Engineering Commons^™

The Sorption Of Metallic Ions By Wood Pulp During Purification, Harold Edgar Boyd

Masters Theses

"The cost of producing cellulose acetate, and the difficulties attending its dissolving, plasticizing, and application to specific uses are problems which must be investigated before the ultimate commercial development of the material can be realized. The price of the cellulose used as raw material for acetylation is one of the primary factors influencing the cost of the finished product. At present, cotton linters constitutes the chief practical souce [sic] of acetate, being almost pure alpha-cellulose, and cheaper than staple cotton, our other source of high alpha-cellulose, Wood pulp is the only other material offering promise as a substitute for cotton, …

Laboratory Concentration Of A Lead-Zinc-Fluorspar Ore From Southern Illinois, Shiou-Chuan Sun

Masters Theses

"The purpose of this investigation was to ascertain the feasibility of preparing marketable products from a rather complex sulphide-fluorspar ore"--Object, page 2. "The ore was examined exhaustively by chemical, microscopic, and mineralogical methods of analysis. After a thorough knowledge of the physical characteristics of the ore had been obtained, flotation concentration tests were made to separate the sulfide minerals from the fluorspar and to attempt to prepare lead-zinc and fluorspar concentrates of marketable grade"--Scope of Work Done, page 2.

Test 313: John Deere L, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere L

TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear.

This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated.

BELT HORSEPOWER TESTS

TEST …

The Effect Of Varying The Malt Concentration And The Ph On The Conversion Of Starch In Corn., Gerald L. Veeneman

Electronic Theses and Dissertations

No abstract provided.

The Loss In Drying Power Of Black Paints Due To Aging., J. E. Rose

Electronic Theses and Dissertations

No abstract provided.

The Development Of A Zinc Phosphate Dental Cement., D. O. Myatt

Electronic Theses and Dissertations

No abstract provided.

The Effect Of Carbon Pigments On Drying Of Linseed Oil., H. A. Bennett

Electronic Theses and Dissertations

No abstract provided.

Comparison Of Ethyl Cellulose And Nitrocellulose In Lacquers., William Wilson Pedersen 1916-2006

Electronic Theses and Dissertations

No abstract provided.

Factors Involved In Improving The Blush Resistance Of Lacquers., Franklin D. Snyder

Electronic Theses and Dissertations

No abstract provided.

Heat Transfer Studies Of A Hydrocarbon Oil., W. R. Barnes

Electronic Theses and Dissertations

No abstract provided.

Freestone County, Texas [Water Quality Survey Of Wells And Springs With Test Hole Data, 1936], Samuel F. Turner

United States Geological Survey: Water Reports and Publications

Introduction

The purpose of this survey was to obtain information concerning existing wells and springs and the quantity and quality of water they yield, and to put down test holes where additional information was needed.

This project was part of a statewide Works Progress Administration project known as a "Statewide Inventory of Water Wells," sponsored by the [Texas] State Board of Water Engineers. The Division of Ground Water of the United States Geological Survey cooperated in the technical direction of the project and the Bureau of Industrial Chemistry of the University of Texas furnished laboratory space and equipment and supervised …

The Control Of The Grain Size Of Tin., Robert D. Macdonald

Bachelors Theses and Reports, 1928 - 1970

The tin alloys of tellurium are extremely hard and have very great tensile strength. It was thought that the reduction of the rate of grain growth of tin with the addition of tellurium accompanied this hardening and strengthening and such way found to be true.

The Electroplating Of Cadmium From Sulfate Solutions, Lewis S. Prater

Bachelors Theses and Reports, 1928 - 1970

It has been proven that cadmium forms a very satisfactory plate on steel, which has to withstand severe corrosion, especially the corrosion of sea water and spray. The metal is now successfully plated electrolytically from cyanide solutions, but wherever work is carried on with cyanide, there is great danger of poisoning to the workers.

The Inhibitory Effects Of Carbonaceous Materials On The Cyaniding Of Gold Ores., David Currie Jr.

Bachelors Theses and Reports, 1928 - 1970

Carbon and carbonaceous material have been known to have a deleterious effect upon the cyanidation of gold and silver ores since the very beginning of the process. Organic matter is a common source of impu­rities in cyanide solution, its reducing effect being notorious.

The Electrical Conductivity Of The Copper-Aluminum Alloys., William W. Hintalla

Bachelors Theses and Reports, 1928 - 1970

Among the many aluminum alloys which have been studied are the binary copper-aluminum alloys. These have proven to be among the most useful of the alumi­num alloys thus far worked upon.

The Effect Of Temperature On The Rate Of Dissolution Of Gold In Cyanide Solutions Which Have A Constant Oxygen Content., Robert Currie

Bachelors Theses and Reports, 1928 - 1970

Since the development of cyanidation into a highly efficient process for treating gold ores, many papers have been written on its various aspects. Although, there has been much work done on it, the chemistry of the reaction is not yet completely understood.

The Presence Of Rhenium In Montana Manganese Ores., Henry E. Swanson

Bachelors Theses and Reports, 1928 - 1970

Rhenium properties offer many interesting possibilities, therefore any ores containing rhenium would be of considerable value. Its close relationship to manganese in the periodic table led to the belief that manganese ores would be an excellent place to search for the metal. Investigation of the literature of rhenium revealed that no ore was known to contain more than 0.001 per cent of rhenium.

The Electrowinning Of Copper From Roasted Sulphides, Thomas B. Linn

Bachelors Theses and Reports, 1928 - 1970

A hydrometallurgical process for the recovery of copper from flotation concentrates has long been con­sidered an attractive possibility. The object of such a method is to produce electrolytic copper without resorting to expensive matte smelting and converting.

Electrolytic Recovery Of Copper And Zinc From Brass, D. H. Swank

Bachelors Theses and Reports, 1928 - 1970

The purpose of this research was to continue the work of Thomas Parker, who worked on the recovery of copper and zinc from brass during the school year l934 - 1935. Since there is such a wide variety of brasses made with usually a third alloying constituent, remelt­ed scrap is suitable only for castings of wide tolerance in specifications.

Geology Of The Tuxedo Mining District, R. W. Lawson, B. R. Tarrant, A. L. Gallagher

Bachelors Theses and Reports, 1928 - 1970

The Tuxedo mining district lies fifteen miles west of Butte on the south east end of Deer Lodge valley. Prospecting and mining has been carried on in this district for about 20 years. As a result many pits have been dug, several adits have been driven, and two or three shallow shafts have been sunk.

The Deposition Of Monomolecular Films., Albert Wilbur Schlechten

Bachelors Theses and Reports, 1928 - 1970

The formation of monomolecular films is possible because of the action of the heteropolar molecules of certain fatty acids, especially stearic. Under the proper conditions the acid will spread out until a monomolecular film is formed.

Test 288: Cletrac Model Bd, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 290: M-M Twin City Model Zt, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 292: Huber Model B, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 293: Massey-Harris Twin Power Challenger, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Development And Operation Of The Universal Coal Mine, Clinton, Indiana, Horace Herbert Clark

Professional Degree Theses

No abstract provided.

Line And Grade Control Of The Subaqueous Midtown Hudson Tunnel, Lauren Preston Tuttle

Professional Degree Theses

"The entire system unifies all Preliminary Survey, Construction Control, and Independent Traverse work; bringing them under one common balanced system; thus, their precise relation is definitely established regardless of which side of the Hudson River the unit occurs. The establishing of a complete system is a subject within itself, and as this paper deals with the method of obtaining and carrying to completion the method of control for the river section of the tunnel, we shall limit our reference to the Triangulation system to the River Quadrangle"--Triangulation System. General, page 1.

Highway Bridges, Design And Cost, John Edward Kirkham

Professional Degree Theses

"Specifications for highway bridges have been modified considerably during the past 15 years. The principal modifications have been the result of the continuous development of motor traffic. The principal changes made have been with reference to live load, impact, and allowable unit stresses. The live load has been changed to conform with the increased weight of modern motor traffic; impact has been included to provide for the effect of heavy fast-moving trucks; and the change in unit stresses has resulted by agreement of engineers. The following specifications, which will be used herein, are practically excerpts from "Specifications for Highway Bridges," …

Manufacture And Application Of Rubber Belting, Lynn Harbison

Professional Degree Theses

"Rubber belting is one of the major products manufactured by the rubber companies and a wide variety of applications is found among many industries. These applications require belts which will meet the needs of the purchasing party both from a cost and a maintenance viewpoint. Belts are installed and operated for two basic purposes, namely, transmission of power and conveyance of level...Transmission and conveyor belting are fundamentally the same for one important factor; this factor is power transmission. Other data are necessary to make and select a belt of the proper type, construction and size. The subject of rubber being …

Design And Construction Of Ponds And Small Reservoirs, Harry Franklin Bossert

Professional Degree Theses

"In presenting this paper, "The Construction of Ponds and Small Reservoirs", the writer wishes to call attention to a report by the National Resources Committee entitled "Little Waters : A Study of Headwater Streams and Other Little Waters: Their Use and Relation to the Land"--Introduction, page 5.