Aerodynamics and Fluid Mechanics Commons^™

Equivalent-Area Studies For Sonic Boom Loudness Mitigation On A Commercial Supersonic Aircraft Configuration, Zachary N. Foster

All Graduate Reports and Creative Projects, Fall 2023 to Present

Since the early 1970s, the FAA has banned commercial supersonic flight over populated areas. This ban has limited aerospace manufacturers’ and commercial aircraft companies’ ability to design and operate subsonic aircraft in their fleets. Since then, research has been conducted to understand the sonic boom and learn how to minimize its loudness. The work presented in this project report aims to use a 1D low-fidelity analysis to study the effect of perturbations to the outer mold line (OML) of a representative model of the N+2 Quiet Commercial Supersonic Concept Aircraft. Using a 1D analysis that employs an equivalent area method, …

Effect Of Spray Rails On Takeoff Performance Of Amphibian Aircraft, Soham Bahulekar

Doctoral Dissertations and Master's Theses

Amphibian aircraft have seen a rise in popularity in the recreational and utility sectors due to their ability to take off and land on both land and water, thus serving a myriad of purposes such as aerobatics, surveillance, and firefighting. The design of such seaplanes requires to be both aerodynamically and hydrodynamically efficient, especially during the takeoff phase. In the past, naval architects have implemented ways to make boats, yachts, and large ships more efficient; one of them being the addition of chine strips and spray rails on the hull. This thesis study explores the possibility of implementing spray rails …

Development Of A State-Space Aeroelastic Model Of A Flexible T-Tail Aircraft For Flutter Analysis, Patrick S. Downs

Doctoral Dissertations and Master's Theses

Flutter prediction is an important part of the preliminary design process of any new aircraft. Current analysis methods include coupled fluid structure interaction codes and doublet lattice panel codes. The computation resources and time required for CFD solutions makes them unattractive for preliminary design and doublet lattice models require considerable pre and post processing to provide satisfactory results. Thus, a process for developing an analytical model to facilitate rapid design changes and the implementation of active control systems is the main motivation of this thesis. An analytical model is developed by first deriving the equations of motion of the structure …

Design Of Banner Tow Mechanism For Bush Plane, Kyle Ciarrone, Ivan Martin, Rishabh Gadi, Tyler Brandt

Williams Honors College, Honors Research Projects

The 2019-2020 AIAA DBF objective was to design, build, and test a banner-towing bush plane that carries wooden passengers and luggage. Senior members on the team undertook the creation of the banner tow mechanism subsystem as their senior design project on behalf of the design team due to the challenge of its mechanical design and the aerodynamic considerations regarding its placement and enclosure aboard the aircraft. The competition as well as access to campus resources were canceled due to COVID-19, so full testing and integration of the mechanism was not achieved. However, the engineering design process was experienced from the …

Wind Tunnel Measurements And Data Analysis Tutorial, Nihad E. Daidzic

Aviation Department Publications

This tutorial gives details on processing of raw aerodynamic data measured directly in the wind tunnel on airfoils and wings. Also procedures and equations from the lab report are given and demonstrated how to compute geometric characteristics of wings/airfoils and air data. All numeric results are typically rounded to five significant digits.

Initial Stage Of Fluid-Structure Interaction Of A Celestial Icosahedron Shaped Vacuum Lighter Than Air Vehicle, Dustin P. Graves

Theses and Dissertations

The analysis of a celestial icosahedron geometry is considered as a potential design for a Vacuum Lighter than Air Vehicle (VLTAV). The goal of the analysis is ultimately to understand the initial fluid-structure interaction of the VLTAV and the surrounding airflow. Up to this point, previous research analyzed the celestial icosahedron VLTAV in relation to withstanding a symmetric sea-level pressure applied to the membrane of the structure. This scenario simulates an internal vacuum being applied in the worst-case atmospheric environmental condition. The next step in analysis is to determine the aerodynamic effects of the geometry. The experimental setup for obtaining …

Fuel Flow Reduction Impact Analysis Of Drag Reducing Film Applied To Aircraft Wings, Damon Resnick, Chris Donlan, Nimish Sakalle, Cody Pinkerman

SMU Data Science Review

In this paper, we present an analysis of flight data in order to determine whether the application of the Edge Aerodynamix Conformal Vortex Generator (CVG), applied to the wings of aircraft, reduces fuel flow during cruising conditions of flight. The CVG is a special treatment and film applied to the wings of an aircraft to protect the wings and reduce the non-laminar flow of air around the wings during flight. It is thought that by reducing the non-laminar flow or vortices around and directly behind the wings that an aircraft will move more smoothly through the air and provide a …

Brakes, Thrust Reversers, Beta Props, Spoilers And Life Dumps All Help In Deceleration Of Jets And Turboprops, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.

Avoiding Aircraft Icing Accidents, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.

Determination Of Stability And Control Derivatives For A Modern Light Composite Twin Engine Airplane, Monica M. Londono

Master's Theses - Daytona Beach

To develop and compare full envelope stability and control derivatives and their associated errors for a modern light composite twin engine airplane from flight test data and digital DATCOM (Data Compendium). This development is to serve three purposes 1) to provide data for validation of newer analytical techniques such as Computational Fluid Dynamics (CFD), 2) to provide public domain static and dynamic stability and control derivatives for a modern twin engine airplane, 3) to analyze the relationship between test design and error for both output error and equation error methods.

A flight test program was conducted on a Diamond Twin …

Multidisciplinary Design Optimization Of An Extreme Aspect Ratio Hale Uav, Bryan J. Morrisey

Master's Theses

ABSTRACT

Multidisciplinary Design Optimization of an Extreme Aspect Ratio HALE UAV

Bryan J. Morrisey

Development of High Altitude Long Endurance (HALE) aircraft systems is part of a vision for a low cost communications/surveillance capability. Applications of a multi payload aircraft operating for extended periods at stratospheric altitudes span military and civil genres and support battlefield operations, communications, atmospheric or agricultural monitoring, surveillance, and other disciplines that may currently require satellite-based infrastructure. Presently, several development efforts are underway in this field, including a project sponsored by DARPA that aims at producing an aircraft that can sustain flight for multiple years and …