Engineering Commons^™

Baseband Agc In An Am-Fm Telemetry System, Richard S. Simpson, William H. Tranter

Electrical and Computer Engineering Faculty Research & Creative Works

The use of AGc loops at the input and output of the FM link in an AM-FM telemetry system allows the mean-square transmitter deviation to be maintained near maximum value, even though data may be nonstationary. However, errors result because of the inability of the receiver AGc loop to track perfectly gain variations in the transmitter loop. In this paper the general characteristics of AGc are discussed, and a theoretical analysis is performed to determine the time constant, steady-state error, and tracking error for a first-order loop. Also, tracking error for first order and second-order loops is investigated by simulation. …

Patent Drawing, John L. Byers

Graduate Research Papers

This study is concerned with an investigation of procedures and methods for patent drawings. Specifically, the study involves research in standards of acceptable patent drawings, their proper execution, necessary materials, type of training needed to become a patent draftsman, and the location of available source of training.

A Predictive Model For Travel Times On Two-Lane State Highways : Progress Report, Salim Said Hejal, Harold L. Michael

JTRP Technical Reports

No abstract provided.

A Study Of The Composite Action Of Light Gage Steel Deck And Concrete, Charles Sherman Bach Jr.

Masters Theses

"This thesis is on the investigation of corrugated light-gage steel sheets used as the tension reinforcement for concrete slabs. The steel sheets used had embossments placed at uniform intervals over the entire length of the sheets. The composite concrete and light-gage deck steel were tested to determine a method of design for this type of composite section from an economical, safe and practical standpoint. The investigation covered the flexural, shear and bond capacity of this type of composite section"--Abstract, page ii.

Test 1050: John Deere 4320 Syncro Range, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 1054: Ford 2000 Gasoline 6-Speed (All Purpose), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Proceedings Of The Arkansas Academy Of Science - Volume 24 1970, Academy Editors

Journal of the Arkansas Academy of Science

No abstract provided.

Metallographic Study Of Phase Changes In Heat Treated Ductile Iron, Mahendra Vadilal Desai

Masters Theses

"Continuous cast ductile iron samples were hardened. It was found that carbide dissolved in the austenite faster than graphite and that this material requires higher austenitizing temperatures and longer austenitizing time than steels. Tempered microstructures were affected by the prior austenitizing treatment and it appeared that the amount of carbon dissolved in the austenite determined the tempered microstructure. Several attempts to determine the austenite grain size indicated that it is not as easy to determine in ductile iron as in steels. Two techniques, heat etching and an isothermal transformation method, were found to reveal prior austenite grain size. It was …

Mutually Dependent Heat And Mass Transfer In Laminar Tube Flow, Gary Alfred Scheffel

Masters Theses

"An investigation is performed of the mutually dependent heat and mass transfer in laminar and hydrodynamically fully developed gas flow in a tube. Sublimation of mass occurs at the tube wall so that heat and mass transfer take place between the wall and the flowing gas stream. The wall of the tube is thermally insulated from the external environment with the result that the heat of sublimation is supplied by convective transport from the gas. The solution of this problem requires the simultaneous consideration of the energy and diffusion equations, with coupling provided by the boundary conditions. Mathematical expressions are …

Probe Detection Of Microwave Perturbation In A Magnetoplasma, Show-Ran Peter Wang

Masters Theses

"When a microwave signal with a frequency near the electron upper hybrid resonance is applied to a magnetoplasma, it will excite the plasma. The perturbation of plasma can be detected by using Langmuir probes. The particular plasma used in this experiment is an argon discharge type and the density is relatively low (n~10⁸ cm⁻³). The electron temperature is about 7000º K. Because a magnetic field is applied to the plasma, it is necessary to use the probe theory in a magnetic field to calculate the electron number density from the electron temperature. In order to determine the electron upper hybrid …

The Anodic Dissolution Of Zinc In Potassium Chloride-Potassium Chlorate Solutions, Kuei Chun Chen

Masters Theses

"The anodic dissolution of Zn was studied in Cl⁻-Clo⁻₃; solutions at a temperature of 25ºC. It was found that the apparent valence of Zn ions going into solution was approximately the normal value of two at low current densities. An empirical equation was derived relating the apparent valence to the current density and both concentrations of Cl⁻ and Clo⁻₃. An anodic dissolution mechanism was proposed"--Abstract, page 1.

Degradation Of Polystyrene Solutions By Capillary Shear, Tyan-Faung Niu

Masters Theses

"An apparatus has been constructed to investigate the capillary shear degradation of polymer solutions. Maximum shear rates obtainable under flow conditions which could be characterized as nonturbulent were on the order of 10₅ sec⁻¹. The effect of calculated shear rate, initial molecular weight, and number of passes through the capillary tube on the degradation of polystyrene (with M̄_v from 22,000 to 1,770,000) solutions in toluene (0.1 wt.%) were studied. The tests in the 0.0105 in. ID stainless steel tube at a calculated shear rate of 1.36 x 10₅ sec⁻¹ show that, for equal number of passes, the lower the …

Magnetohydrodynamic Stability Of Laminar Flow In The Entrance Region Of A Parallel-Plate Channel, Thomas Eldon Eaton

Masters Theses

"The hydrodynamic stability of laminar flow of an electrically conducting fluid flowing in a parallel-plate channel with an applied transverse magnetic field is investigated. The linear perturbation theory of hydrodynamic stability along with the assumption of low magnetic Reynolds number is applied to the governing equations to derive the governing rnagnetohydrodynarnic stability equation. A finite difference scheme is employed to numerically solve the magnetohydrodynamic stability equation. Neutral stability characteristics of the flow in the entrance region are obtained and presented. The neutral stability characteristics of the fully developed Hartmann flow are also re-examined and compared with those of a previous …

A Study On The Feasibility Of Using Pipelines For The Collection And Transportation Of Urban Solid Wastes, William Leo Sago Jr.

Masters Theses

"This study was conducted to determine the technological feasibility of using a tube transport (pipeline) system to supplement and partially eliminate the present inadequate solid waste collecting and transporting techniques employed in most cities throughout the United States. Specific objectives were to develop a practical pipeline system for the transport of refuse by means of a fluid and to determine the uniformity of composition of refuse. The hydrodynamic characteristics of each transport medium, water and Chemical Emulsion., W-4088, were to be determined also. Another item of interest was the degree of grinding necessary to transport refuse by pipeline. An experimental …

The Evaluation Of Radar Guided Missile Performance Using Various Target Glint Models, Franklin Delano Hockett

Masters Theses

"A radar guided missile seeker approaching a target arrives at a crossover point beyond which the entire target is illuminated by the missile seeker's radar antenna beam. When this occurs, for a complex target, the radar senses a time changing target center location which may greatly complicate the terminal tracking portion of the seeker's flight. This thesis documents various glint models in use today and compares the performance of these models by using a seeker model to determine the effect of glint on terminal tracking performance. A large volume of data has been compiled describing various radar characteristics of complex …

Time And Load Independent Properties Of Bituminous Mixtures: Technical Paper, S. A. Swami, William Harner Goetz, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

Flow In Aggregate-Binder Mixes : Technical Paper, Egons Tons, William Harner Goetz, Virgil L. Anderson

JTRP Technical Reports

No abstract provided.

A Study Of Relative Costs Of Flexible Highway Pavements, Farideh Ramjerdi

JTRP Technical Reports

No abstract provided.

Analysis Of Concrete Slabs On Ground And Subjected To Warping And Moving Loads: Technical Paper, Karl Harcourt Lewis, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

A Generalized Investigation Of Selected Highway Design And Construction Factors By Regional Geomorphic Units Within The Continental United States, Matthew W. Witczak

JTRP Technical Reports

No abstract provided.

Precast, Prestressed Concrete For Bridge Decks : Technical Paper, Martin J. Gutzwiller, Robert H. Lee, Charles F. Scholer

JTRP Technical Reports

No abstract provided.

Carburization Of Type 316l Stainless Steel In Static Sodium, F. B. Litton, Arthur E. Morris

Materials Science and Engineering Faculty Research & Creative Works

The transport of carbon from an iron-87 wt.% carbon alloy through static sodium to Type 316L stainless steel was investigated at temperatures of interest to the liquid-metal fast-breeder reactor (LMFBR) program. The rate-controlling step for the experimental geometry employed was the diffusion of carbon in the source. © 1970.

Exact Solution For A Model Of Dislocation Pipe Diffusion, J. Mimkes, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

The dislocations are treated as an ideal array of parallel pipes of radius and diffusivity Dp embedded in the bulk material of the diffusivity Db. The exact solution of this problem of diffusion along semi-infinite edge dislocations is presented for cubic, tetragonal, and hexagonal crystals. The solution makes it possible to evaluate the dislocation pipe radius a and the ratio of diffusivities from one experiment. It is applied to experimental data for self-diffusion in tellurium available in the literature. The results of the calculations are a dislocation pipe radius a=(1.5 0.5)x10-4 cm and an activation energy for the pipe diffusion …

Test 1046: International Farmall 826 Hydrostatic Diesel (Also International 826 Hydrostatic Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1047: International Farmall 1026 Hydrostatic Diesel (Also International 1026 Hydrostatic Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1048: International Farmall 1456 Diesel (Also International 1456 Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1058: Case 770 Power Shift Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1061: Case 770 Manual Gasoline, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Australian Tractor Test Report. No. 56. Zetor 5511, G H. Vasey, W. F. Baillie

Journal of the Department of Agriculture, Western Australia, Series 4

AUSTRALIAN TRACTOR TEST REPORT

The Zetor 5511 is a general purpose farm tractor. With 43 drawbar horsepower and 51 h.p. at the P.T.O. at rated engine speed it comes within Class 5 of Australian Standard Classification of Wheeled Tractors for Agricultural Purposes, A.S. Dl0-1967. It is equipped with 18.4 x 28 pneumatic tyres.

It has a five-speed gear box with a High and Low ratio change giving 10 forward and 2 reverse speeds

Super Spreader Distributes Snail Baits, G D. Rimes, W. M. O'Donnell

Journal of the Department of Agriculture, Western Australia, Series 4

THE problem of distributing snail bait on broad acres has been overcome by simple modifications to a conventional super spreader.