Bioresource and Agricultural Engineering Commons^™

Mechanical Fractionation Of Wheat Middlings For Application In Pyrolysis And Animal Feed, Okwudili I. Obiakor

Dissertations, Master's Theses and Master's Reports

Wheat middlings are grain byproducts that are underused for bioenergy production despite having a high lignocellulose content. Its use as a feedstock for catalytic pyrolysis depends on effective and sustainable fractionation to enhance efficiency and product yield. This study tested mechanical pre-fractionation (sieving and air classification) to reduce ash content of certain fractions to < 1% for catalytic pyrolysis and enrich nutrient levels of other fractions for feed applications. Wheat middlings were separated into 11 fractions using screen sizes from 106 µm to 1651 µm, and the composition of each fraction was characterized (ash, protein, structural carbohydrates, lignin, starch, and simple sugars). For cyclone separation, a full factorial design was used to study the effect of air velocity (15,18, 20 m/s) and feed rate (33, 35, 38 kg/h) on the amount of material collected in the underflow and overflow, and the composition of these fractions was characterized. Sieving showed a pronounced segregation of ash content, from 4.5% to 6.5% in wheat middlings fractions, with 5.7% being the lowest for coarse fractions which has higher lignocellulose content, and 4.5% in the fine fraction (150-212 µm). The same defined enrichment was observed in all nutrients except for protein. Starch enrichment zone were defined in the fine fractions (212 µm and below), for structural carbohydrates and lignin in the coarse fractions (600 µm and above), and for ash in coarse fractions (1180-1651 µm). In contrast, protein content was not significantly different between various fractions (p value=0.787). The fiber rich fraction (> 600 µm), suitable for pyrolysis, which have a composite ash value of 6.0% can be sorted and mixed with intermediate fractions to reduce ash to 5.3% and the remaining fractions rich in digestible nutrients used for animal feed formulation. Compared to sieving, cyclone separations did not …

Anaerobic Reductive Bioleaching Of Manganese Ores, Neha Sharma

Dissertations, Master's Theses and Master's Reports

Manganese extraction by biological methods is a green and economical way to produce manganese from low as well as high grade manganese ores. This is especially important for US ores, which are primarily either small in extent, low-grade with a high iron content, or both. They are therefore not suitable for conventional mining, which is very capital-intensive and requires a large up-front investment and are therefore imported at high costs. The goal is therefore to develop a process that can be applied at small scales, with minimal startup costs, and low equipment and labor requirements. It is also critical to …

Recovering And Upgrading Kraft Lignin For Application In Flexible Polyurethane Foam, Peng Quan

Dissertations, Master's Theses and Master's Reports

Lignin is the second abundant natural polymer and has been highlighted as a potential substitute for fossil-based raw materials. However, the inherent molecular heterogeneity and the complex recovery processes result in the challenge of controlling the molecular properties and value-added applications of lignin in large scale. To address those issues, a novel acid-liquefaction process was developed in this study to recover Kraft lignin with improved molecular homogeneity directly from black liquor.

In the first study, the liquefaction parameters were screened based on yield and molecular weight properties of the recovered lignin. Then, the recovered lignin samples were used to replace …

Use Of Lidar In The Design Of Grassed Waterways: Case Study In Agricultural Management In Oklahoma, Annette Sparks

Dissertations, Master's Theses and Master's Reports

Before the advent of Light Detection and Ranging (LiDAR) technology, farm-level infrastructure for sustainable agriculture was designed using topographic maps. LiDAR is a remote sensing method whereby reflected laser pulses are measured to generate high-resolution 3D images of the terrain. This report compares these two methods in the design of grassed waterways for flood drainage and evaluates how the quantitative difference between the two methods can affect the overall hydrologic design. The benefits of LiDAR are expected to be higher accuracy and precision in design, as well as greater reproducibility or consistency, regardless of the designer. To carry out this …

Experimental Investigation Of Fast Pyrolysis Of Arundo Donax In A Novel Paddle Reactor, Chintan Desai

Dissertations, Master's Theses and Master's Reports

The main objective of this research was to show the effectiveness of a novel paddle reactor for fast pyrolysis and study the effect of biomass particle size and reaction temperature of Arundo Donax a type of energy crop on the bio-oil yields. The novel paddle reactor showed effective mixing and heat transfer which were proved with the help of studying the residence time and the heating characteristics of the system respectively. The effect of different biomass particle sizes on the bio-oil yield was not significant, the bio-oil yield was approximately 50% for all the sizes. For Arundo Donax particle sizes …

Method Of Introducing A Plurality Of Genes Into Plants, Vincent Lee C. Chiang, Laigeng Li

Michigan Tech Patents

A method of concurrently introducing multiple genes to plants and trees is provided. The method includes an Agrobacterium-mediated gene delivery system by which multiple genes together with a single selectable marker gene are simultaneously transferred and inserted into the genome of plants, including trees.