Open Access. Powered by Scholars. Published by Universities.®

Biochemical and Biomolecular Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Biochemical and Biomolecular Engineering

Bioremediation Of Refinery Desalter Effluent Using Debaryomyces Hansenii And Parachlorella Kessleri, Leila Azimian Oct 2019

Bioremediation Of Refinery Desalter Effluent Using Debaryomyces Hansenii And Parachlorella Kessleri, Leila Azimian

Electronic Thesis and Dissertation Repository

Crude oil desalting operations produce an effluent stream which is challenging to treat due to its salt, heavy metal and hydrocarbon content. Consequently, desalter effluent (DE) is usually diluted into other effluent streams and sent to conventional wastewater treatment plants which may lead to upsets the plant operation.

In this study, a novel microbial approach was applied which investigated DE treatment using halotolerant yeast Debaryomyces hansenii (LAF-3 10 U) or the environmentally robust micro-algae Parachlorella kessleri strain CPCC 266. The effect of these two different approaches on both synthetic and actual DE was investigated in both batch and/or continuous mode. …


Photobioreactor Design For Improved Energy Efficiency Of Microalgae Production, Alexander Burns Dec 2014

Photobioreactor Design For Improved Energy Efficiency Of Microalgae Production, Alexander Burns

Master's Theses

ABSTRACT

Photobioreactor Design for Improved Energy Efficiency of Microalgae Production

Alexander Burns

The objective of this research was to investigate a new photobioreactor (PBR) design for microalgae production that retains the typical advantages of existing tubular PBRs while reducing power consumption by providing simultaneous culture circulation and gas exchange with airlift alone and no centrifugal recirculating pump. Traditional tubular PBR designs feature a compressed air supply and a centrifugal pump for culture circulation and gas exchange. Circulation and gas exchange in a closed-system PBR is necessary to keep the algae suspended and to provide sufficient mass transfer (mainly for the …


Experimental & Empirical Correlations For The Determination Of The Overall Volumetric Mass Transfer Coefficients Of Carbon Dioxide In Stirred Tank Bioreactors, Syeda Anam Kazim Aug 2012

Experimental & Empirical Correlations For The Determination Of The Overall Volumetric Mass Transfer Coefficients Of Carbon Dioxide In Stirred Tank Bioreactors, Syeda Anam Kazim

Electronic Thesis and Dissertation Repository

One of the most important parameters to cultivate microalgae is carbon dioxide absorption by microalgae. Therefore, it is necessary to determine the overall volumetric mass transfer coefficient (KLa) of carbon dioxide to quantify CO2 transfer from the gaseous to the liquid phase. Until now, finding KLa of CO2 for microalgae cultivation has been a challenge as there is not much information available about it in the literature and most of the time the CO2 transfer to microalgae is approximated. In this study, correlations to directly calculate KLa of CO2 in …


Temperature Influence And Heat Management Requirements Of Microalgae Cultivation In Photobioreactors, Thomas Hagen Mehlitz Feb 2009

Temperature Influence And Heat Management Requirements Of Microalgae Cultivation In Photobioreactors, Thomas Hagen Mehlitz

Master's Theses

Microalgae are considered one of the most promising feedstocks for biofuel production for the future. The most efficient way to produce vast amounts of algal biomass is the use of closed tubular photobioreactors (PBR). The heat requirement for a given system is a major concern since the best algae growth rates are obtained between 25-30 °C, depending on the specific strain. A procedure to determine temperature influence on algal growth rates was developed for a lab-scale PBR system using the species Chlorella. A maximum growth rate of 1.44 doublings per day at 29 °C (optimal temperature) was determined. In addition, …