Open Access. Powered by Scholars. Published by Universities.®

Navigation, Guidance, Control, and Dynamics Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 5 of 5

Full-Text Articles in Navigation, Guidance, Control, and Dynamics

An Empirical Study To Investigate The Effect Of Air Density Changes On The Dsrc Performance, Mostafa El-Said, Vijay Bhuse, Alexander Arendsen Oct 2017

An Empirical Study To Investigate The Effect Of Air Density Changes On The Dsrc Performance, Mostafa El-Said, Vijay Bhuse, Alexander Arendsen

Peer-Reviewed Publications

The primary role of Intelligent Transportation Systems (ITS) system is to implement Advanced Driver Assistance Services (ADAS) such as pedestrian detection, fog detection and collisions avoidance. These services rely on detecting and communicating the environment conditions such as heavy rain or snow with nearby vehicles to improve the driver's visibility. ITS systems rely on DSRC to communicate this information via a Vehicle-to-Vehicle (V2V) or Vehicle-to-Infrastructure (V2I) communications architectures. DSCR performance may be susceptible to environmental changes such as air density, gravitation (gravitational acceleration), air temperature, atmospheric pressure, humidity, and precipitation.

The goal of this research is to investigate whether the …


Dynamic Understeer Control Using Active Rear Toe, Mark Oliver Dixon Kaufman Apr 2017

Dynamic Understeer Control Using Active Rear Toe, Mark Oliver Dixon Kaufman

Doctoral Dissertations and Master's Theses

This thesis was conducted to show the ability of Active Rear Toe to control the understeer characteristics of a vehicle. Active rear toe is the ability to control the angle of the rear wheels around the vertical axis, allowing the car’s turning radius to change. By changing this radius, the lateral acceleration can be controlled, therefore the understeer of the vehicle can be controlled. The controls scheme is a sliding mode control, specifically a hyperbolic tangent boundary layer and a type 1 zeno controller. The system shows effectiveness to control the understeer of the vehicle up until limit grip on …


Utilizing Ground-Based Lidar Measurements To Aid Autonomous Airdrop Systems, Martin Cacan, Edward Scheuermann, Michael Ward, Mark Costello, Nathan Slegers Jan 2017

Utilizing Ground-Based Lidar Measurements To Aid Autonomous Airdrop Systems, Martin Cacan, Edward Scheuermann, Michael Ward, Mark Costello, Nathan Slegers

Faculty Publications - Biomedical, Mechanical, and Civil Engineering

Uncertainty in atmospheric winds represents one of the primary sources of landing error in airdrop systems. In this work, a ground-based LIDAR system samples the wind field at discrete points above the target and transmits real-time data to approaching autonomous airdrop systems. In simulation and experimentation, the inclusion of a light detection and ranging (LIDAR) system showed a maximum of 40% improvement over unaided autonomous airdrop systems. Wind information nearest ground level has the largest impact on improving accuracy.


Development Of A Test Level 3 Transition Between Guardrail And Portable Concrete Barriers, Robert W. Bielenberg, David Gutierrez, Ronald K. Faller, John D. Reid, Phil Tenhulzen Jan 2017

Development Of A Test Level 3 Transition Between Guardrail And Portable Concrete Barriers, Robert W. Bielenberg, David Gutierrez, Ronald K. Faller, John D. Reid, Phil Tenhulzen

Department of Civil and Environmental Engineering: Faculty Publications

Road construction often requires that work zones be created and shielded by portable concrete barriers (PCBs) to protect workers and equipment from errant vehicles as well as to prevent motorists from striking other roadside hazards. For an existing W-beam guardrail system installed adjacent to the roadway and near the work zone, guardrail sections are removed so a PCB system can be placed. A study was done to develop a crashworthy transition between W-beam guardrail and PCB systems. Design concepts were developed and refined through computer simulation with LS-DYNA. Additionally, a study of critical impact points was conducted to determine impact …


Calibrating The Robertson’S Platoon Dispersion Model On A Coordinated Corridor With Advance Warning Flashers, Zhao Li, Laurence Rilett, Ernest Tufuor Jan 2017

Calibrating The Robertson’S Platoon Dispersion Model On A Coordinated Corridor With Advance Warning Flashers, Zhao Li, Laurence Rilett, Ernest Tufuor

Department of Civil and Environmental Engineering: Faculty Publications

Platoon dispersion (PD) is the foundation of traffic signal coordination in an urban traffic network. PD describes the phenomenon by which vehicles depart from an upstream intersection as a platoon and begin to disperse before they arrive at the downstream intersection. Recently, advance warning flashers (AWFs) have been applied in many high-speed corridors. There is a need to update the traditional PD model to include the effect of AWFs. This paper examines the traffic flow dispersion patterns when an AWF is present and tests the hypothesis that the AWF will affect PD on a coordinated signal corridor. Platoon vehicles, which …