Digital Commons Network^™

Multi-H Continuous Phase Modulation : Its Properties And Analysis, Jyung-Cheng Chen

Theses

Multi-h CPM, a generalization of CPFSK and also one of the so-called Combined Modulation and Coding schemes, is useful in digital communication systems where both the bandwidth and power are constrained. The increased signal processing complexity, which can be viewed as the third communication resource, is used to trade for both power and bandwidth, and to approach the error-free communication promised by Shannon's theorem.

The transmitted multi-h CPM signal carries a coded sequence of continuous phase changes; the possible phase states form a cylindrical trellis in phase and time, in which the modulation indices are reused in a cyclical fashion. …

Logic Simulation And Methodologies For Design For Testability, Ravi Shankar Prasad Mallampalli

Theses

This thesis describes the method used for developing the standard TTL blocks using the logic simulator SPLICE1. It also gives a comprehensive overview of methods which can be used for designing a circuit which is testable. A format called Electronic Design Interchange Format (EDIF) is also described as a tool which can be used for transporting design data in the VLSI indgstry.

A Variant Of Tale-Spin With Independent Data And Rule Bases, Laxmi Gupta

Theses

Not Included

Effect Of Center Of Gravity Location On Optimum Performance Of Random Vibratory Vehicle Suspension, Daniel Mahar

Theses

This study provides the analysis for the optimal design of a conventional vehicle suspension system, consisting of a sprung mass (vehicle body) and two unsprung masses (wheel frame), accentuated by the implementation of a damped absorber to the unsprung masses. Further, the effect of the c.g. (center of gravity) location of the vehicle body is investigated. A two dimensional, four degrees of freedom linear model is chosen. Randomly profiled terrain is assumed to impart hyperbolically distributed stationary vertical random displacements to the front and rear wheels. For generalization, nondimensional design parameters are selected. Criteria for optimization include the tire-terrain normal …

An Investigation Of The Applicability Of Walker And Fetsko Ink Transfer Equation On And The Influence Of Ink Viscosity On Heat Set Ink Used On The Web Offset Process, Dein Wang

Theses

The Walker and Fetsko ink transfer equation is the most used ink transfer equation to predict the ink and paper behavior on the ink transfer step in the printing process. All previous studies have shown that this equation is mostly applicable in the three major printing processes, letterpress, lithography and gravure. A study by Schaeffer, Fisch and Zettlemoyer reported extensive measurements for several oil-base ink and paper combination over a range of proof-press printing conditions. Yuri Bery did a series of studies for modifying the Walker and Fetsko equation in gravure inks for Weyerhaeuser Company. All the studies showed that …

A Study On The Relationship Of Dark Reaction Of Diazo And Photopolymer Presensitized, Negative Working, Lithographic Plates With Temperature Relative Humidity, And Time, Kannan Adityan

Theses

Dark reaction is a condition in which the plate acts as if it is exposed to a low level of active light, even though it is being stored in the dark. The Stouffer scale or the sensitivity guide is used to measure this dark reaction which takes place also as a result of high temperature and relative humidity. If there is much dark reaction taking place, more solid steps will show up on a negative working plate. For the purpose of this experiment diazo and photopolymer presensitised, negative working, lithographic plates were chosen. These plates were cut into small sections …

Mythography, Christopher Losee

Theses

Although it was written over a year before this section, the thesis proposal which appends this report still serves as a good introduction to my ideas on myth in general , and in particular to my way of thinking when I began this inquiry into the photographic representation of myth. In exploring the visual and artistic dimensions of myth, I found that my thoughts and feelings on the subject changed vastly as the work progressed; however, the end result of this process of exploration has led me back to the beginnings of the work and allowed me, as T,S. Eliot …

The Effect Of The Relief Plate Shoulder Angle On Flexographic Dot Gain, Bruce Brier

Theses

The mechanism of image-formation in photopolymer flexographic relief printing plates is reviewed. In addition to the identified factors, it was hypothesized that the level of exposure could influence the plate shoulder angle. It was further hypothesized that an optimization of shoulder angle with respect to halftone dot area may reduce the dot gain of the printing process. An experiment was conducted using a novel method of plate exposure. Continuous-tone masks were placed in contact with the plate back and the halftone negative used on the plate face. The resulting shoulder angles were measured and analyzed for significant fit to a …

Measurement Of The Spectral And Spatial Responses Of The Human Eye's Blue Sensitive System And The Effects Of Lateral Inhibition By The Red And Green Sensitive Systems, Paul Berg

Theses

A study was conducted to measure the change in spatial modulation sensitivity of the human eye's blue sensitive system at low light levels due to color shift, intensity change, and accommodation of red and green sensitive systems with yellow light. A testing device was designed which allowed a wide range of variation in viewing conditions for targets of several spatial frequencies. IV Results indicate that the ability to resolve gratings by the blue cones is depressed by lowering grating intensities but does not depend on wavelength within the blue cone sensitivity envelope to any extent greater than that explained by …

The Challenge Of Functional Art, Janice C. Anthony

Theses

None provided.

Analyze3d, A Structural Analysis Program Employing Membrane And Solid Finite Elements, James Mendham Gathercole

Theses

The purpose of this thesis is to describe the addition of an 8 and 20-node isoparametric brick element to the finite element program ANALYZE, permitting three-dimensional analysis. The reason for the addition is that even though Analyze is a relatively simple program, its simplicity makes it a good educational tool for finite element courses. The added brick element expands the use of the program for educational purposes.

In its original form, Analyze is a finite element package for static structural analysis developed at Wright Patterson Air Force Base. The program consists of four finite elements: (1) bar, (2) membrane triangle, …

The Effect Of Systemic Arterial Pressure On Microvascular Flow And Transcapillary Exchange Of Macromolecules In The Hamster Cheek Pouc, Govind Mohanlal Gawdi

Theses

Microvascular flow velocities and transport of macromolecules were studied in the hamster cheek pouch under control and acute high arterial pressure conditions, with or without topical (local) application of the vasodilating agent, bradykinin. Mean arterial pressures of 130-160% control were attained by intravenous renin infusion. The microcirculation of the cheek pouch was studied using intravital microscopy. Areas with arterioles and venules were recorded on a videotape for later analysis of red cell velocity, using an RBC tracking correlator, and vessel diameter using a video shearing monitor.

In addition, vascular permeability to macromolecules was studied in the hamster cheek pouch vascular …

The Modeling Of A Self-Oscillating Dc-To-Dc Converter, Frank Andrew Linkowsky

Theses

This thesis develops a model of a nonlinear self oscillating current-or-voltage step-up dc-to-dc converter. Expressions are given that predict the operation of the converter in the time domain and in the state plane. To verify these expressions, a large signal computer simulation technique [1] is used to compare theoretical results with actual measurements. This type of simulation allows a nonlinear switching converter to be modeled with a series of piecewise-linear operating intervals. The resulting waveforms predicted by the developed model show close agreement with waveforms found in the laboratory. Therefore, the model represents a powerful tool that may be used …

A Tracheoesophageal Puncture Voice Prosthesis, Georghios Makris

Theses

A voice prosthesis was developed that allows verbal communication of laryngectomised patients. The prosthesis requires a superiorly directed tracheoesophageal puncture in which the periscope mounted on the tracheal stoma vent is introduced. The prosthesis is operated by air injection through the periscope. Air injection is achieved by pulmonary pressure after the occlusion of the stoma vent. Stoma vent occlusion can be achieved either by the patient's finger or by the designed cover valve mounted on the prosthesis. The cover valve allows free breathing, hand-free prosthesis use, and it can release excess pressure during coughing. Periscope valve air resistance tests have …

Tests On Square Reinforced Concrete Members Under Combined Biaxial Bending And Tension, Bhadresh Shah

Theses

The research reported herein studies the ultimate strength behavior for square-shaped reinforced concrete short columns under combined biaxial bending and tension that is a common design problem. The present ACI building code (ACI 318-83) (1) and design hand book (2) do not offer an insight into the determination of strength and ductility behavior of biaxially loaded reinforced concrete columns. A design equation developed by Hsu (3,4,5 ) to study the ultimate strength behavior and failure surfaces for members under these combined action was used and the computed results were compared with the present analytical results and experimental results for square-shaped …

Theoretical Investigation Of Submerged Turbulent Jet, Talal N. Hindi

Theses

A theoretical investigation concerning the flow characteristics velocity distribution of a circular submerged turbulent axisymetricic water jet impinging on a flat plate was carried out. Starting with the use of the available data and equations obtained by previous investigators and found room for improvement. By solving these equations for the velocity distribution and comparing them to the experimental results is was found out where improvements of the analysis were were necessary. Then taking Tollwien's solution for the velocity distribution and changing the reference axis to see whether or not the equations would give better results for velocity calculations. With certain …

Zeta Potential Measurements Of Biological Flocs Using A Streaming Potential Cell, Wayne James Gallagher

Theses

A streaming potential apparatus was assembled and tested. Its purpose was to characterize the surface of biological flocs in a wastewater environment. Samples of mixed liquor were obtained from the Passaic Valley Sewerage Commissioners wastewater treatment plant in Newark, New Jersey. Filtered mixed liquor was passed through a bed of the floc particles in the streaming potential cell, and the electric potential across the cell was measured as a function of the differential pressure drop. From these data, the zeta potential was calculated using the Helmholtz equation. Values of -0.88 and -0.44 millivolts were obtained for two mixed liquor samples.

Gallium Film Formation By Ion Cluster Beam Deposition, Te-Chuan Hsu

Theses

Gallium thin films were deposited by Ion Cluster Beam (ICB) from pure gallium. This research had two objectives: to develop a practical method of crucible heating to generate gallium clusters; and to investigate the influence of ICB system parameters on the formation of clusters and film properties. An electron-bombardment crucible heater with a novel construction was designed. The top section of the carbon crucible was kept at a higher temperature than the middle section to prevent clogging of the nozzle and " spitting " phenomena which were found to occur with the conventional design. Crucible temperatures up to about 1360°C …

Reliability Of Dielectrics : Using Noise As A Diagnostic Tool, Ramesh K. Jain

Theses

The aim of this thesis is to develop a screening method to predict the reliability of a dielectric material. The screen chosen is an electrical noise. The dielectric material studied is varnished fibre glass cloth material supplied by Westinghouse Electric Corporation.

The dielectric material will have varying amount of voids, crystal defects, and surface contaminants impurities introduced during manufacturing process. On application of the electric stress, ionization (corona) will take place. The corona degrades the material due to thermally generated heat, chemical reactions in the voids and ionic bombardment of the material.

An experimental set up is developed to monitor …

Investigation Of Water-Binding Properties Of Industrial Sludges Using Thermal Analysis As A Monitoring Tool, Ron Josephson

Theses

As part of a program to develop new and more cost-effective dewatering approaches for industrial hazardous wastes, sludges and synthetic "model" materials were analyzed by thermal methods in an attempt to comprehend their water-binding qualities and differentiate free and bound water. These thermal methods included Differential Thermal Analysis (DTA), Thermogravimetric Analysis (TG), and Differential Scanning Calorimetry (DSC). Industrial sludges and laboratory models were compared using both standard heating techniques and subambient cooling (to -60°C). This latter technique provides direct indication of the amount of free water. This information can be very useful in evaluating and improving dewatering techniques for industrial …

An Enrollment Projection Simulation, Dianne Bills

Theses

This thesis applies current computer science technology to the simulation of student behavior, called Student Flow, in higher education. Data Flow Diagrams were modified for Student Flow analysis and used to help select parameters relevant to the simulation. A longitudinal database of enrollment activity was retrieved and analyzed to generate simulation statistics. The simulation was implemented using an electronic spreadsheet. The model thus developed was then used to project future student enrollments.

An Agreeable Truth: Facts And Faith In Nineteenth Century Photography, David Wooters

Theses

Not Included

Mwterm: A Macintosh Based Multiple-Window Unix Workstation, Deshler Armstrong Jr

Theses

MWTerm is a terminal emulator that runs on an Apple Macintosh computer. It provides a multiple window interface in which each window maps to a independent process on the host computer. It is designed to run in conjunction with a cooperating program on the host computer, under the Unix operating system. This paper describes the ideas behind the user interface presented by MWTerm. The implementation of both the Macintosh and the Unix ends is described. A discussion of the lessons learned and future enhancements is provided.

Muscle In Motion: Four Of The Most Common Overuse Injuries Of The Bicyclist, Carol France Kalafatic

Theses

Not Included

A Multiprocessor Distributed Debugger, David Blackman

Theses

This thesis presents the design and implementation of a distributed debugger. The debugger was designed to support the debugging of a system containing multiple processors from a single debug console. The debugger implementation consists of host software which runs on a VAX minicomputer and target software which runs on Intel SDK-86 single board computers. The host and targets communicate using an RS-232 channel. The debugger supports breakpoints, disassembly of target code, symbolic reference of program procedures and variables, and download of Intel Object Module Format binary files.

Combined Query Language (Cql): An Interactive Query Language With Procedural Features, Ilia Levi

Theses

Interactive query languages provide easy to use interfaces to database systems. However, they lack the power of the host languages to perform manipulations on data. This thesis presents an interactive query language Combined Query Language (CQL) that has some features of procedural languages. CQL allows users to interactively manipulate databases and perform calculations on data. CQL is a self contained interactive query language that combines the computational power of a host language (like FORTRAN) with the convenience and flexibility of the common interactive query languages. Users of CQL would not have to use a host language for most of the …

Fertile Ruin, Elizabeth Quackenbush

Theses

Not Included

A Sentimental Journey, Rose Marie Sherwood

Theses

None provided.

Nouveau Deco, Jodie Traugott

Theses

Not Included

Forced Plasma Oxidation Of Reactively Evaporated Indium As A Transparent Antistatic Coating For Ponyethylene Terephthalate, David Dawson Elli

Theses

Thin films of indium oxide (IO) were prepared by a three stage process involving forced plasma oxidation (FPO) of reactively evaporated indium. Applications of IO films produced using this technique include transparent, antistatic coatings for the continuous processing of polyethylene terephthalate (PET). The films were characterized by sheet resistance and optical transmittance measurements, and ESCA. Experiments were performed to determine the effect of FPO exposure time on sheet resistance Rs and optical transmittance T, which were then monitored over a one year period to determine the stability of the films. A model is developed to explain the effects of (i) …