Automotive Engineering Commons^™

Traction And Launch Control For A Rear-Wheel-Drive Parallel-Series Plug-In Hybrid Electric Vehicle, Adam Michael Szechy

Doctoral Dissertations and Master's Theses

Hybrid vehicles are becoming the future of automobiles leading into the all-electric generation of vehicles. Electric vehicles come with a great increase in torque at lower RPM resulting in the issue of transferring this torque to the ground effectively. In this thesis, a method is presented for limiting wheel slip and targeting the ideal slip ratio for dry asphalt and low friction surfaces at every given time step. A launch control system is developed to further reduce wheel slip on initial acceleration from standstill furthering acceleration rates to sixty miles per hour. A MATLAB Simulink model was built of the …

Development, Characterization, & Implementation Of Phase-Change Material Cold Plates For Hybrid-Electric Vehicle Battery Systems, Kevin Cwiok

Doctoral Dissertations and Master's Theses

Due to the regulations on internal combustion engine vehicles, there is a large demand of hybrid and electric vehicles with large battery packs as Energy Storage Systems (ESS) capable of long ranges and decreased emissions. These battery packs output large heat loads during charge-depletion mode and currently require active cooling to keep the batteries within operating conditions. The current systems relied onto achieve this are the air and liquid cooled thermal managements systems. A recent alternative approach to current cooling for ESS thermal management is the use of phase-change materials (PCMs). PCMs regulate the temperature of the ESS by leveraging …

Vision-Aided Navigation For Autonomous Vehicles Using Tracked Feature Points, Ahmed Saber Soliman Sayem

Doctoral Dissertations and Master's Theses

This thesis discusses the evaluation, implementation, and testing of several navigation algorithms and feature extraction algorithms using an inertial measurement unit (IMU) and an image capture device (camera) mounted on a ground robot and a quadrotor UAV. The vision-aided navigation algorithms are implemented on data-collected from sensors on an unmanned ground vehicle and a quadrotor, and the results are validated by comparison with GPS data. The thesis investigates sensor fusion techniques for integrating measured IMU data with information extracted from image processing algorithms in order to provide accurate vehicle state estimation. This image-based information takes the forms of features, such …

Sensing, Actuation, And Embedded Control For A Custom Scr Nitrogen Oxides Emissions Reduction System, Anuj Kalidas Sharma

Doctoral Dissertations and Master's Theses

Diesel engines are the main power source for medium and heavy duty on road vehicles. With the rising standards for mileage of vehicles set by the Corporate Average Fuel Economy and the Environmental Protection Agency, diesel engines should soon be considered in lieu of gas engines. Despite advantages of diesel engines, diesel emissions include harmful gasses like carbon monoxide, nitrogen oxides and particulate matter. Selective Catalytic Reduction (SCR) systems have long been used to reduce diesel emissions from medium to heavy-duty diesel engines. Primary focus of this research effort is the implementation and improvement of a SCR system on light …

The Design Of A Racing Simulator: A Three-Phase User Testing Approach, Jakob E. Rouleau, Eric J. Wach

Human Factors and Applied Psychology Student Conference

No abstract provided.

Accident Events In Automated Vehicles, Peter Hancock, Tiffani Walker, Valarie Yerdon, William Volante, Shu Ling Li

Human Factors and Applied Psychology Student Conference

We are all aware of the increasing penetration of purely automated vehicles into the coming panoply of ground transportation. Much of the test and evaluation procedures of these respective vehicles have occurred on unidirectional, multi-lane highways and freeways where the central computational problem is relatively simple longitudinal and lateral control. In essence, these controls over what Gibson and Crooks labelled the ‘field of safe travel,’ can be affected by a suite of on-board sensors that measure a combination of range (d) and closure velocity (v). These combinatorial kinematics and kinetics can then provide satisficed solutions to the question of relative …

An Approach To Automotive Electrification And Testing, Christopher Rowe

Doctoral Dissertations and Master's Theses

In order to compete in the EcoCAR 2 competition, Embry-Riddle Aeronautical University has redesigned the Powertrain of a 2013 Chevrolet Malibu into a plug-in hybrid electric vehicle. This endeavor was made possible by the EcoCAR 2 competition sponsored by the Department of Energy, General Motors, and Argonne National Laboratory. The Powertrain was changed from a conventional internal combustion engine with a start/stop capability, to a fully electric Powertrain, with a diesel generator, and plug in charging capability. This paper will cover the electrical work performed on the vehicle during the summer prior to year three of the competition, EcoCAR 2 …

Run-Time Hev Engine-Generator Power-Speed Optimization For Fuel Consumption And Emissions Reduction, Chester Paul Rowe Ii

Doctoral Dissertations and Master's Theses

As fuel economy and emissions standards become more stringent, Plug-in Hybrid Electric Vehicles (PHEV) using series architectures are being increasingly explored. Due to the decoupling of the Internal Combustion Engine (ICE) from the road, the primary control challenge in this architecture is the optimization of an ICE control law. A run-time Genset speed controller is presented for use during the charge-sustaining mode in a Series PHEV to find the optimal operating parameters for a conventional diesel engine coupled to an electric generator in terms of minimized fuel consumption and emissions generation. On board vehicle sensors provide real time data to …

Development Of A System Architecture For Unmanned Systems Across Multiple Domains, Charles Randall Breingan Jr.

Doctoral Dissertations and Master's Theses

In the unmanned systems industry, there is no common standard for systems components, connections and relations. Such a standard is never likely to exist. Needless to say, a system needs to have the components that are required for the application, however, it is possible to abstract the common functionality out of an individual implementation. This thesis presents a universal unmanned systems architecture that collects all of the common features of an unmanned system and presents them as a set of packages and libraries that can be used in any domain of unmanned system operation. The research and design of the …

Execution Of A Hybrid Vehicle Controls Development Effort Utilizing Model-Based Design, Hardware-In-The-Loop Testing, Agile Scrum Methods And Requirements Engineering, Derek Simon Bonderczuk

Doctoral Dissertations and Master's Theses

Modern hybrid vehicles require sophisticated supervisory control systems in order to realize competitive efficiency gains. Processes such as model-based design, HIL simulation and Agile Scrum methods can allow for quicker and less costly development of a complex product. The design of a supervisory control system for a prototype PHEV vehicle was executed with the intent of developing a mule vehicle into a 99% production ready vehicle. The control system design process was carried through from requirements definition to operating parameter optimization of utilizing model-based design, HIL simulation and the Scrum model. A prototype vehicle that has a fully functioning hybrid …

Differential Effects Of Refractive Blur On Day And Nighttime Driving Performance, Joanne M. Wood, Michael J. Collins, Alex Chaparro, Ralph Marszalek, Trent Carberry, Philippe Lacherez, Byoung Sun Chu

Publications

PURPOSE. To investigate the effect of different levels of refractive blur on real-world driving performance measured under day and nighttime conditions.

METHODS. Participants included 12 visually normal, young adults (mean age = 25.+- 5.2 years) who drove an instrumented research vehicle around a 4 km closed road circuit with three different levels of binocular spherical refractive blur (+0.50 diopter sphere [DS], +1.00 DS, +2.00 DS) compared with a baseline condition. The subjects wore optimal spherocylinder correction and the additional blur lenses were mounted in modified fullfield goggles; the order of testing of the blur conditions was randomized. Driving …

Decreasing The Power Consumption Of Hybrid Electric Vehicle Architectures, Domenic Leo Barsotti

Doctoral Dissertations and Master's Theses

This paper presents the challenges seen by current automotive manufacturers in their investigation of more fuel efficient vehicles. The two main areas for improvement are aerodynamics and passive cooling of electrical systems. Aerodynamics of an Ahmed body is investigated with a drag reduction system proposed utilizing slot jets at the rear of the bluff body . Two separate systems show a decrease in drag of 16 and 25%. The paper also investigates the use of a phase change material for a hybrid electric vehicles energy storage system cooling. Phase change materials take advantage of the latent heat of fusion to …

Development Of A Hybrid Vehicle Powertrain Test Laboratory, Bennet Samuel Soundarraj

Doctoral Dissertations and Master's Theses

During the last two years, Embry-Riddle Aeronautical University has installed and tested a fully functional eddy-current chassis dynamometer testing facility on campus. An automotive test facility requires a systems engineering approach to install, calibrate and commission a chassis dynamometer. This thesis shows that, the dynamometer test facility was successfully installed, commissioned and documented to safely support the power train development and testing. We can currently test the EcoCAR vehicle and a number of other front-wheel-drive vehicles at our university campus using the eddy current chassis dynamometer.

Development Of A Supervisory Control Unit For A Series Plug-In Hybrid Electric Vehicle, Brian Neal Harries

Doctoral Dissertations and Master's Theses

A Series PHEV was chosen, as ERAU's entry into EcoCAR2 through a multidisciplinary architecture selection process. The series architecture was chosen for its mechanical feasibility, consumer acceptability and its performance on energy consumption simulations. The Series PHEV architecture was modeled using Matlab, Simulink, and dSPACE ASM tools, to create a plant model for controller development. A supervisory controller was developed to safely control the interactions between powertrain components. The supervisory control unit was tested using SIL and HIL methodologies. The supervisory controller was developed with an emphasis on fault detection and mitigation for safety critical systems. A power management control …

The Engineering Process For The Design Of A Motorcycle Chassis And Suspension, Derek J. Noce

Doctoral Dissertations and Master's Theses

The thesis objective is to define and establish an engineering process for the design of a modern motorcycle chassis and suspension. The engineering process focuses on the interdisciplinary fields of engineering dealing with design and structural optimization. Specialized software, such as Motorcycle Kinematics, MATLAB, CATIA, HEEDS Professional, and NASTRAN are utilized. Motorcycle Kinematics is used to set up the preliminary motorcycle geometry, and MATLAB is a used to analyze the kinematics and stability of the motorcycle based on this geometry. CATIA (Computer Aided Three-Dimensional Interactive Application) is used to graphically illustrate the geometry of the motorcycle in three dimensional space. …

Nonholonomic Feedback Control Among Moving Obstacles, Stephen Gregory Armstrong

Doctoral Dissertations and Master's Theses

A feedback controller is developed for navigating a nonholonomic vehicle in an area with multiple stationary and possibly moving obstacles. Among other applications the developed algorithms can be used for automatic parking of a passenger car in a parking lot with complex configuration or a ground robot in cluttered environment. Several approaches are explored which combine nonholonomic systems control based on sliding modes and potential field methods.

Development And Implementation Of A Fault Mitigating Control System For A Biodiesel Plug-In Hybrid Electric Vehicle For The Ecocar: The Next Challenge Competition, Sean Christopher Carter

Doctoral Dissertations and Master's Theses

The automotive industry is continuously developing, and with it hybrid vehicle technology is a growing field of interest. The design of the electric vehicle is a pressing matter and grows in complexity with new powertrain components such as power inverters and transmission systems that use electric motors. As a control system develops, the architecture always comes back to systems engineering documentation to find safety protocols, solutions to problems through fault testing, and validating and verifying the control architecture throughout the whole process. Testing and evaluation plans are required more than ever and are constantly being updated and implemented in today's …

Internet Enabled Remote Driving Of A Combat Hybrid Electric Power System For Duty Cycle Measurement, Jarrett Goodell, Marc Compere, Wilford Smith, Mark Brudnak, Mike Pozolo, Et Al.

Publications

This paper describes a human-in-the-loop motion-based simulator interfaced to hybrid-electric power system hardware, both of which were used to measure the duty cycle of a combat vehicle in a virtual simulation environment. The project discussed is a greatly expanded follow-on to the experiment published in [1,7]. This paper is written in the context of [1,7] and therefore highlights the enhancements. The most prominent of these enhancements is the integration (in real-time) of the Power & Energy System Integration Lab (P&E SIL) with a motion base simulator by means of a “long haul” connection over the Internet (a geographical distance of …

Soldier/Hardware-In-The-Loop Simulation-Based Combat Vehicle Duty Cycle Measurement: Duty Cycle Experiment 2, Mark Brudnak, Mike Pozolo, Victor Paul, Syed Mohammad, Marc Compere, Et Al.

Publications

This paper describes a human-in-the-loop motion-based simulator interfaced to hybrid-electric power system hardware both of which were used to measure the duty cycle of a combat vehicle in a virtual simulation environment. The project discussed is a greatly expanded follow-on to the experiment published in [1]. This paper is written in the context of [1] and therefore highlights the enhancements. The most prominent of these enhancements is the integration (in real-time) of the Power & Electric System Integration Lab (P&E SIL) with a motion base simulator by means of a “long haul” connection over the Internet (a geographical distance of …

Robust Control Techniques Enabling Duty Cycle Experiments Utilizing A 6-Dof Crewstation Motion Base, A Full Scale Combat Hybrid Electric Power System, And Long Distance Internet Communications, Marc Compere, Jarrett Goodell, Miguel Simon, Wilford Smith, Mark Brudnak

Publications

The RemoteLink effort supports the U.S. Army's objective for developing and fielding next generation hybrid-electric combat vehicles. It is a distributed soldierin- the-Ioop and hardware-in-the-Ioop environment with a 6-DOF motion base for operator realism, a full-scale combat hybrid electric power system, and an operational context provided by OneSAF. The driver/gunner crewstations rest on one of two 6-DOF motion bases at the U.S. Army TARDEC Simulation Laboratory (TSL). The hybrid power system is located 2,450 miles away at the TARDEC Power and Energy System Integration Laboratory (P&E SIL). The primary technical challenge in the RemoteLink is to operate both laboratories together …

Robust Control Techniques For State Tracking In The Presence Of Variable Time Delays, Jarrett Goodell, Marc Compere, Miguel Simon, Wilford Smith, Ronnie Wright, Mark Brudnak

Publications

In this paper, a distributed driver-in-the-Ioop and hardware-in-the-Ioop simulator is described with a driver on a motion simulator at the U.S. Army TARDEC Ground Vehicle Simulation Laboratory (GVSL). Realistic power system response is achieved by linking the driver in the GVSL with a full-sized hybrid electric power system located 2,450 miles away at the TARDEC Power and Energy Systems Integration Laboratory (P&E SIL), which is developed and maintained by Science Applications International Corporation (SAIC). The goal is to close the loop between the GVSL and P&E SIL over the Internet to provide a realistic driving experience in addition to realistic …