Astrodynamics Commons^™

Senior Project: Global Position Determination From Observed Relative Position Of Celestial Bodies, Michael Holmes

Aerospace Engineering

A method was developed to determine the latitude and longitude of an observer based on the observed position of the Moon and several other celestial bodies. The basic principal developed dealt with the proximity of the Moon. Its relative displacement from calculated values was measured using photography by comparison with stars near the Moon. Photographs were taken from a location in San Luis Obispo at Longitude 120°35.9' and Latitude 35°13.3'. The analysis method has determined the location of the observer to a Longitude of 117°43.8'. An additional method located the observer to 36°38.7'N Latitude and 114°47.6'W Longitude.

Attitude Control Of A Satellite Simulator Using Reaction Wheels And A Pid Controller, Ryan E. Snider

Theses and Dissertations

Attitude requirements of a satellite are determined by its mission: telecommunications, optical imagery, and meteorology to name a few. A satellite's ability to orient its mission critical hardware (solar arrays, attitude sensors, etc.), as well as its mission specific payload, is incumbent upon the performance of the satellite's attitude control system (ACS). For a highly accurate ACS and for moderately fast maneuverability, reaction wheels are preferred because they allow continuous and smooth control while inducing the smallest possible disturbance torques. The objective of this research is to design, build, test, and evaluate the performance of a reaction wheel ACS on-board …

Prototype Development And Dynamic Characterization Of Deployable Cubesat Booms, Grant M. Thomas

Theses and Dissertations

The current barrier to CubeSat proliferation is their lack of utility depth. These small satellites are exceptionally well suited for specific space missions such as space weather observation and other scientific data gathering exploits; however, they are not suited for every mission. The 10cm-cube form factor that gives the CubeSat its unique advantage is also its greatest hindrance. A potential bridge over this gap is the successful integration of deployable booms onto the CubeSat structure. With this research, the Air Force Institute of Technology (AFIT) explored the parameters of deployable tapespring booms using the triangular retractable and collapsible (TRAC) cross- …

Preliminary Electrical Designs For Ctex And Afit Satellite Ground Station, Arthur L. Morse

Theses and Dissertations

This thesis outlines the design of the electrical components for the space-based ChromoTomography Experiment (CTEx). CTEx is the next step in the development of high-speed chromotomography at the Air Force Institute of Technology. The electrical design of the system is challenging due to the large amount of data that is acquired by the imager and the limited resources that is inherent with space-based systems. Additional complication to the design is the need to know the angle of a spinning prism that is in the field of view very precisely for each image. Without this precise measurement any scene that is …

Mission Analysis For Multiple Rendezvous Of Near-Earth Asteroids Using Earth Gravity Assist, Uriah J. Tobey

Theses and Dissertations

The Jet Propulsion Laboratory (JPL) catalog of near-Earth objects (NEOs) such as asteroids and comets contains over 6600 asteroids and 150 comets as of February of 2010. This includes over 1000 potentially hazardous asteroids, or objects with orbits that pass close enough to Earth to pose a potential impact threat. The asteroid community believes there are a significant number of objects still undiscovered, which makes finding, tracking, and calculating missions to study these objects an active area of research. This study was based on finding orbit solutions using Earth gravity assist to visit one near-Earth object (NEO) a year for …

System Integration And Attitude Control Of A Low-Cost Spacecraft Attitude Dynamics Simulator, Ryan L. Kinnett

Master's Theses

The CalPoly Spacecraft Attitude Dynamics Simulator mimics the rotational dynamics of a spacecraft in orbit and acts as a testbed for spacecraft attitude control system development and demonstration. Prior to this thesis, the simulator platform and several subsystems had been designed and manufactured, but the total simulator system was not yet capable of closed-loop attitude control. Previous attempts to make the system controllable were primarily mired by data transport performance. Rather than exporting data to an external command computer, the strategy implemented in this thesis relies on a compact computer onboard the simulator platform to handle both attitude control processing …

Adaptive Control Applied To The Cal Poly Spacecraft Attitude Dynamics Simulator, Matthew C. Downs

Master's Theses

The goal of this thesis is to use the Cal Poly Spacecraft Attitude Dynamics Simulator to provide proof of concept of two adaptive control theories developed by former Cal Poly students: Nonlinear Direct Model Reference Adaptive Control and Adaptive Output Feedback Control. The Spacecraft Attitude Dynamics Simulator is a student-built air bearing spacecraft simulator controlled by four reaction wheels in a pyramidal arrangement. Tests were performed to determine the effectiveness of the two adaptive control theories under nominal operating conditions, a “plug-and-play” spacecraft scenario, and under simulated actuator damage. Proof of concept of the adaptive control theories applied to attitude …

Comparison And Design Of Simplified General Perturbation Models (Sgp4) And Code For Nasa Johnson Space Center, Orbital Debris Program Office, Nicholas Z. Miura

Master's Theses

This graduate project compares legacy simplified general perturbation model (SGP4) code developed by NASA Johnson Space Center, Orbital Debris Program Office, to a recent public release of SGP4 code by David Vallado. The legacy code is a subroutine in a larger program named PREDICT, which is used to predict the location of orbital debris in GEO. Direct comparison of the codes showed that the new code yields better results for GEO objects, which are more accurate by orders of magnitude (error in meters rather than kilometers). The public release of SGP4 also provides effective results for LEO and MEO objects …

Attitude Determination Using Imaging Lidar, Camille Decoust

Master's Theses - Daytona Beach

The purpose of this study is to determine the attitude of an out of control object using a new technology called lidar (Light Ranging and Detection). As the number of spacecraft continues to grow, it is paramount to introduce a new type of autonomous on-orbit satellite inspection and repair involving docking. Traditional space vision technology is based on video systems. This method is limited by the necessity of operating when the target is illuminated by the sunlight or using its own source of illumination. The use of laser imaging technology offers an elegant solution to these challenges. This approach allows …

Optimization Of Active Rendezvous Trajectories By Genetic Algorithms, Marie Emmanuelle Ricour

Master's Theses - Daytona Beach

Trajectory optimization is and will remain a hot topic in the engineering field. Because analytical or exact solutions are often difficult and sometimes impossible to compute, there is a need for alternative and efficient methods. UnderWater Vehicles (UWV) trajectories and rendezvous trajectories of continuous low-thrust spacecraft are examined. One of the methods to solve such problems is the Genetic Algorithm (GA) method. In this work, a GA has been developed using Matlab®. It treats possible solutions to the studied problems as individuals and eventually converges to an optimal or near optimal solution. Genetic Algorithms have been used previously to solve …

Investigation Of An Alternative Technique For Measuring Turbulence In The Upper Atmosphere, Charles Patrick Leonard

Mechanical & Aerospace Engineering Theses & Dissertations

The capability of the Global Positioning System (GPS) as a tool for measuring turbulence in the upper atmosphere is presented. By studying experimental ground and flight test data, a methodology for extracting macroscale turbulence data from in situ measurements was developed.

A description of the GPS using a single nonprecision receiver is followed by data from ground and flight testing. Ground testing focused on determining the smallest turbulent scales discernible by the GPS receiver. Testing was also undertaken to compare turbulence data from the GPS with that of a simultaneously operating constant-temperature hot-wire anemometer, the conventional tool for making turbulence …

Weatherford Air Show And General Thomas P. Stafford Museum Dedication, City Of Weatherford

Programs

This is a program from the 1987 Weatherford Air Show and General Thomas P. Stafford Museum Dedication in Weatherford, Oklahoma.

Unless stated otherwise within this repository collection, all materials are shared under the following Creative Commons license: [Creative Commons Attribution-NonCommercial 4.0 International License].

Second Annual Great Oklahoma Balloon Race & Airshow Gala Reception, Clarence E. Page Oklahoma Air And Space Museum

Programs

This is the program from the second annual Great Oklahoma Balloon Race & Airshow Gala Reception in honor of Astronaut, Lt. General Thomas P. Stafford. The event was held at the Clarence E. Page Oklahoma Aviation and Space Hall of Fame and Museum in the Kirkpatrick Center in OKC, OK, on Thursday, August 16th, 1984.

Unless stated otherwise within this repository collection, all materials are shared under the following Creative Commons license: [Creative Commons Attribution-NonCommercial 4.0 International License].

Apollo/Soyuz Tv Guide: "Soyuz, Soyuz, This Is Apollo...", Bob Button

Articles

This is a TV Guide from 1975 that features a story about the televised Apollo/Soyuz mission.