Aerodynamics and Fluid Mechanics Commons^™

Three Component Velocity Measurements In The Tip Vortex Of A Micro-Air-Vehicle, Hong-Joon Park

Theses and Dissertations

The purpose of this research was to improve the MAV that will be used for battle damage assessment and reconnaissance or local surveillance through the experiments in AFIT wind tunnel. The experiments were performed to investigate the wing displacement and wing tip vortex interaction. To conduct the experiments, telescopic survey tool and tri-axial hot-wire anemometer was utilized. The results indicate that wing tip displacement of the flexible wing was approximately 8 times that of the rigid wing in an unstalled condition and data suggests that flexible wing has a denser core-distribution of velocity within the wing tip vortex and delays …

An Investigation Of The Dynamic Effects Of Flap Deflection On The Aerodynamic Characteristics Of An Airplane Wing Using Computational Fluid Dynamics, Alexander Moerchel

Master's Theses - Daytona Beach

Flaps are used to increase an airplane's lift and to adjust its stability and maneuverability. This study shows an application of STAR-CD, a commercial computational fluid dynamics (CFD) software, to an investigation of the dynamic effects of flap deflection on the lift, drag and moment coefficients, as well as on the location of the center of pressure. For this study, a plain flap was modeled with a moving mesh and was attached to a NACA 0012 airfoil and a wing of a general aviation aircraft for a 2D and 3D investigation, respectively. In addition, the flap deflection rates were varied …

Macroscopic Computational Model Of Dielectric Barrier Discharge Plasma Actuators, Timothy R. Klein

Theses and Dissertations

Recent progress in the generation and sustainment of gas discharges at atmospheric pressure has energized research in the field of plasma-aerodynamics. Plasma actuators are promising devices that achieve flow control with no moving parts, do not alter the airfoil shape and place no parts in the flow. The operation of a plasma actuator is examined using a macroscopic (force and power addition) computational fluid dynamic model of a dielectric barrier discharge, DBD, in Fluent. A parametric approach is adopted to survey the range of requisite magnitudes of momentum and energy delivered to the flow field and to identify the effects …

The Effect Of Aerodynamic Surfaces Versus Thrust Maneuvers On Reentry Vehicles, Meredith M. Albrecht

Theses and Dissertations

This research effort analyzes the effect of aerodynamic surfaces versus thrust maneuvers on a reentry vehicle. At high altitudes the effect of aerodynamic surfaces on the reentry vehicle is small due to low atmospheric density; however as the vehicle reaches lower altitudes a lift maneuver is very successful in deflecting the vehicle and creating a large impact footprint. When a continuous thrust maneuver is input in the place of a lift maneuver the results are very similar at the highest maneuver altitudes, although the impact footprint shrinks rapidly as the maneuver altitude decreases. Additionally, when the thrust maneuver is along …

Characterization Of Upstream Mixing Cavities And A Downstream Combustion Cavity In Supersonic Flow, Adam P. Quick

Theses and Dissertations

A key area of study in air-breathing hydrocarbon-fueled scramjet combustors is the characterization of cavity-based fuel injection and flame holding. One issue concerns oscillatory disturbances caused by trapped vortices in the main flame holder cavity as a fuel-air mixing enhancement technique. Previous research demonstrates that oscillatory disturbances can be carried downstream via the shear layer and alter the oscillatory characteristics of a downstream cavity. This study investigates the mixing effectiveness of three upstream direct-fueled mixing cavities as well as the effect on the oscillatory behavior of the downstream combustion cavity by the upstream mixing cavity. The three upstream mixing cavities …

Aerodynamic Analysis Of Lattice Grid Fins In Transonic Flow, Karl S. Orthner

Theses and Dissertations

Lattice grid fins have been studied for missile tail control for several years. A lattice grid fin can be described as an unconventional missile control surface comprised of an outer frame supported by an inner lattice grid of lifting surfaces. This unconventional fin design offers favorable lift characteristics at high angle of attack as well as almost zero hinge moments allowing the use of small and light actuators. In addition, they promise good storability for potential tube-launched and internal carriage dispenser-launched applications. The drawback for the lattice grid fins is the high drag and potentially poor radar cross section performance …

Experimental Investigation Into The Aerodynamic Performance Of Both Rigid And Flexible Wing Structured Micro-Air-Vehicles, Anthony M. Deluca

Theses and Dissertations

The Air Force Research Lab, Munitions Directorate, Eglin Air Force Base, Florida has designed a man-portable carbon-fiber Micro-Air-Vehicle (MA V) used for on-the-spot surveillance by Special Operations Forces (SOF) for enemy reconnaissance as well as post-strike Battle Damage Assessment (BDA).The main goals of this experiment are: 1) characterize the flow quality of the new AFIT 3' x 3' wind tunnel and 2) determine the aerodynamic performance characteristics of the 24" span, 6" chord flexible and rigid wing MA V s. The turbulent intensity of the wind tunnel was approximately 2%. Both MA Vs had an average lift slope within 3.5% …

External Aerodynamics Of Heavy Ground Vehicles: Computations And Wind Tunnel Testing, Ilhan Bayraktar

Mechanical & Aerospace Engineering Theses & Dissertations

Aerodynamic characteristics of a ground vehicle affect vehicle operation in many ways. Aerodynamic drag, lift and side forces have influence on fuel efficiency, vehicle top speed and acceleration performance. In addition, engine cooling, air conditioning, wind noise, visibility, stability and crosswind sensitivity are some other tasks for vehicle aerodynamics. All of these areas benefit from drag reduction and changing the lift force in favor of the operating conditions. This can be achieved by optimization of external body geometry and flow modification devices. Considering the latter, a thorough understanding of the airflow is a prerequisite.

The present study aims to simulate …

Measurements Of The Effects Of Tunnel Wall Proximity On The Velocity Field Upstream Of A Rod With Vortex Shedding In Low-Speed Flow, David R. Hopper

Theses and Dissertations

High cycle fatigue is an important consideration in blade design for turbomachinery. Blades in an engine undergo countless loading cycles in a lifetime, the result of pressure waves that propagate upstream and downstream from disturbances in the flow. Better understanding of these effects would allow blade designers to reduce the effects of high cycle fatigue, such as costly recurring maintenance or catastrophic engine failure. An experimental study was undertaken to determine the unsteady flow field upstream of a single cylinder in a subsonic flow. Von Karman vortex shedding from the cylinder produced a forcing function much like periodic blade passage …

Numerical And Experimental Investigation Of The Flowfield Near A Wrap-Around Fin, Carl P. Tilmann

Theses and Dissertations

A wall-mounted semi-cylindrical model fitted with a single wrap-around fin (WAF) has been investigated both numerically and experimentally, with the objective of characterizing the mean and turbulent flowfield in the vicinity of the fin. Numerical and experimental results are used to determine the nature of the flowfield and quantify the effects of fin curvature on the character of the flow near WAFs. This research has been motivated by the need to identify possible sources of a rolling moment reversal observed at high speeds in sub-scale flight tests. Detailed mean flow and turbulence measurements were obtained in the AFIT Mach 3 …

Wing-Section Optimization For Supersonic Viscous Flow, Cem Cihan Item

Mechanical & Aerospace Engineering Theses & Dissertations

The recent interest in the High Speed Civil Transport (HSCT) has resulted in renewed research studies of optimized supersonic cruise transport configurations. Incorporation of flow viscosity effects in the design process of such a supersonic wing is currently under investigation. This may lead to more accurate problem formulations and, in tum, greater aerodynamic efficiency than can be obtained by the traditional, inviscid, linear theories. In this context, for a design code to be a candidate for a complex optimization problem, such as three-dimensional viscous supersonic wing design, it should be validated using simpler building-block shapes.

To optimize the shape of …

Implementation Of A Multiblock Sensitivity Analysis Method In Numerical Aerodynamic Shape Optimization, James Matthew Lacasse

Mechanical & Aerospace Engineering Theses & Dissertations

A multiblock sensitivity analysis method is applied in a numerical aerodynamic shape optimization technique. The Sensitivity Analysis Domain Decomposition (SADD) scheme which is implemented in this study was developed to reduce the computer memory requirements resulting from the aerodynamic sensitivity analysis equations, Discrete sensitivity analysis offers the ability to compute quasi-analytical derivatives in a more efficient manner than traditional finite-difference methods, which tend to be computationally expensive and prone to inaccuracies.

The direct optimization procedure couples CFD analysis based on the two-dimensional thin-layer Navier-Stokes equations with a gradient-based numerical optimization technique. The linking mechanism is the sensitivity equation derived from …

Computation Of The Aerodynamic Characteristics Of A Subsonic Transport Aircraft Using A Panel Method, Lillianne Plaster Whitelock Troeger

Mechanical & Aerospace Engineering Theses & Dissertations

An advanced low-order panel method, VSAERO, is applied to a full-configuration transport aircraft. Wing pressure distributions as well as lift, drag, and pitching moment coefficients calculated for the full computational configuration are compared with experimental data. In addition, partial configurations are evaluated computationally to determine the relevance of certain complex aircraft components to the computations. It is shown that the wing-surface pressure distributions and pitching moment coefficient are well predicted by VSAERO. The lift coefficient is consistently overpredicted by the code.

Navier-Stokes Analysis Of Cold Gas Scramjet Nozzle-Afterbody Flowfields, Walter C. Engelund

Mechanical & Aerospace Engineering Theses & Dissertations

The recent renewal of interest in hypersonic aerodynamics, brought about largely in part due to the development of the National Aerospace Plane (NASP), is resulting in an increased reliance on computational fluid dynamics for flowfield data in this flight regime. The design of the nozzle-afterbody section for a hypersonic transport such as the NASP is currently underway, and is being conducted using both computational fluid dynamics and cold, non-reacting, simulant gas experimental models. In this study, a computational analysis is conducted for the flow through a scramjet nozzle-afterbody test section.

Computations have been performed for a cold gas simulation of …

Aerodynamic Forces On Flight Crew Helmets, Timothy A. Sestak, Richard M. Howard, Chester A. Heard

Publications

Wind tunnel tests were conducted to deter- mine the aerodynamic forces generated on aircrew flight helmets. Three helmets were tested: two used by aircrews flying ejection seat aircraft in the U.S. military, the Navy HGU-33/P and the Air Force HGU-53/P; and one prototype helmet of significantly different shape and volume. Axial and normal forces were measured through a range of pitch and yaw angles. It was found that large forces exist tending to promote helmet loss during ejection, and that simple modifications to the current helmet configurations can reduce those forces by as much as 40%. It is demonstrated that …

Calculations Of Three-Dimensional Transonic Flows Using The Implicit Formulation Of The Isenthalpic Euler Equations With Flux Vector Splitting, Frank E. Cannizzaro

Mechanical & Aerospace Engineering Theses & Dissertations

A numerical method for solving three-dimensional transonic flows using the isenthalpic formulation of the Euler equations is developed. The method uses van Leer's flux vector splitting to solve the implicit formulation of the governing equations, which are applied to a cell centered finite-volume scheme. A three factor spatial approximate factorization is implemented in solving the implicit part of the governing equations. Time marching to a steady state solution requires short computational times due to the relative efficiency of the basic method. Computational times are further reduced by the implementation of the multigrid acceleration technique, which provided converged solutions in approximately …

Analysis And Optimal Design Of Wind Tunnel Balances, Sung-Ling Twu

Mechanical & Aerospace Engineering Theses & Dissertations

The problem of finding the optimal cross-sectional shape of the elastic cage in wind tunnel balance is formulated and solved numerically. A mathematical model to implement the boundary condition associated with the elastic rigid connection into the finite element method is discussed. Numerical results show that the rigid connection at the end of the elastic cage has significant effect on the stress distribution.

The finite dimensional approach for a three dimensional design sensitivity analysis is derived. Using both the free and rigid boundary conditions, numerical examples are performed and comparisons of the accuracy of design sensitivity analysis between the proposed …