Open Access. Powered by Scholars. Published by Universities.®

Aerodynamics and Fluid Mechanics Commons™

Open Access. Powered by Scholars. Published by Universities.®

1996

Articles 1 - 11 of 11

Full-Text Articles in Aerodynamics and Fluid Mechanics

Experimental Investigation Of Compressible Boundary Layers Under The Influence Of Pressure Gradients, Raymond C. Wier Dec 1996

Experimental Investigation Of Compressible Boundary Layers Under The Influence Of Pressure Gradients, Raymond C. Wier

Theses and Dissertations

This study examined the effect of mild pressure gradients on the mean and turbulent flow of high-speed boundary layers. Three Mach numbers (1.7, 3.0 and 5.0) were investigated. Three pressure gradients were examined; a zero pressure gradient (ZPG), a favorable pressure gradient (FPG), and a combined pressure gradient (CPG). The CPG consisted of an adverse pressure gradient followed by a favorable pressure gradient. Conventional pressure probes, hot-wire and particle image velocimetry (PIV) were used to examine the flow. Measurement included mean velocity, velocity turbulence intensity, mass flux turbulence intensity and energy spectra. Instantaneous (10 nsec) Mie scattering flow visualizations were …

Go to article

Experimental Investigation Of Transverse Supersonic Gaseous Injection Enhancement Into Supersonic Flow, Mark P. Wilson Dec 1996

Experimental Investigation Of Transverse Supersonic Gaseous Injection Enhancement Into Supersonic Flow, Mark P. Wilson

Theses and Dissertations

In pursuit of more efficient and effective fuel-air mixing for a SCRAMJET combustor, this study was conducted to investigate relative near field enhancements of penetration and mixing of a discrete low-angled (25°) injected air jet into a supersonic (M=2.9) cross flow. The enhancements were achieved by injecting the transverse air jet parallel to the compression face of eight different ramp geometries. The jet-ramp interactions created collinear shock structures, baroclinic torque vorticity enhancement, ramp spillage enhanced vorticity, magnus effect penetration enhancement, and increased total pressure loss. Shadowgraph photography was used to identify the shock structures and interactions in the flow field. …

Go to article

The Effectiveness Of Film Cooling In A Hypersonic Flowfield With Favorable Pressure Gradients, Julie A. Young Oct 1996

The Effectiveness Of Film Cooling In A Hypersonic Flowfield With Favorable Pressure Gradients, Julie A. Young

Mechanical & Aerospace Engineering Theses & Dissertations

The impetus of this technical document is to report results of aerothermodynamic cooling of a scramjet nozzle under favorable pressure gradients. The goals of film cooling are to protect the nozzle skin from the high enthalpy combustor flow, reduce regenerative cooling requirements, and decrease nozzle skin friction. A hypersonic nozzle configuration for which experimental data exists was selected as the basis of this numerical study. As a first step, the numerical results of film cooling along a flat plate are compared to previous literature to validate the numerical model. Subsequently, computations are performed to study the effects of varying the …

Go to article

A Study Of The Numerical Implementation Of Multidisciplinary Design Optimization Strategies, Rodney A. Taylor Jul 1996

A Study Of The Numerical Implementation Of Multidisciplinary Design Optimization Strategies, Rodney A. Taylor

Mechanical & Aerospace Engineering Theses & Dissertations

Design optimization provides an organized, systematic, and efficient method for obtaining design improvements based upon a specified measure of design performance. In the multidisciplinary design optimization (MDO) environment efficient optimization techniques allow complex designs to be improved by managing conflicting disciplinary design goals so as to improve the global design. This thesis studies the implementation issues surrounding MDO techniques and strategies. To facilitate this investigation two testbed problems have been selected for study. These problems consider two approaches to the conceptual design of an aeroelastic wing. The first approach is based on an idealized, two-dimensional representation of an airfoil under …

Go to article

Direct Measurement Of Skin Friction In High Temperature And Impulsively Started Supersonic Flowfields, David M. Hazelton Jun 1996

Direct Measurement Of Skin Friction In High Temperature And Impulsively Started Supersonic Flowfields, David M. Hazelton

Theses and Dissertations

This study further developed and improved a miniature plastic cantilever floating element gauge for direct measurement of skin friction in shock tunnel tests. Gauge durability and usability were improved, and potential sources of error were quantified. A high frequency 30 kHz gauge (compared to the baseline 10 kHz gauge) was constructed by using an I-beam cantilever rather than a round beam. A directional gauge was developed and demonstrated by measuring the flowfield about a fin in the AFIT shock tunnel. The 10 kHz and 30 kHz gauges were used in two scramjet test sequences conducted at Mach 14 enthalpy (stagnation …

Go to article

Nonlinear Analysis Of Airfoil Flutter At Transonic Speeds, Scott A. Morton May 1996

Nonlinear Analysis Of Airfoil Flutter At Transonic Speeds, Scott A. Morton

Theses and Dissertations

Hopf-bifurcation analysis is used to determine flutter boundaries of a pitch and plunge airfoil (PAPA) at transonic Mach number conditions. The PAPA model is a coupling of the Euler equations and a two-degree-of-freedom structural model composed of linear and torsional springs. The Euler equations are discretized using an upwind total variation diminishing scheme (TVD) of Harten and Yee. Equilibrium solutions of the PAPA model are computed using Newton's method and dynamic solutions are explicitly integrated in time with first-order accuracy. The Hopf-bifurcation point, which models the flutter condition, is computed directly by solving an extended system of equilibrium equations following …

Go to article

Sensitivity Analysis And Optimization Of Aerodynamic Configurations With Blend Surfaces, Almuttil Mathew Thomas Apr 1996

Sensitivity Analysis And Optimization Of Aerodynamic Configurations With Blend Surfaces, Almuttil Mathew Thomas

Mechanical & Aerospace Engineering Theses & Dissertations

A novel (geometrical) parametrization procedure using solutions to a suitably chosen fourth order partial differential equation is used to define a class of airplane configurations. Inclusive in this definition are surface grids, volume grids, and grid sensitivity. The general airplane configuration has wing, fuselage, vertical tail and horizontal tail. The design variables are incorporated into the boundary conditions, and the solution is expressed as a Fourier series. The fuselage has circular cross section, and the radius is an algebraic function of four design parameters and an independent computational variable. Volume grids are obtained through an application of the Control Point …

Go to article

Study Of Surface Heat Exchangers For High-Altitude Atmospheric Research Aircraft, Te-Kang Wang Apr 1996

Study Of Surface Heat Exchangers For High-Altitude Atmospheric Research Aircraft, Te-Kang Wang

Mechanical & Aerospace Engineering Theses & Dissertations

A flush-mounted heat exchanger concept, using the wing surface to dissipate heat, is investigated as a lower drag alternative to conventional ducted plate-fin radiators. A feasibility analysis is made for an unmanned high-altitude aircraft which will reach altitudes up to 25 kilometers. A computer code is used to calculate approximate heat transfer coefficients over the airfoil's surface. A model is tested in the Old Dominion University subsonic wind tunnel to verify the results of the computer code. The results indicate that a flush mounted heat exchanger design is able to provide 20 to 100 percent of the required heat dissipation …

Go to article

An Investigation Into The Effects Of Lateral Aerodynamic Asymmetries, Lateral Weight Asymmetries, And Differential Stabilator Bias On The F-15 Directional Flight Characteristics At High Angles Of Attack, David R. Evans Mar 1996

An Investigation Into The Effects Of Lateral Aerodynamic Asymmetries, Lateral Weight Asymmetries, And Differential Stabilator Bias On The F-15 Directional Flight Characteristics At High Angles Of Attack, David R. Evans

Theses and Dissertations

The F-15 is a stable aircraft throughout most of its flight envelope. However, it still exhibits an uncommanded yawing and rolling tendency at high angles-of-attack. Identified influencing factors of this uncommanded motion are lateral aerodynamic asymmetries, lateral weight asymmetries, and differential stabilator bias. Previous research into the effects of these influencing factors has been qualitative. This thesis quantifies the effects and then identifies a symmetric F-15 configuration. The quantifying metric presented is net yaw acceleration. This thesis used both computer simulation and experimental flight test to quantify these effects. A discussion of each influencing factors effects on the F-15B high …

Go to article

Compressible Turbulence Measurements In A Supersonic Boundary Layer With Impinging Shock Wave Interaction, Michael J. Meyer Mar 1996

Compressible Turbulence Measurements In A Supersonic Boundary Layer With Impinging Shock Wave Interaction, Michael J. Meyer

Theses and Dissertations

No abstract provided.

Go to article

Riblet Effects On Gortler Vortex Development Over A Concave Surface, James A. Rothenflue Feb 1996

Riblet Effects On Gortler Vortex Development Over A Concave Surface, James A. Rothenflue

Theses and Dissertations

Riblet effects on Goertler vortex development in laminar and transitional flows were measured using three-dimensional laser-Doppler anemometry. Three freestream velocities were tested such that riblet spacing corresponded to Goertler vortex (GV) wavelengths which presumably would be either strongly amplified, weakly amplified, or attenuated by centrifugal forces on a curved surface. Experiments revealed the development of paired, counterrotating vortices within the riblet valleys over both flat and concave surfaces. For riblet spacings equivalent to weakly or non-amplified GV wavelengths, GV development on a curved surface was above the riblets and was delayed by the addition of riblets. The GV wavelength was …

Go to article