Digital Commons Network^™

Economic Analysis Of Secondary Distribution Networks, Charles F. Cromer

Masters Theses

"In the early history of commercial electricity in heavy load density areas, the d.c. Edison Network was developed extensively. As far as reliability is concerned it is exceeded by no system. At the present time it has been developed to the extent of automatic and non-automatic converters, motor-generator sets, booster sets and storage battery reserve capacity.

This type of network is fed from several substations in the area at utilization voltage.

As load densities have increased, the large amounts of copper required, the cost of substation sites and large rotating conversion equipment have made the expansion of the d.c. Network …

Investigation Of The Fundamental Properties Of Rubber-Asphalt Mixtures, Yali Cevat Hasan

Masters Theses

"The writer of this thesis believes that the most important thing next to the original construction cost of a road, is the maintenance cost. It is apparent that the maintenance cost for any given road is directly proportional to the percentage of worn out sections in that road. It is believed that climatic conditions are the very first cause of road failures and that traffic on the road often has a secondary degree of importance in the causing of road surface failures….

It is obvious that extreme heat as well as extreme cold will ruin a road. A heavy traffic …

The Effect Of Inlet Air Temperature On The Efficiency Of A Spark Ignition Engine, John B. Toomey Jr.

Masters Theses

"The object of this thesis is to determine the effect of inlet air temperature on the efficiency of an internal combustion engine. In most text books the subject is dismissed with mentioning the negative effect of warm air on the maximum output of the engine. This fact is recognized but since most engines are run at maximum output only a small percentage of the time, it would be possible to control the air temperature as the situation demanded. With the assumption that cold air could be used when full power is desired, it was decided to determine the effect of …

Investigation Of Stress And Crack Distribution In Concrete Slabs Containing Welded Wire Reinforcement, Joseph H. Senne

Masters Theses

"Concrete is daily becoming more important as a structural material. However, without steel reinforcement, concrete would never have attained such wide use since, being weak in tension, it must be combined with some other material to take the tension stresses and prevent the tension cracks in the concrete from opening an appreciable amount.

One type of steel reinforcement used particularly for footings, beams and columns is known as deformed bar. In this case deformations are placed on the bars at the time of rolling. These deformations act as mechanical anchorage in preventing the bar from slipping, thus allowing it to …

The Effect Of Back Pressure Created By A Venturi Tube On Power Output And Efficiency Of An Internal Combustion Engine, James J. Trace

Masters Theses

"The exhaust pressure against which an engine works affects the amount of pumping losses, the volumetric efficiency and the rate of advance of the flame front during the combustion process.

When the back pressure is decreased to the same pressure as the intake pressure, the amount of negative work done during the exhaust-intake process approaches the positive work done during the process. It can be seen from a PV diagram that it is possible to make this negative work less than the positive work and gain work during the process.

Because of the "15 to 30 degrees” of intake valve …

The Relationship Between The Centrifuge Moisture Equivalent And The Vacuum Moisture Equivalent In Soils, Samuel Payton Halcomb

Masters Theses

"Soil is a material that has been formed through the influence of many different natural agencies. The engineer is not so much interested in how the soil was formed, but he does want to know the characteristics of the soil with respect to its use as a structural material. Therefore, the engineer is primarily interested in the physical properties of soils.

Much progress has been made during the past twenty five years in the study of Soil Mechanics, but even today there is a tendency among engineers to think of soil as just a mixture of clay, sand, silt and …

Bauxite Versus Diaspore Clay In High Alumina (70%) Refractory Brick, Bhikhubhai Mahadeo Sedalia

Masters Theses

"The last twenty five years have seen a remarkable change in the character and types of refractories for furnace construction. Not much more than a few years ago, the production of refractories consisted almost solely of fireclay and silica shapes. A few high alumina bricks were made from Missouri diaspore clays or from bauxite and fire clays. At a later date, although little used, high alumina refractories were available which were made from alumina of a higher degree of purity, by the fusion process. Today refractories covering the entire range of composition from about 98% SiO₂ to 99 1/2% …

Series Capacitors, Emcet Bilgeer

Masters Theses

"Static capacitors as an element of transmission and distribution circuits first appeared in the form of shunt capacitors. These shunt capacitors were primarily used in power factor correction. They can be regarded as a load in the circuit which draws a loading current. This loading current fleeing through the reactive line produces a voltage rise, thus reducing the voltage drop between sending and receiving ends. This phenomenon helps the voltage control of the feeder as well as power factor correction. The disadvantage of the shunt capacitor is its inflexibility. The shunt capacitor is connected across the line; hence the voltage …

Precise Lattice Parameter Determinations Of Diamond Silicon And Germanium By The Asymmetric Method, Esrefettin Zeki Aka

Doctoral Dissertations

"The construction of the apparatus for production of powder patterns at a definite temperature and the technique for evaluation of x-ray powder patterns by the asymmetric method are described in detail, and the mode of error elimination is discussed.

A new scanning device is designed for use in x-ray diffraction work.

A modified method is described for the determination of densities of solids, which eliminates some of the difficulties interfering with other similar methods thus far proposed. Formulae are derived for the calculation of density as well as for reduction of density at a desired temperature.

The following conclusion are …

The Underground Electrocarbonization And Gasification Of Mineral Fuels, Erich Sarapuu

Doctoral Dissertations

"The development of underground gasification methods for recovering mineral fuels is comparatively recent and several methods have been evolved for treating the various source materials. The problem of recovering solid and liquid fuels by underground gasification in gaseous form was primarily approached by means of opening underground entries which created the required fire-drift for starting the gasification in place.

Increasing knowledge of the whole problem of gasification in situ led to the evolution of new improvements in the underground gasification technique and, in the course of progressive research the preparations required for starting the gasification were accomplished from the surface. …

Study Of Relay Behaviour Under System Oscillations And Out Of Step Conditions, Emil D. Grigoriadis

Masters Theses

"The recent developments in harnessing electrical power have opened a new field in the improvement and betterment of the existing types of relays and the development of new types. Thus about 1930 the manufacturers introduced the high speed circuit breaker with operating times of the order of 8 cycles and the engineers awoke to the possibilities of high speed or one-cycle relays.

Many developments took place since that time which gave us the improved forms of Instantaneous Overcurrent Protective schemes, the Distance Relay Protection, the Carrier Current Protection and many others. Later, because of the war time problems of increased …

Oil Field Corrosion, Edwin Harry Barsachs

Masters Theses

"The corrosion of metals in the petroleum industry has become an important engineering problem. The rapid increase during recent years in costs of steel has caused the industry to intensify its efforts to minimize corrosion losses in pipe lines and well casings. An industry-wide research program has resulted in the development of improved methods of controlling corrosion of such equipment.

The purpose of this paper is to assemble and correlate the information concerning the different causes, the detection, and the mitigation of corrosion of metals used in the oil fields of the world. The causes that are presented in this …

A Survey Of Acidity In Drainage Waters And The Condition Of Highway Drainage Installations, James H. Havens, James L. Young Jr., Harvey J. Field Jr.

Kentucky Transportation Center Research Report

Every creek gulley and raw interrupted by roadway fills and embankments must be provided with an adequate drainage conduit under the pavement. If the natural drainage is impeded or the conduit is not functioning properly, impounded water over-runs the pavement, seeps through the fill, and eventually disintegrates the section or reduces its stability. The topography in Kentucky, through varied sectionally, requires on the average, one cross-drain for every thousand feet of roadway. Obviously, these drainage structures are of considerable economic importance in the highway program, not only from the standpoint of initial construction costs, but also from consideration of the …

Measurement Of Surface Irregularities And Riding Qualities Of High Type Bituminous Pavements, Harvey J. Field Jr.

Kentucky Transportation Center Research Report

Studies of riding qualities as determined by irregularities in high type bituminous pavements were first treated in Report No. 1 on this subject in December, 1949. At that time interest was centered as much on specifications as on the causes, the thought being that specifications did not provide satisfactory tolerances to produce surfaces with good riding qualities. Specifically, tolerances over relatively short distances longitudinally were though to be at fault.

It was found early in that work that variations in the lateral direction were causing considerable roughness but since longitudinal variations were being studied primarily, no actual measurements were made …

Test 454: Dodge Power Wagon T137, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary. All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University. Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

B.P.R. Project On Correlation Of Truck Traffic And Pavement Conditions, Kentucky Highway Materials Research Laboratory

Kentucky Transportation Center Research Report

Locations for the Test Sections within the Control Sections and as close as possible to the Loadometer Stations established by the Division of Planning have been selected and are described in this report. With but one or two exceptions, there is reasonable certainty that these sections of pavement can be kept in service without major changes for a period of five years. However, there are repairs that should be made on the pavements in two of the sections in order to prevent rapid deterioration that is likely to occur if these are not corrected at the beginning of the study.

Test 448: John Deere Mc, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere MC TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear. This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated. BELT HORSEPOWER TESTS TEST …

Mineralization Of The Bonanza Mine, H. M. Callaway

Bachelors Theses and Reports, 1928 - 1970

The Bonanza mine of the Emery mining district in Powell County is on the largest veins in the area, and is developed to a depth of 680 feet by an incline shaft following the dip of the structure. Sulfide ores carrying gold and silver values are mined throughout the area which is easily accessible by road from Deerlodge, Montana, ten miles west of the district.

Fauna Of The Pilgrim Formation Of The South Boulder Creek Area In Southwestern Montana, John T. Eastlick

Bachelors Theses and Reports, 1928 - 1970

This paper, a study of the fauna of the Pilgrim formation at South Boulder Creek in southwestern Montana, represents a laboratory study of the fossil specimens collected by Dr. Alvin Hanson during the summer of 1949. The scope of investigation includes identification and classification of the faunas, their stratigraphic relationship and zonal subdivisions.

A Mineral Dressing Study Of The Benefication Of Philipsburg Manganese Carbonate Ore, Frank M. Antonioli

Bachelors Theses and Reports, 1928 - 1970

The beneficiation of rhodochrosite ore to the extent that it is suitable for nodulizing and subsequent use in the steel industry is intriguing. Such ores from certain mines is relatively easy to beneficiate, but the rhodo-chrosite ore from several deposits of the Philipsburg district has never been successfully up-graded by any of the several known beneficiating methods.

An Annotated Handbook Of Free Teaching Materials For Industrial Arts Instructors, Donald L. Ferguson

Master's Theses or Doctor of Nursing Practice

This research comprising a handbook of free teaching materials for the industrial arts instructor is prepared as an aid to the classroom and shop teacher. There are many teaching aids now available for industrial arts teachers. Comparatively few industrial arts teachers know where to obtain these materials. The primary purpose of this research is to present in form "An Annotated Handbook of Teaching Materials for These Instructors. " This handbook includes the address, name, source, and description of materials available at no cost.

Hot-Dip Aluminizing Of Low-Carbon Steels, Claude R. Barnes Jr.

Bachelors Theses and Reports, 1928 - 1970

In a relatively short period of sixty-five years, aluminum has grown to the rank of fifth in total weight of met­als produced in the world. Throughout its short life, aluminum has been found to have excellent corrosion-resistant properties; yet only in recent years has aluminum been under consideration as a corrosion-resistant coating for iron and steel.

Isothermal Transformation Of S.A.E. 6150 Steel By The Magnetic Permability Method, Richard R. Douglas

Bachelors Theses and Reports, 1928 - 1970

Since the purpose of this thesis is primarily to present an improved mechanical method for plotting isothermal transformations by means of differential mag­netic permeability between untransformed austenite and its ultimate transformation product.

The Lilly Mine Of Powell County, Montana, Wilbur Aikin

Bachelors Theses and Reports, 1928 - 1970

For many years the Elliston District, of Powell County has been a minor producer of gold, lead, zinc, and silver. Although never among the largest producing districts of the state, it has with the exception of the war years supplied a notable tonnage of ore to the neighboring mills ever since the first placer and lode claims were located there during the late eighteen hundreds.

Consumptive Use Of Water Studies In The Ashley And Ferron Creek Areas Of Utah, Elden E. Fisher

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The inadequacy of water and power supplies in Utah for agriculture, for industry, for domestic and community consumption has retarded the State's economic growth. Shortages of water and hydroelectric power are the principle impediments to the full realization of other potentials of Utah, that is, the full use of its arable lands, the wide and diversified use of its industrial raw materials, and the unrestricted development of its communities. The problem of securing additional sources of water and power has resolved itself into one of major concern. The objective of this study was to determine unit values of consumptive use …

Effect Of Surface Irregularities On The Riding Qualities Of High Type Pavements, Harvey J. Field Jr.

Kentucky's Annual Forum on Transportation

No abstract provided.

Road Side Improvement, N. R. Elliott

Kentucky's Annual Forum on Transportation

No abstract provided.

Economics In Erection Of Long Span Continuous Bridges, Harry A. Balke

Kentucky's Annual Forum on Transportation

No abstract provided.

Toll Facilities In The Highway Program, Craig P. Hazelet

Kentucky's Annual Forum on Transportation

No abstract provided.

Low Cost Bridges For Secondary Roads, G. Wood Smith

Kentucky's Annual Forum on Transportation

No abstract provided.