Digital Commons Network^™

Adaptation Of Beggs Deformeter Apparatus To The Solution Of Three-Dimensional Problems, Roland L. Finley

Mechanical Engineering ETDs

In the area of structural analysis and structural design, numerous efforts have been made and more are yet to be made toward solving statically indeterminate problems easily and with a high degree of accuracy. Fortunately, the great majority of such problems can be solved by one or more of the many mathematical methods that are normally used. However, the mathematical solutions become exceedingly difficult if and when it is desired to use irregularly shaped structural members.

Digital Computers And Their Application To Civil Engineering Problems, Richard G. Vaughan

Civil Engineering ETDs

Early in 1960 a study was undertaken by the author to become acquainted with the use and application of digital computers in the structural and civil engineering fields. After several months study and attendance, during the summer of 1960, at a National Science Foundation Institute on the use of digital computers in engineering, it was felt that the study could be expanded and presented in thesis form. The principal benefit from the study, other than the author's, will possibly be the integration into the civil engineering curricula of the material contained in the thesis.

The material as presented is the …

The Use Of Ferrophosphorous And Manganese Ore In High Density Concrete For Radiation Shieding, Robert A. Crist Jr.

Civil Engineering ETDs

The scope of this thesis encompasses the investigation of the feasibilities of using a locally and/or readily available heavy aggregate for high density concrete. Such an aggregate was found to be available in Socorro, New Mexico. The Socorro Manganese Corporation has a stockpile of over 7,000 tons of high-grade manganese ore (specific gravity = 4.5) potentially suitable as a heavy aggregate, and some of which was used for this research. Along with the manganese ore was used ferrophosphorous, a very heavy aggregate manufacture by the Victor Chemical Works (specific gravity = 6.5), to obtain a range of densities that would …

Theory And Fabrication Of Point Contact Diodes Utilizing Reduced Single Crystal Rutile Tio2, Goebel Davis Jr.

Electrical and Computer Engineering ETDs

Single Crystal Rutile TiO2 upon reduction by heating in an atmosphere of hydrogen becomes a semiconductor, and the conductivity increases with the time and temperature of reduction. The reduction process creates oxygen vacancies with which there are associated two loosely bound electrons. These electrons may be raised to the conduction band by thermal excitation. Hence, an oxygen vacancy behaves like an impurity donor site.

The Use Of Compensation With Directional Couplers, Roland Alan Lincoln

Electrical and Computer Engineering ETDs

This thesis describes an improved technique for measuring voltage standing wave ratio (VSWR). The reflectometer system is analyzed, and an improved coaxial system is presented which more accurately measures VSWR.

The Control And Measurement Of Minute Curvatures In A Steel Shaft, Donald F. Wilkes

Mechanical Engineering ETDs

The primary purpose of this thesis was the solution of several special problems relating to the establishment, adjustment, and measurement of small elastic curvatures and the associated strains in a metal shaft. The solution of these problems was an important link in the development of a new type of seismometer for measuring extremely long periods with vibrations (up to 60 seconds). To achieve the sensitivity and long natural period of vibration required for accurate measurements of long-period waves, the seismometer employs a seismic mass which is suspended on an air film and constrained to follow an essentially horizontal guide rod. …

The Control And Measurement Of Minute Curvatures In A Steel Shaft, Donald F. Wilkes

Mechanical Engineering ETDs

The primary purpose of this thesis was the solution of several special problems relating to the establishment, adjustment, and measurement of small elastic curvatures and the associated strains in a metal shaft. The solution of these problems was an important link in the development of a new type of seismometer for measuring extremely long period with vibrations (up to 60 seconds). To achieve the sensitivity and long natural period of vibration required for accurate measurements of long-period waves, the seismometer employs a seismic mass which is suspended on an air film and constrained to follow an essentially horizontal guide rod. …

Computer Programs For Determining Radar Return Power And Fading Spectra, Chung Chia

Electrical and Computer Engineering ETDs

The properties of radar terrain return at near vertical incidence have been under investigation at the University of New Mexico with Sandia Corporation, Albuquerque, New Mexico, and the United States Naval Ordinance Test Station, China Lake, California.

Mix Design Study And Compressive Strengths Obtainable From Pumice-Aggregate Concrete, Benjamin F. Snow

Civil Engineering ETDs

Compressive strengths of pumice-aggregate concrete were examined by introducing controlled variables into the mix proportions. A mix design method is presented, and this method was analyzed for consistency and feasibility.

Correlation Of The Atterberg Limits And The California Bearing Ratio Values For Soil-Cement Media, Vernon E. Kerr

Civil Engineering ETDs

Tests were made on three different soils, using controlled amounts of Portland cement and water. All tests were made using a standard liquid limit device or a six-inch mold. The variables were amounts of Portland cement, degree and thoroughness of mixing, moisture content, curing and compaction of samples. The recommended procedures for performing the Plastic Limits Test, Liquid Limits Test and the California Bearing Ratio Test were followed with very few exceptions. All values obtained from testing are entered in the report and no retesting was done.

Design Of Crystal Filters, Charles E. Schmidt

Electrical and Computer Engineering ETDs

This thesis concerns the application of electromechanical impedance elements to electric wave filters, so it is appropriate to begin with some discussion of such elements. The most important type is the piezoelectric resonator, most commonly made quartz.

Transient Sensitivity Of Piezoelectric Accelerometers, William E. Baker

Electrical and Computer Engineering ETDs

No abstract provided.

Experimental Determination Of Dynamic Stress Concentration Factors In Rectangular Steel Bars, Jerome E. Ligocki

Civil Engineering ETDs

Stress concentration factors obtained from impact tests indicate substantial agreement with experimentally derived static stress concentration factors. Testing was limited to one 3/8 diameter centrally located hole in a long rectangular bar 2 inches wide. The hole was located at a bar cross section where a plane wave was found to exist. Stress pulse lengths as short as 50 microseconds duration was used in the experiments.

The experimental results confirm the ability of the resistance strength gage to accurately measure stress pulses. The proper amplitude response of the gage is proven by comparison with dynamic and static test results. The …

Practical Analysis Of Blocking Oscillators, Richard D. Griffith

Electrical and Computer Engineering ETDs

The objective is to give a method of treatment of blocking oscillator circuits which will be of practical value for circuit design. An attempt has been made to reach a good compromise between accuracy, generality, and usefulness. The use of statistical methods to complement the mathematical analyses is stressed.

Evaluation Of New Mexico Asphaltic Concrete Aggregates By The Sand Equivalent Test, John P. Boyd

Civil Engineering ETDs

No abstract provided.

Crustacean Gastroliths From The Jackson Eocene Of Louisiana

School of Mines and Metallurgy Bulletins

Wechesia louisianae, n. sp., is described from upper Eocene beds at Montgomery, Louisiana. Second species of the genus, it extends the range of Wechesia Frizzell and Exline from Claiborne (middle) Eocene and validates the generic diagnosis.

A Study Of Drift Mobility In Neutron Irradiated N-Type Germanium, William H. Closser

Electrical and Computer Engineering ETDs

With the advent of the transistor in the late 1940's have come an entirely new field of engineering and a greatly renewed interest in solid state physics. This paper will be concerned in general with the electrical properties of these materials, and specifically drift mobility of the minority carriers in n-type germanium. The minority carrier in n-type material is the hole. The definition of drift mobility is: the mean carrier velocity per unit electric field.

The Fields Of Electric Dipoles In Sea Water- The Earth-Air-Ionosphere Problem, Wallace L. Anderson

Electrical and Computer Engineering ETDs

In the initial part of the following investigation; expressions will be obtained for the Hertz potential in three regions of arbitrary conductive and dielectric properties. The regions are separated from each other by two infinite parallel planes. In directions normal to these planes, the regions above and below the intermediate layer are considered to be of semi-infinite extent. The regions are individually homogeneous. An electric dipole is located in one of the semi-infinite media, which will be called medium 1. The intermediate layer is called medium 2, and the other medium 3.

Acceleration Of A Symmetric Plasmoid In An Axial Magnetic Bias Field, Richard Daniel Jones

Electrical and Computer Engineering ETDs

A pulsed gas, electrodeless discharge, plasma accelerator facility has been developed for experimental studies of the coupling mechanism for the transfer of energy from a driving magnetic field to a plasma. Gas at low pressure is ionized by an azimuthal electrical field induced through the action of a rapidly varying axial magnetic field produced by the flow of current through a ring surrounding a confining glass shock tube. The tube is arranged to permit radial expansion of the ionized gas. Due to its conductivity, the plasma, once it is formed, can exclude the rapidly varying driving magnetic field for a …

Shape Factors For Conduction Of Heat, Harry J. Otway

Mechanical Engineering ETDs

The purpose was to measure the heat conduction shape factors for cylinders and square prisms enclosed by spheres and to estimate the accuracy of the following approximation. This approximation is that of matching the area of the cylinder or prism to an equivalent sphere and then applying the analytical solution for concentric spheres.

"Observations Of A Visiting Highway Engineer", J. Alan Proudlove

Kentucky's Annual Forum on Transportation

No abstract provided.

A Radar Refraction Correction For Symmetric And Nonsymmetric Tropospheric Index Distributions, Ralph J. Rainey Jr.

Electrical and Computer Engineering ETDs

The high precision radars now in use have demonstrated the need for more exact refraction correction than is afforded by any fixed "standard" refractive index profile. The precision capabilities are even substantial enough to cause concern over the possible effects of the non-symmetric index distribution which introduces azimuthal errors. However, the indications are that the present limitation on true range measurements are primarily due to limitations on the radar itself, and a "gross" average correction is adequate for many cases of interest.

Analysis Of Pavement Roughness, Rolands L. Rizenbergs

Kentucky Transportation Center Research Report

In earlier progress reports dealing with the development of triaxial acceleration analysis as applied to the evaluation of pavement riding qualities, of which this report is a continuation, riding comfort or discomfort was emphasized. The accelerations monitored then were evaluated in terms of g's per sec., or "jerk" which is considered by some authorities to be a more significant index of comfort. The earlier methods of analysis have been reviewed, and acceleration is considered here to be the most practical parameter to use as a measure of pavement roughness. Most of the equipment and instrumentation has been retained, and the …

Performance Survey Of Reinforced Concrete Pipe Culverts, Robert C. Deen, Ronald D. Hughes

Kentucky Transportation Center Research Report

Methods of installation and design criteria have tended to restrict the usefulness of rigid pipe culverts. With the increased mileage of highways which meet high standards, there has been an increase in the number of pipe culverts installed under high fills. This, of course, has accented the need for criteria for the proper design and installation of rigid pipe to obtain the maximum utilization of the pipe strength and to minimize the possible steelements that may occur in the road surface near the pipe installation or in the flow line of the pipe culvert.

In order to provide for an …

A Development Of An Equivalent Circuit Of A Hall Generator Which Utilizes A Flux Concentrator, Laurence L. Rosier

Electrical and Computer Engineering ETDs

The development of the transistor has brought about a great deal of research in the field of semiconductors. One of the results in this research is the development of the Hall effect. A number of new devices which utilize the Hall effect have been proposed; however, more theoretical and experimental work is required to determine which of these devices are practical. The success of the equivalent circuit approach in the other fields of electrical engineering suggests that an equivalent circuit which would represent Hall effect devices would be useful. The development of such an equivalent circuit should be centered about …

Light Gage Cold-Formed Steel Design Manual, American Iron And Steel Institute

American Iron and Steel Institute (AISI) Specifications, Standards, Manuals and Research Reports (1946 - present)

No abstract provided.

The Effect Of The Ultraviolet Portion Of The Sun Spectrum On Chlorine Residuals In Water Supplies, Tumkur Mohmed Ameer Ahmed

Masters Theses

"The effect of sunlight on chlorine residuals in water supplies was investigated to provide original and basic information of value to the water purification field.

Three different water systems were employed: (a) The Simplified Water System, (b) The Ground Water System, and (c) The Surface Water System. The RS Sunlamp provided an appropriate source of ultraviolet radiation. A 10 mg/1 chlorine concentration was used. The pH values of 7 and 10 and the illumination intensities of 145 and 200 foot candles were employed. Iodometric determination of chlorine residuals was the main parameter used.

It was found that the chlorine residuals …

Australian Tractor Tests : Zetor 50 Super : Report On Test No.35, G H. Vasey

Journal of the Department of Agriculture, Western Australia, Series 4

T H I S Report is taken from the full Technical Report No. 35; results are shown here in briefer form: fuller explanations are added. Values quoted may be rounded out to two instead of three significant figures.

Crustacean Gastroliths From The Jackson Eocene Of Louisiana, Donna L. Frizzell, Wayne C. Horton

Missouri School of Mines and Metallurgy Bulletins

Wechesia louisianae, n. sp., is described from upper Eocene beds at Montgomery, Louisiana. Second species of the genus, it extends the range of Wechesia Frizzell and Exline from Claiborne (middle) Eocene and validates the generic diagnosis.

Effect Of Deflections For A Flat Plate By Slope-Deflection-Gyration Method, William Hsin-Loo Ying

Masters Theses

"Since the procedure for the theoretical solution of a rectangular flat plate or slab is complex, many approximate methods for determining the moments and deflections of such plate have recently been developed. One of these methods is the so called Slope-Deflection-Gyration Method which is performed by means of basically well-known structural theories - slope-deflection and torsion.

For a given plate, it is assumed that the plate is to be divided up into a grid of strips or equivalent beams at right angles to each other. The joints of this grid are assumed to be rigidly intersected and be permitted to …