Engineering Commons^™

Technology For Improving The Quality Of Graphite Enrichment By Chemical Treatment, Baxtiyor S. Sadullayev, Abror S. S. Usmonov

CHEMISTRY AND CHEMICAL ENGINEERING

No abstract provided.

On The Possibility Of Using Qiziltepa Bentonite In Drilling, Farrukh B. Erkinov, Biloliddin B. Qobilov, Mukhammadamin Sh. Jololdinov

CHEMISTRY AND CHEMICAL ENGINEERING

The aim of the study was to investigate the possibility of using natural bentonite samples obtained from the Qiziltepa district of Navoiy region in drilling operations. Within the scope of the study, the chemical and mineralogical compositions of the bentonite were determined using X-ray diffraction (XRD) and X-ray fluorescence (XRF) analysis methods. In addition, several enrichment methods for bentonite were tested under laboratory conditions. These included magnetic separation of the bentonite suspension formed with water, washing, and acid washing using oxalic acid for chemical enrichment. The chemical and mineralogical composition of the resulting samples was reanalyzed, relevant tables were compiled, …

Peculiarities Of Preparation Of Nanostructured Cerium-Doped Lutetium-Aluminium Garnet Powders Prepared By Sol-Gel Combustion Method, Eygeniy N. Poddenezhny, Ekaterina E. Trusova, Andrei A. Boiko, Vladimir S. Urbanovich

CHEMISTRY AND CHEMICAL ENGINEERING

The aim of the work is to study a new method of thermochemical synthesis of luminescent powder of lutetium-aluminium garnet activated by cerium ions (Lu₃Al₅O₁₂:Се³⁺) using nitric acid salts of lutetium, aluminium and cerium, and a mixture of acetic acid and polyvinyl alcohol as a propellant. The synthesis process was carried out in a muffle furnace at an initial temperature of 350 ºC under conditions of limited presence of atmospheric air. The average size of the coherent scattering region for Lu₃Al₅O₁₂:Се³⁺ obtained from the combustion …

Evaluation Of Coal Properties Used In A Cement Plant, Geun-Seong Lee, Farrukh B. Erkinov, Mastura Kh. Aripova

CHEMISTRY AND CHEMICAL ENGINEERING

Coal is not only a heat source for clinker burning but also the coal ash after combustion plays a large role in the quality of clinker mixed with hot meals in the kiln. Since the properties of coal vary depending on the coalification and environment in which it was sedimented, the quality of coal supplying to cement plant can change greatly depending on the coal seam even if it is from the same coal mine. Therefore, the coal used in a cement plant should have its properties measured accurately through representative sampling whenever it is supplied to the plant, and …

Preparation Of Nano-Sized Silver Particles By Electrolysis From Silver-Containing Electrical Scrap, Umar A. Yakhyaev, Mastura Kh. Aripova, Ripsime V. Mkrtchyan, Dilrabo A. Mukhtorova

CHEMISTRY AND CHEMICAL ENGINEERING

The aim of the study was preparation of nanosized silver particles by electrolysis from silver-containing scrap from electrical engineering production. For this purpose, at the first stage, silver particles with a size of 0.2–2 microns were obtained by the cementation method, confirmed by the results of scanning electron microscopy. A silver anode for the electrolysis unit was created from the obtained silver particles by the melting method. At the second stage, electrolysis was carried out on a unit with rotating electrodes, in which the cathode was made of platinum. Optimum conditions for the electrolysis process, carried out at a voltage …

Synthesis Of Neodymium Oxide Nanotubes Via Chemical Deposition Followed By Thermal Treatment, Odiljon E. Abdurakhmonov, Mastura Kh. Aripova, Sherzod E. Abdurakhmonov, Zaynobiddin T. Matkarimov, Sultan Kh. Suleymanov, Natalya A. Kulagina

CHEMISTRY AND CHEMICAL ENGINEERING

The aim of this work is to synthesize Nd₂O₃ nanotubes via chemical deposition followed by thermal treatment. Nd(OH)₃ nanotubes were synthesized using Nd(NO₃)₃ as a precursor and NaOH as a precipitant. After thermal treatment, crystalline Nd₂O₃ nanotubes were obtained. Thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC) were conducted to study the thermal effects and phase transitions during the synthesis. X-ray phase analysis (XRD) was used to determine the phase composition and crystal structure. In addition, the construction of the crystal lattice structure is carried out using programs.The morphological characteristics …

Anhydrous Ammonia As A Hydrogen Carrier Fuel For Solid Oxide Fuel Cells, Cole Anthony Wilhelm

Dissertations - ALL

In the years since humans realized that our actions could have profoundly harsh effects on the environment, we have been searching for ways to minimize our impacts, while also maintaining the same standard of living. One of the actions with such effects is power generation using fossil fuels, which has long been the largest source of energy. While efforts should be made to improve the efficiency of these power generation plants, we should also work to identify alternative opportunities for power generation without the use of fossil fuels. Some of these opportunities include hydroelectric, photovoltaic, wind, nuclear, and the combustion …

Dynamic Resource Allocation For Wireless Networks And Radar Systems Via Deep Reinforcement Learning, Ziyang Lu

Dissertations - ALL

The rapid advancement of wireless communication technologies and the proliferation of smart devices have led to increasingly complex and dynamic network environments. These developments have posed significant challenges to traditional radio resource management (RRM) techniques, which often struggle with scalability, adaptability, and real-time decision-making. In response to these limitations, this dissertation explores the application of advanced machine learning, particularly deep reinforcement learning (DRL), to develop intelligent, adaptive, and data-efficient solutions for resource management in wireless networks and radar systems. We begin by addressing joint channel access and power control in wireless interference networks using centralized, distributed, and federated multi-agent DRL …

Poly(Pyridinium Salt)S Containing 9,9-Bis(4- Aminophenyl)Fluorene Moieties With Various Organic Counterions Exhibiting Both Lyotropic Liquid-Crystalline And Light-Emitting Properties, Pradip K. Bhowmik, David King, Haesook Han, Andras F. Wacha, Matti Knaapila

Chemistry and Biochemistry Faculty Research

Main-chain conjugated and non-conjugated polyelectrolytes are an important class of materials that have many technological applications ranging from fire-retardant materials to carbon-nanotube composites, nonlinear optical materials, electrochromic materials for smart windows, and optical sensors for biomolecules. Here, we describe a series of poly(pyridinium salt)s-fluorene containing 9,9-bis(4-aminophenyl)fluorene moieties with various organic counterions that were synthesized using ring-transmutation polymerization and metathesis reactions, which are non-conjugated polyelectrolytes. Their chemical structures were characterized by Fourier transform infrared (FTIR), proton (1H) and fluorine 19 (19F) nuclear magnetic resonance (NMR) spectrometers, and elemental analysis. They exhibited polyelectrolytic behavior in dimethyl sulfoxide. Their lyotropic liquid-crystalline phases were …

Grades Are Bugs, Jordan Freitas

Computer Science Faculty Works

This paper argues that grades are bugs in our educational system, undermining desired behaviors and outcomes. Grades were introduced into higher education for purposes directly at odds with the goals of inclusive pedagogy today, as well as the neuroscience of human motivation and learning. Students enter computer science programs from increasingly varied backgrounds and experiences, and face a rapidly evolving landscape of prospective career paths while higher education costs in the United States are ever increasing. Computer science educators have a responsibility to adapt and carefully re-examine typical approaches to all aspects of the learning environments we build and curricula …

High-Frequency Impedance Spectroscopy: Measurement Reproducibility, Electromagnetic, And Ionic Effects In Cylindrical Lithium-Ion Cells, Matthew R. King, Paul T. Coman, Rafid Mollah, Md Rayhan Khan, Saranraj Karuppuswami, Taylor R. Garrick, Ralph E. White

Faculty Publications

Accurate high-frequency electrochemical impedance spectroscopy (HF EIS) is critical for understanding lithium-ion battery (LIB) behavior under AC perturbations, relevant to electric vehicle systems and charging infrastructure. However, measurements at high frequencies are often distorted by external electromagnetic interference, poor contact quality, and wiring artifacts. This study investigates four experimental testbench configurations for HF EIS of cylindrical LIBs, highlighting the impact of contact resistance, Faraday shielding, wire twisting, and calibration. A coupled electrochemical-electromagnetic model is developed to isolate and analyze the skin effect and frequency-dependent electrolyte conductivity. Results show that spot-welded connections, twisted and shielded wiring, and calibration within a Faraday …

Corrosion Mitigation And Monitoring Of Bridge Tendons And Failure Forecasting Of Wastewater Force Mains, Stanley Chike Agbakansi

USF Tampa Graduate Theses and Dissertations

Corrosion remains a significant threat to civil infrastructure, resulting in costly repairsand potential structural failures. This dissertation addresses three critical aspects of corrosion: mitigation and monitoring of post-tensioned bridge tendons, and failure forecasting of wastewater force mains due to internal corrosion.

First, the research investigates the effectiveness of corrosion inhibitors (CIs) applied via pressure injection (impregnation) in post-tensioned tendons. The protective mechanisms and long-term performance of various inhibitors were evaluated to identify the most effective formulations. Among the tested inhibitors, MCI-2020 — a water-based, migratory, mixed-type corrosion inhibitor — demonstrated the most promising results, showing excellent corrosion protection while preserving …

Keynote: Robotizing The Picking And Sorting With Grabtm And Sorttm, Lars Eilertsen

International Material Handling Research Colloquium

No abstract provided.

Paving The Way For The Future Of Robotic Compact Storage And Retrieval Systems: An Innovative Conceptual Design, Mahmut Tutam

International Material Handling Research Colloquium

No abstract provided.

A Multi-Model Tool For Evaluating Sustainability Levels Of Last Mile Logistic Services Developed By Drones, Maria Grazia Gnoni, Fabiana Tornese, Lorenzo Rubrichi

International Material Handling Research Colloquium

No abstract provided.

Estimating Order Picking Distances Using Machine Learning, Hector J. Carlo, Carlos A. Morel-Figueroa, Victoria Méndez-González, Yamilette Boscio-Sánchez, Alex Demel-Pacheco

International Material Handling Research Colloquium

No abstract provided.

Enhancing Social Sustainability In Parcel Hubs Using Discrete Event Simulation And Multi-Objective Optimization, Harald Steinkellner, Domenik Kaever, Christoph Rockenschaub

International Material Handling Research Colloquium

No abstract provided.

Throughput Comparison Between An Amr-Based Sorting System And A Loop Sorter: A Case Study On High-Performance Parcel Sorting, Moritz Roidl

International Material Handling Research Colloquium

No abstract provided.

Supply Chain Robustness And Resilience Modeling Using Bayesian Networks, Md Sarder, Seyedmohsen Hosseini

International Material Handling Research Colloquium

No abstract provided.

Assess Picker Postural Risk Using Real-Time Posture Estimation Technology (Openpose) For Robotic Mobile Fulfillment Systems, Ching-Jung Ting, Tzu-Heng Kao, Kuan-Ting Liu

International Material Handling Research Colloquium

No abstract provided.

Machine Learning Approach For The Operation Of Puzzle-Based Storage Systems, Tal Raviv, Yossi Bukchin

International Material Handling Research Colloquium

No abstract provided.

Autonomous Mobile Robots Amrs Equipped With Picking Robot For Order-Picking In Storage Rack, Tone Lerher, Jakob Marolt, Luka Bizjak, Boris Jerman

International Material Handling Research Colloquium

No abstract provided.

Proof-Of-Concept Implementation Of A Drone-Enabled Material Handling System In Manufacturing, Julio Jimenez-Sarda, Daniel F. Silva, Alice E. Smith

International Material Handling Research Colloquium

No abstract provided.

Considerations For Implementing Ai In Warehousing Environments, Irma Adams, Nicolas Iman, Natalie S. Cherbaka

International Material Handling Research Colloquium

No abstract provided.

Tactical Recovery Planning In A Strategic Single-Sourced Supply Chain After Disruption, Sarvesh Gore, Jose D. Porter Phd

International Material Handling Research Colloquium

No abstract provided.

Shared Autonomy Open Logistics Systems: Definitions, Examples, And Related Literature, Jennifer Pazour

International Material Handling Research Colloquium

No abstract provided.

Algorithmic Approaches To Path Planning For Collaborative Robot-To-Robot Picking, Christopher Reining, Pia Schreynemackers, Niklas Jost, Alice Kirchheim

International Material Handling Research Colloquium

No abstract provided.

Circular Thinking In A Technological Age: Designing For A Regenerative Future, Mohammed Ali Berawi, Perdana Miraj, Mustika Sari

CSID Journal of Infrastructure Development

Architecture, engineering, and construction sector is experiencing challenges related to environment and economic aspects. It consumes vast amounts of resources and energy and contributes heavily to global carbon emissions. Academics and industry leaders are trying to explore various strategies to combat climate change by shifting toward circularity. It is a systems-based approach that prioritizes regenerative design, responsible consumption, and closed-loop resource use. At the heart of this shift lies the interplay between circularity, technology, and the environment that can reshape how we live, produce, and consume. But this transformation is not simply about adopting greener practices; it’s about rethinking the …

The City As The Classroom: The Case Of “Start ‘Em Young Advocacy” At Silliman University, Philippines, Novee Elarmo Maestrecampo Jr., Giovanni Tuballa Macahig

CSID Journal of Infrastructure Development

This case study highlights the value of engaging with communities as real-world environments for practical and reflective learning. It suggests that students can develop insights and acquire knowledge through interactions with diverse groups and locations, even within urban settings. The paper presents the experience of implementing the “Start ‘em Young Advocacy,” a student-led, environment-focused, and project-based initiative within the Civic Welfare Training Service (CWTS) under the National Service Training Program (NSTP) at Silliman University, Philippines. In collaboration with the City Social Welfare and Development Office (CSWDO), CWTS students worked with thirty daycare centers. Using Kolb’s Experiential Learning Theory as a …

Barriers To Learning Exposure In Construction 4.0: Perspectives From Built-Environment Students, Olajide Julius Faremi, Habeeb Abiodun Arowolo

CSID Journal of Infrastructure Development

The ongoing digital transformation of the construction industry, known as Construction 4.0, requires students in built-environment programs to gain adequate exposure to emerging technologies. Despite this need, many faces significant barriers to meaningful engagement. This study explores the factors limiting students’ learning experiences related to Construction 4.0 in Nigerian universities and polytechnics. Using a stratified random sampling method, 154 students from one university and one polytechnic were surveyed through a structured questionnaire. Data were analyzed using frequency distribution, relative importance index, and the Mann-Whitney test. Results identify key obstacles such as limited peer collaboration, insufficient funding and resources, and weak …