liquid two-phase flows in bubble columns. The models studied were validated using experimental …

Fabrication And Modification Of Titania Nanotube Arrays For Harvesting Solar Energy And Drug Delivery Applications, Ahmed El Ruby Abdel Rahman Mohamed

Electronic Thesis and Dissertation Repository

The fast diminishing of fossil fuels in the near future, as well as the global warming caused by increasing greenhouse gases have motivated the urgent quest to develop advanced materials as cost-effective photoanodes for solar light harvesting and many other photocatalytic applications. Recently, titania nanotube arrays (TNTAs) fabricated by anodization process has attracted great interest due to their excellent properties such as: high surface area, vertically oriented, highly organized, one-dimensional, nanotubular structure, photoactivity, chemical stability and biocompatibility. This unique combination of excellent properties makes TNTAs an excellent photoanode for solar light harvesting. However, the relatively wide band gap energy of …

Hydrodynamics In The Gas-Driven Inverse Liquid-Solid Fluidized Bed, Jiaqi Huang

Electronic Thesis and Dissertation Repository

A novel reactor named Gas-Driven Inverse Liquid-Solid Fluidized Bed (GDFB for short) was developed in this research. A vertical baffle divides the column into a riser and a downer. Inverse fluidization is driven by the gas and occurs in the downer, where hydrodynamics and their influencing factors were studied. In the solid-baffle system, four fluidization regimes were observed, including the packed bed, semi-fluidized bed, fully-fluidized bed, and circulating bed. Bed expansion ratio was higher for particles with a higher density and a smaller solids loading. Moreover, the average particle velocity was proportional to superficial gas velocity and higher for denser …

Catalytic Conversion Of Fructose, Glucose And Industrial Grade Sugar Syrups To 5-Hydroxymethylfurfural, A Platform For Fuels And Chemicals, Sadra Souzanchi

Electronic Thesis and Dissertation Repository

5-hydroxymethylfurfural (HMF) as a versatile and polyfunctional compound derived from dehydration of biomass has attracted increasing attentions in research over the past decades. HMF is an important intermediate and platform chemical, which can be converted into different useful chemicals as well as the promising biofuels. It can be obtained from acid-catalyzed dehydration of different C₆-based carbohydrates such as glucose, fructose, sucrose and cellulose.

In this thesis, a cost-effective process for catalytic conversion of simple sugars (particularly glucose and fructose) and industrial grade sugar syrups to HMF was studied in a novel biphasic continuous-flow tubular reactor using inexpensive heterogeneous …

Microwave And Ultrasound Assisted Zeolitization Of Coal Fly Ash, Syed Salman Raza Bukhari

Electronic Thesis and Dissertation Repository

Coal fly ash (CFA) is a major bi-product of coal fired power plants and is a liability for coal power industry. Coal fly ash has been accumulating rapidly around the globe and has been known to be accident prone, resulting in $1.65 billion in clean-up costs and fines. Given the environmental damage CFA is capable of causing, it is a great interest for scientists to recycle this material. Utilization of novel energy such as microwave and ultrasound has been of research interest for the zeolitization of coal fly ash.

This research produced zeolites from CFA utilizing microwave and ultrasound power. …

Visible Light Driven Photocatalysis For Degradation Of Diclofenac, Noshin Hashim

Electronic Thesis and Dissertation Repository

Diclofenac (DCF), a widely used non-steroidal anti-inflammatory drug (NSAID), is a commonly detected substance that readily accumulates in tissues of aquatic fish and poses a threat to wildlife and freshwater quality. Advanced Oxidation Processes (AOPs) have been explored as an alternative method for complete mineralization of DCF as conventional treatment methods are inadequate for treatment of trace contaminants.

This study employs a semi-batch, swirl-flow, monolithic type photocatalytic reactor to determine intrinsic kinetic parameters of DCF mineralization, in an immobilized system under both UV and visible radiation. The goal of this work to determine true kinetics of DCF, after correcting for …

Application Of Mechanically Fluidized Reactors To Lignin Pyrolysis, Valentina Lago

Electronic Thesis and Dissertation Repository

Lignin has great potential for the production of aromatics currently derived from petroleum, since it is the most abundant source of aromatics in nature. At present, Kraft lignin is used as fuel within the pulping process but, alternatively, it could be converted to high-value chemicals using thermochemical processes such as pyrolysis. Kraft lignin, however, is a very cohesive and thermally sensitive powder with foaming and agglomerating tendency under reaction conditions. Therefore, new reactor designs are necessary to efficiently process this raw material.

Consequently, a novel reactor design, designated as Mechanically Fluidized Reactor (MFR) has been developed to successfully process Kraft …

Optimisation Of The Transesterification Stage Of Biodiesel Production Using Statistical Methods, Arnold Paintsil

Electronic Thesis and Dissertation Repository

The present research examines solely the transesterification stage of the biodiesel production process. Six process variables that affect the yield of biodiesel at this stage are examined using the 12 run Plackett-Burman Design. To study the effect of FFA[1] and to replicate real life situations where oil (feedstock) contain varying amounts of FFA, linoleic acid is used as FFA and intentionally added to high oleic acid canola oil containing less than 0.07% FFA. The process is catalyzed with potassium carbonate and evaluated at varying temperatures, stirring rates, reaction times and methanol oil ratios. The yields at the end of …

Liquid Distribution From Industrial Scale Spray Jets In Fluidized Beds, Mohammadali Zirgachianzadeh

Electronic Thesis and Dissertation Repository

Liquid injections via spray nozzles are used in fluidized bed reactors such as Fluid Cokers. In such industrial processes, in order to maximize the product yields it is required to optimize the performance of the nozzle. Moreover parts of the bed might become defluidized, bogged, due to high liquid load. Then optimizing the performance of the nozzle and local bed bogging detection is the primary research objectives for this thesis work.

The first part of the research work was focused on developing a novel method employing electrical conductance to characterize the liquid distribution in a large scale fluid bed of …