Engineering Commons^™

An Investigation Of Low-Strength Concrete And Resulting Structural Failure In A Bridge Deck, James H. Havens

Kentucky Transportation Center Research Report

This investigation concerns the discovery of weak concrete in a portion of the deck of the Elkhorn City bridge, APD 640(4), within a year after it was opened to traffic. The deck concrete was placed between April 14 and June 14, 1968. The bridge serves heavy coal-trucks traffic. Failures occurred in the eastern-most span (No. 5) in April or May of 1969, Undoubtedly, the heavy loading contributed to early disclosure of defective concrete.

A preliminary investigation was made in May 1969, and reported by memorandum May 21, 1969. The bottom third or half of concrete in the affected portion, Span …

Locating And Tracing Seepage Water In Unstable Slopes, Yasin A. Alkhoja, Gordon D. Scott

Kentucky Transportation Center Research Report

With the increase in modern highway construction, the occurrence of landslides has been growing proportionally due to the use of deeper cuts and higher fills. It has been observed that landslides on highways often occur in fills on hillsides. Accumulation of water in the embankment, usually seeping from a nearby hill, may reduce the shear strength of the embankment soil and result in failure at a later time. Many landslides on Kentucky highways have occurred a few years after construction and obviously have been caused by the gradual weakening of the embankment due to a damming and accumulation of water. …

Slip-Form Paving, Kerry P. Magan

Kentucky Transportation Center Research Report

The proper placement, consolidation, and finishing of low-slump concrete without the aid of pre-erected side, forms has been widely acclaimed as an economical and effective procedure in the construction of portland cement concrete pavements. This construction procedure, commonly referred to as slip-form paving, depends upon the ability of low-slump concrete to remain in place after consolidation and removal of forms.

Slip-form pavers differ from conventional pavers in that no fixed side forms are required inasmuch as the slip-form paver has side forms that advance with the machine. Concrete is merely deposited on the prepared subgrade in front of the machine, …

Weighing Vehicles In Motion [1969], University Of Kentucky Research Foundation

Kentucky Transportation Center Research Report

An agreement between the Kentucky Department of Highways and the University of Kentucky Research Foundation, dated March 15, 1969, extended and continued research on Weighing Vehicles in Motion. The agreement contained these objectives of the continuing research:

"The services provided by the FOUNDATION shall be within the scope of the objectives outlined in the original proposal and made a part of the original contract (Research Project KYHPR-61-27, Development of an Electronic Means of Weighing Vehicles in Motion, a part of the DEPARTMENT'S Work Program, HPR-1, Part II). The research shall consist of, but not limited to, the following:

A. Furnishing …

Engineering Geognosy Of Warren County, Jerry G. Pigman, Tommy C. Hopkins

Kentucky Transportation Center Research Report

Engineering soils and geologic maps are proving to be invaluable to engineers, industrial leaders, community planners, and administrators during the preliminary stages of planning and site selection. Quantitative engineering data on soils and geological formations, and the interpretation of these data, are important factors to consider in developing the best land-use plans and providing stable foundations for highways, buildings, and other structures, such as dams. Information of this type, when available, is being used by public and private organizations in planning urban development. Engineering soils and geologic maps can be used to great advantage in four major ways by planners …

Engineering Geognosy Of Boyd County, Tommy C. Hopkins, Jerry G. Pigman

Kentucky Transportation Center Research Report

Engineering soils and geologic maps are proving to be invaluable tools of engineers, industrial leaders, community planners, and administrators during tbe preliminary stages of planning and site selection for major construction projects and the development of plans to use nature's basic resource--the land. Quantitative engineering data for soils and geological formations, and the interpretation of tbese data, are important factors to consider in the best land-use plans and in providing stable foundations and proper usage of earth materials for highways, buildings, and other earth structures. Engineering soils and geologic maps can be used to great advantage by planners and engineers …

The Irish Plumbing And Heating Engineer, June 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

The Irish Plumbing And Heating Engineer, May 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

The Irish Plumbing And Heating Engineer, March 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

The Irish Plumbing And Heating Engineer, April 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

Settlement Of Highway Bridge Approaches And Embankment Foundations, Tommy C. Hopkins

Kentucky Transportation Center Research Report

The nature and causes of the differential settlement between a bridge deck and the adjoining highway pavement have been studied by only a few investigators. Highway engineers often attribute this fault in the riding surface to the settlement of the embankment because of the improper placement and compaction of material in the approach embankment. Although there exists suggestive evidence that this condition produces the bridge approach fault, no conclusive evidence has been presented which shows this to be the primary source of settlement. Jones (1), Bishop (2) and Deen (3) suggest that differential settlement between the bridge deck and approach …

The Irish Plumbing And Heating Engineer, February 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

The Irish Plumbing And Heating Engineer, January 1969 (Complete Issue)

Building Services Engineering

No abstract provided.

Flexible Pavement Design Criterion, James H. Havens

Kentucky Transportation Center Research Report

Our recent report on "Rational Analysis of Kentucky Flexible Pavement Criterion," November 1968, presented theoretical treatments of current design curves – which enabled transformation of the current curves into companion sets of curves embodying alternative proportions of bituminous concrete and dense-graded aggregate base. We are privileged now to submit additional analytical information and to offer recommendations for revising the present design criterion.

Hot Mix Sand Surfacing, James H. Havens

Kentucky Transportation Center Research Report

Everyone has some compassion toward drivers who become victims of pavement slipperiness. The development of slipperiness on a road surface follows one of the laws of nature. Why not, then, employ other laws provided by nature to better advantage? For example, craftsmen use grinders, abrasives, buffers, etc. to achieve glossy surface finishes. Traffic does the same to our pavements. We might employ craftsmens' routine in reverse -- that is, roughen the surface. Better still, the principles that are apparent in a grinding wheel or whetstone may be used as a model for our pavement surface: a material of hard, abrasive …

Rational Analysis Of Kentucky Flexible Pavement Design Criterion, Herbert F. Southgate, Robert C. Deen, James H. Havens

Kentucky Transportation Center Research Report

Rational criteria for the structural design of pavements are emerging from classical theories equated to the observed behavior of real pavements. Pavement behavior is known to be affected by traffic, variations in soil support, and variations of component thicknesses. Considerable attention has been devoted to the mechanistic response of pavements to static and dynamic loads and to the development of theoretical design procedures, which rely, in part, on the computation of certain critical stresses, strains, and(or) deflections in the structure. A computer program (1) for the elastic analysis of multilayered pavement systems has enabled an extensive investigation of the effects …

Proposed Experimental Design And Construction Features, Kentucky Department Of Highways

Kentucky Transportation Center Research Report

PURPOSE AND OBJECTIVES: The experimental features proposed in connection with this project are three-fold: the first pertains to subsurface drainage of the pavement system, the second pertains to the feasibility of constructing full-depth, asphaltic concrete pavement sections directly on subgrade material -- rock or soil; the third pertains to the structural design and performance of pavement sections employing designated substitutions of bituminous concrete dense-graded aggregate base.

Landslides In Kentucky, Robert C. Deen, James H. Havens

Kentucky Transportation Center Research Report

The reoccurrence of certain features of landslides in Kentucky suggests that the difficulties in the State can be readily classified. Because of this repetitive nature, one can be alerted to the possibility of slides in certain situations early in the planning and design stages of the facility to be constructed. Thus, the traveling public might be spared the inconvenience illustrated in Figure 1. Enough cannot be said concerning the necessity for having adequate soils and geological information concerning possible routes for highway locations, and a review of a number of landslides in Kentucky suggests that there are certain troublesome geologic …

Discussion On Skid Resistance Of Pavement Surfaces, Rolands L. Rizenbergs

Kentucky Transportation Center Research Report

The concern for adequate skid resistance or friction of pavement surfaces is confined to wet weather conditions. Dry pavements are highly skid resistant unless the surface contains loose material, such as gravel, sand, etc., which could provide rolling action by the particles under the tires. Surface contaminates, such as oil, soft tars and asphalt, etc., could also provide lubrication to the surface and create a slippery condition. Normally, however, water is the lubricating agent reducing pavement friction and in some cases creating very hazardous driving conditions. Another situation of concern is drainage, or lack of proper drainage, of the pavement. …

I-75 Kenton County Slide, Herbert F. Southgate

Kentucky Transportation Center Research Report

No abstract provided.

Determination Of Traffic Parameters For The Prediction, Projection, And Computation Of Ewl’S, John A. Deacon, Robert L. Lynch

Kentucky Transportation Center Research Report

One of the first published methods for the structural design of highway pavements was called the Massachusetts Rule and was presented in the eighth annual report of the Massachusetts Highway Commission in 1901 (1). The essence of this procedure was a rather intuitive assumption concerning the distribution of vertical pressures beneath a loaded area. For design purposes, this required the selection of a design load which, since failure was assumed to be catastrophic and not cumulative, could be taken as the largest load that could reasonably be anticipated during the design life of the pavement. The prediction of such a …

Equivalent Axleloads For Pavement Design, John A. Deacon, Robert C. Deen

Kentucky Transportation Center Research Report

Proper structural design of highway pavements requires an evaluation of the destructive effects of the anticipated vehicular loading. The concept of load equivalency provides a means for expressing these destructive effects in terms of a single measure, the equivalent axleloads (EAL's). The design EAL's represents the equivalent number of applications of a standard or base axleload anticipated during the design life.

Experimental Applications Of Protective Coatings To Shales Exposed In Highway Cuts, James H. Havens

Kentucky Transportation Center Research Report

Many shales exposed in roadway cut-sections are susceptible to weathering, slaking, and erosion; fallout and taluses clog drainage; benches overflow; and occasionally landslides or rockslides develop. Presently, in design, certain types of shales and even named formations are afforded wider benches than others; soil mantles at the tops of cuts are being stripped back farther; and, of course, sound ledge-rock offers the preferred type of bench-cap. Pre-splitting methods of blasting have greatly enhanced the appearance of cuts and have minimized the shattering of cut faces. The resulting surfaces frequently are quite smooth when first exposed and remain so if the …

Performance Of A Reinforced Concrete Pipe Culvert Under Rock Embankment, Robert C. Deen

Kentucky Transportation Center Research Report

A 48-inch diameter reinforced concrete pipe installation has been observed in order to evaluate the performance of both types of bedding conditions as currently used by the Kentucky Department of Highways. A portion of the pipe was laid using Kentucky's Standard B Bedding. The remainder of the pipe culvert was laid using the B₁ Bedding (imperfect trench); the design height of the fill (36 feet) was sufficient to require the imperfect trench construction. The embankment was primarily of a rock fill material, with the largest particle size limited to a maximum of 3 feet. The portion of the pipe …

Durability Of Culvert Pipe, James H. Havens

Kentucky Transportation Center Research Report

Almost twenty years ago the Department began to develop durability data on types of culvert materials. In the interim, various stopgap as well as very judicious policies have issued. The present criterion or design practice applicable to Federal Aid projects was affirmed by the Bureau of Public Roads, May 24, 1965. Extensive field surveys have been conducted; various design innovations have been employed; and a "hot" test site has, in a demonstrative way, provided critical life-expectancy records. All past history had been documented previously; however, a brief retrospective summary will provide some continuity between forethought and certain issues now maturing.

A Concrete Pavement Without Transverse Joints [July 1968], Ronald D. Hughes

Kentucky Transportation Center Research Report

In 1949, a 5.737-mile section of portland cement concrete pavement was constructed without the inclusion of transverse joints. The project, designated as Fl 239(4), is a section of US 31W located in Simpson County extending from the Tennessee line (Sta 9+11) to the south city limits of Franklin (Sta 311+40). The pavement is 22 feet wide, 8 inches thick, and is underlain by 1-1/2 inches of compacted No. 10 crushed limestone for insulation and leveling. Air-entraining cement was used and the concrete was placed with approximately 4-1/2 percent entrained air. One-half inch deformed tie bars were used in the longitudinal …

Temperature Distribution Within Aspalt Pavements And Its Relationship To Pavement Deflection, Herbert F. Southgate, Robert C. Deen

Kentucky Transportation Center Research Report

No abstract provided.

Bridge Paint Specifications, Proposed Revisions, James H. Havens

Kentucky Transportation Center Research Report

During the past several years, I have devoted considerable attention and study to bridge-paint systems and specification -- in an attempt to keep abreast with developments and current practices throughout the country. My first proposal (July 30, 1958; copy appended) was motivated by development of a then-new rust-inhibitive pigment suggested by National Lead Company. The pigment had shown considerable promise as a substitute for red lead and appeared in many respects to be superior to red lead -- on of which was economy.

Construction And Performance Of Trial Section Of Treated Shoulders On The Mountain Parkway Extension, Robert L. Florence, Tommy C. Hopkins

Kentucky Transportation Center Research Report

In October 1966, J.W. Spurrier, Assistant Operations Management Engineer, requested that the Research Division make a study of a two-mile section of the shoulders on the Mountain Parkway Extension in Wolfe County (from Mile Post 43.8 to Mile Post 45.8) and make recommendations for design and construction procedures for cement stabilization of the shoulders. In compliance with this request, in January 1967, Research Division personnel made a survey of the full length of shoulder on the Mountain Parkway Extension. Included in this survey were measurements of depth of the dense graded aggregate, penetrations of the shoulder subgrade soil and samples …

Investigation Of Use Of Preformed, Compressed Neoprene Seals In Joints Of Concrete Bridge Decks, Dennis L. Willaman

Kentucky Transportation Center Research Report

Progressive deterioration and staining of concrete bridge substructures and erosion of abutments may, in many instances, be attributed to the leakage of bridge deck joints. The primary difficulty in maintaining a properly sealed joint is the continual expansion and contraction of the bridge spans. Joint seals, of course, must remain in contact with both faces of the disjointed sections and remain flexible at all temperatures encountered.

A study was initiated by the Division of Research for the specific purpose of evaluating the performance of preformed, compressed neoprene seals and to compare the performance of these seals with the performance of …