Aerodynamics and Fluid Mechanics Commons^™

Flight Testing And System Identification Of An Experimental Cessna 182, Mariano Chavez Rangel

Discovery Day - Daytona Beach

Flight testing and system identification are essential for accurately characterizing aircraft dynamics and supporting the development of reliable flight control systems. This work presents the use of an experimental Cessna 182 as a full-scale platform for flight testing and system identification, conducted by the Eagle Flight Research Center. The objective is to generate high-fidelity flight data to estimate aerodynamic and dynamic coefficients and establish a baseline model for comparison with a sub-scale aircraft incorporating Integrated High-Lift Propulsor (IHLP) technology. The experimental aircraft is equipped with a comprehensive onboard instrumentation suite designed to capture synchronized measurements of air data, aircraft motion, …

G.W.A.I.H.I.R. Guided Wing Aircraft For Intelligent Hybrid Insertion And Recovery, Abdirahman Ahmed Shirwa, Zach Richards, Derek Harwood, Alex Duncan

Senior Design Project For Engineers

The paper outlines the conceptual and preliminary design of a hybrid vertical takeoff and landing (VTOL) heavy lift unmanned aerial vehicle (UAV) for autonomous cargo transport missions. The primary design objective was to create an aircraft capable of carrying a 15 kg payload over a range of 33 km, achieving a top cruise speed of 45 km/h and maintaining an endurance capacity of at least 90 minutes.

A comprehensive literature review informed key design decision, including airfoil selection, structural material, propulsion system configuration, and control. Key requirements were established early in the design process, such as payload capacity, energy efficiency, …

Bio-Inspired Airfoil Design Based On The Aerodynamic Analysis Of A Bird Feather Microstructure, Jack C. Ihm

College of Graduate Studies: Theses & Dissertations

This study investigates the aerodynamic effects of a bio-inspired airfoil design based on the microstructure of a secondary feather from a female wood duck. The research hypothesized that incorporating barbs and barbules into an airfoil design would modify boundary layer behavior by introducing localized flow disturbances. To test this, a bio-inspired airfoil was developed by integrating the microstructure into a NACA 0012 airfoil and analyzed using computational fluid dynamics (CFD) simulations at angles of attack of 0°, 5°, 10°, and 15°. The results showed that the bio-inspired airfoil influenced boundary layer behavior, producing localized flow disturbances near x/c = 0.7 …

Computational Fluid Dynamics Visualization For Unmanned Aerial Systems In Bridge Inspections, Kristoffer B. Borgen, John Mott

Journal of Aviation Technology and Engineering

Bridge inspections are an expensive and time-consuming process, varying significantly with a bridge’s style, height, width, and length. Inspections create interruptions that interfere with bridge use, as the examination requires partial or total closure, causing traffic delays. Unmanned aerial system (UAS) use has increased significantly over the past decade, including assistance and coordination during bridge inspections. However, the impact on a UAS from high winds and turbulent airflows induced by a bridge’s structure can decrease flight safety during inspections. Visualization of these hazards is difficult for UAS operators; therefore, a process to estimate the velocity and locations of these hazardous …

An Investigation Into In-Flight Loss Of Control Accidents Due To Horizontal Stabilizer Changes On The Piper Cherokee, Connor John Geran

Theses and Dissertations

Loss of Control (LOC) while in-flight in General Aviation (GA) has been the subject of intense research by academic institutions and regulatory agencies in recent years [4] [9] [11] [19] [20] [21]. This interest is primarily due to a disproportionate number of all aircraft accidents occurring within the GA category of flight, with 94% of accidents in 2022 occurring within GA, caused primarily by pilot LOC, with 42% of accidents having LOC as the listed cause. Research into this subject at FIT yielded the results that many common GA aircraft tend to experience a strong pitch up response after undergoing …

Conceptual Design Methodology For The Fan-In-Wing Vtol Aircraft, Brock Steinfeldt

Doctoral Dissertations and Master's Theses

The Fan-In-Wing (FIW) aircraft concept is one of the most compelling solutions for missions demanding jet-like cruise speeds and Vertical TakeOff and Landing (VTOL) capability. However, despite years of interest and documented improvements in lift-fan technology, there exists little in the way of an adequate theory for conceptual design of a fan-in-wing aircraft. To address this issue, a general conceptual design methodology has been developed as a source of guidance for the FIW designer. Through this work, the top-level requirements ranking the fan-in-wing concept above other VTOL aircraft have been defined, while a cross-comparison between the FIW concept and conventional …

Modelling Air Quality In An Aircraft Passenger Cabin Using Health Care Standards, Bert Silich

International Journal of Aviation, Aeronautics, and Aerospace

The interest in aerosol contamination of aircraft passenger cabins has increased since the onset of the COVID-19 pandemic. Mathematical models have been developed to help describe how an aerosol behaves in a closed space. The number of infectious particles inhaled is of scientific interest because it can be related to the risk of getting ill from a pathogen. The data required to calculate these results is often difficult to obtain in real world settings. In fact, particle inhalation details are not obtained in the day-to-day routine of a health care environment and are they not required to maintain safety. Hospital …

Analyzing The Effect Of Delta Airlines' Fleet Upgrade On Operations At Atlanta-Hartsfield Jackson International Airport, Carlos Alberto Castro, Shlok Misra

Publications

Commercial aviation has seen a growth in terms of passengers traveled and flights operated in the past decade (BTS, 2020). To cope up with this growth, airlines adopt various strategies such as network expansion and fleet upgrades. Airlines adopt fleet upgrade strategies to modernize their fleet, reduce costs, expand network coverage, and improve customer loyalty and experience. Research suggests that change in wake turbulence categorization and aircraft performance can directly impact the movements and delays at an airport. For this study, Delta Airline's fleet upgrade program and its effect on operating parameters at Atlanta-Hartsfield Jackson International Airport were analyzed. The …

Mastering Uncoordinated Flight: Slips And Skids, Nihad E. Daidzic

Aviation Department Publications

FAA Safety Webinar (GL15103784) held online at 9:00 CST on Saturday, April 10, 2021.

Identification Of Wind-Induced Hazard Zones Impacting Uas Bridge Inspection, Jack J. Green, John Mott

International Journal of Aviation, Aeronautics, and Aerospace

Unmanned Aerial Systems (UAS) continue to grow in both popularity and utility within the national airspace system. The use of commercial UAS for civil inspection, specifically that of bridge structures, is becoming commonplace among practitioners and academics alike. The development of an integrated bridge-inspection hazard model provides a way for UAS operators to prepare for and respond to changing environmental conditions that could otherwise prevent a successful UAS flight. The interaction of wind-induced airflow with bridge surfaces creates an aerodynamic wake that can result in hazardous conditions for a UAS platform operating in close proximity. An analysis of this airflow …

Celebrating 90-Orbits Around The Sun, Stafford Air & Space Museum

Programs

In celebration of the 90th birthday of Oklahoma astronaut and aerospace legend, Gen. Thomas P. Stafford, the Stafford Air & Space Museum in Weatherford, Oklahoma is offering free admission on September 17th, 2020.

Unless stated otherwise within this repository collection, all materials are shared under the following Creative Commons license: [Creative Commons Attribution-NonCommercial 4.0 International License].

Conceptual Design Of A South Pole Carrier Pigeon Uav, Kendrick M. Dlima

Master's Theses

Currently, the South Pole has a large data problem. It is estimated that 1.2 TB of data is being produced every day, but less than 500 GB of that data is being uploaded via aging satellites to researchers in other parts of the world. This requires those at the South Pole to analyze the data and carefully select the parts to send, possibly missing out on vital scientific information. The South Pole Carrier Pigeon will look to bridge this data gap.

The Carrier Pigeon will be a small unmanned aerial vehicle that will carry a 30 TB solid-state hard drive …

Aircraft Leading Edge Strakes On Conventional Naca Wings, Anthony Pirone

Discovery Day - Prescott

The prevention of stall on aircraft wings has been a great challenge over the history of airplanes. As the aircraft become more and more complex, it becomes harder to fit high lift devices and leading-edge devices onto high camber, supercritical airfoil aircraft wings. In the fighter jet class of aircraft the obstacle of stall is usually delayed by the implementation of leading-edge root extensions or strakes. Strakes create a tip vortice along the sharp leading edge that transitions over the surface of the wing preventing separation on both the upper and lower surface of the wing allowing the fighter jet …

Avia 201 Project 1 Windtunnel Lab Form Ver 1.20 20200323, Nihad E. Daidzic

Aviation Department Publications

To introduce aviation/aeronautics/aerospace students to wind tunnel(s) and methods used in experimental identification of various aerodynamic (and stability) coefficients of airfoils (2D), wings (3D) and scale models.

2020 Oklahoma Research Day Full Program, Southwestern Oklahoma State University

Oklahoma Research Day Abstracts

No abstract provided.

Rocket Motor Nozzle, Corey Hillegass

Williams Honors College, Honors Research Projects

For this honors research and senior design project, the authors will research, analyze, and manufacture a rocket motor nozzle for the Akronauts rocket design team. This research and design project will improve how the rocket design team will decide and manufacture nozzles going forward. The impact of this improvement allows the rocket design team to take steps toward being self-sustaining by manufacturing student designed parts as opposed to commercially bought parts. This will not only be successful in increasing student impact on future designs, but also provides a technical challenge for the authors and will present as an impressive feat …

Wind Tunnel Measurements And Data Analysis Tutorial, Nihad E. Daidzic

Aviation Department Publications

This tutorial gives details on processing of raw aerodynamic data measured directly in the wind tunnel on airfoils and wings. Also procedures and equations from the lab report are given and demonstrated how to compute geometric characteristics of wings/airfoils and air data. All numeric results are typically rounded to five significant digits.

An Afternoon With General Thomas P. Stafford, Stafford Air & Space Museum

Programs

An Afternoon with General Thomas P. Stafford

Sunday, May 19th, 2019 at 2:00 P.M. at the Weatherford High School Performing Arts Center.

Unless stated otherwise within this repository collection, all materials are shared under the following Creative Commons license: [Creative Commons Attribution-NonCommercial 4.0 International License].

Apollo 10, 50th Anniversary Gala, Stafford Air & Space Museum

Programs

The Apollo 10 50th Anniversary Gala was held on May 18th, 2019 at the Stafford Air & Space Museum in Weatherford, Oklahoma.

Unless stated otherwise within this repository collection, all materials are shared under the following Creative Commons license: [Creative Commons Attribution-NonCommercial 4.0 International License].

Generator Design: A Study Of Optimized Airflow, Rachel Wattleworth

Williams Honors College, Honors Research Projects

The core goal of this project was to prototype, test, and evaluate a new type of fan for the Safran Electrical & Power air-cooled generators. The idea of a new fan being made for these two generators arose when they were not adhering to design requirements. A base mixed-flow fan was created to test on multiple generators. Upon creating a prototype, it will be tested to prove if it can increase the air flow, decrease temperatures, and increase power and life of the machines. They all proved to be successful and achieve the main objectives for this project. Data such …

Urban Flow And Small Unmanned Aerial System Operations In The Built Environment, Kevin A. Adkins

International Journal of Aviation, Aeronautics, and Aerospace

The Federal Aviation Administration (FAA) has put forth a set of regulations (Part 107) that govern small unmanned aerial system (sUAS) operations. These regulations restrict unmanned aircraft (UA) from flying over people and their operation to within visual line of sight (VLOS). However, as new applications for unmanned aerial systems (UAS) are discovered, their capabilities improve, and regulations evolve, there is an increasing desire to undertake urban operations, such as urban air mobility, package delivery, infrastructure inspection, and surveillance. This built environment poses new weather hazards that include enhanced wind shear and turbulence. The smaller physical dimensions, lower mass and …

Air Temperatures Tutorial, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.

Design Of A Heavy Lift Rc Aircraft - Society Of Automotive Engineers (Sae) Aero Design® West Competition Team, Jiyoung Hwang, Phillip Nielsen

Undergraduate Research Symposium - Prescott

The SAE Aero West design competition challenges undergraduate students to design and build an RC aircraft that will fly with the maximum number of passengers and luggage possible. The ERAU SAE team focuses on simulation-based research and project methods such as Computational Fluid Dynamics (CFD), aircraft optimization, and Finite Element Analysis (FEA). Designing and manufacturing a well-designed heavy lift aircraft and competing with other groups will give experience in solving engineering problems. The Aerodynamics team is currently focusing on score optimization, aircraft performance and configuration. The propulsion team is constructing a test rig to test various propellers and motors to …

2018 Oklahoma Research Day Guide Book, Southwestern Oklahoma State University

Oklahoma Research Day Abstracts

This is the 2018 Oklahoma Research Day Guide Book. This book does not contain abstracts.

Specific Air Range (Sar) And How To Estimate It, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.

Design Of Shape-Conforming Nosecone For Optimal Fluid Flow From Transonic To Supersonic Range, Anna Tombazzi

Williams Honors College, Honors Research Projects

Modern flight vehicles, such as rockets, missiles, and airplanes, experience a force caused by forebody wave drag during the flight. This drag force is induced when the frontal point of each vehicle breaks the pressure wave during flight. Efforts to reduce this wave drag force to improve flight efficiency include modifying the nosecone profile of the flight vehicles to lower the drag force.

This project revolved around creating a design to make the transformation of nosecone shapes from a ¾ Parabolic profile to a ½ Power Series profile possible, mid-flight. Using a novel nosecone assembly, shape memory alloys (SMAs) and …

Flight Dynamics: Flying Qualities Of Handling Factors Are Engineered Into The Aircraft Design, Nihad E. Daidzic

Aviation Department Publications

Flight dynamics is an aerospace engineering discupline that addresses aircraft stability and controllability. It is also mathematically very intensive and is traditionally the most difficult in the pilot training curriculum. Ultimately, it does not matter how good steady-state performance of an aircraft design is if its flying (handling) qualities are deficient. Paradoxically, the first airplane Wright Flyer, was statically and dynamically unstable, had large control authority, and was difficult to fly. We've come a long way since those early days, but stability is still vitally important in aircraft design and flight ops. The focus of this article will be airplane …

An Archival Analysis Of Stall Warning System Effectiveness During Airborne Icing Encounters, John Michael Maris

Doctoral Dissertations and Master's Theses

An archival study was conducted to determine the influence of stall warning system performance on aircrew decision-making outcomes during airborne icing encounters. A Conservative Icing Response Bias (CIRB) model was developed to explain the historical variability in aircrew performance in the face of airframe icing. The model combined Bayes’ Theorem with Signal Detection Theory (SDT) concepts to yield testable predictions that were evaluated using a Binary Logistic Regression (BLR) multivariate technique applied to two archives: the NASA Aviation Safety Reporting System (ASRS) incident database, and the National Transportation Safety Board (NTSB) accident databases, both covering the period January 1, 1988 …

Computational Fluid Dynamics Is Key To Better Flying Aircraft, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.

Brakes, Thrust Reversers, Beta Props, Spoilers And Life Dumps All Help In Deceleration Of Jets And Turboprops, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.