Open Access. Powered by Scholars. Published by Universities.®

Physics Commons

Open Access. Powered by Scholars. Published by Universities.®

1993

Electrical and Computer Engineering

Barkhausen effects

Articles 1 - 3 of 3

Full-Text Articles in Physics

Evaluation Of Fatigue Damage In Steel Structural Components By Magnetoelastic Barkhausen Signal Analysis, Madhav Rao Govindaraju, Andrew Strom, David C. Jiles, S. B. Biner, Z. J. Chen May 1993

Evaluation Of Fatigue Damage In Steel Structural Components By Magnetoelastic Barkhausen Signal Analysis, Madhav Rao Govindaraju, Andrew Strom, David C. Jiles, S. B. Biner, Z. J. Chen

Ames Laboratory Publications

This paper is concerned with using a magnetic technique for the evaluation of fatigue damage in steel structural components. It is shown that Barkhausen effect measurements can be used to indicate impending failure due to fatigue under certain conditions. The Barkhausen signal amplitude is known to be highly sensitive to changes in density and distribution of dislocations in materials. The sensitivity of Barkhausen signal amplitude to fatigue damage has been studied in the low‐cycle fatigue regime using smooth tensile specimens of a medium strength steel. The Barkhausen measurements were taken at depths of penetration of 0.02, 0.07 ...


Modeling Of Micromagnetic Barkhausen Activity Using A Stochastic Process Extension To The Theory Of Hysteresis, David C. Jiles, Levent B. Sipahi, G. Williams May 1993

Modeling Of Micromagnetic Barkhausen Activity Using A Stochastic Process Extension To The Theory Of Hysteresis, David C. Jiles, Levent B. Sipahi, G. Williams

Materials Science and Engineering Publications

Recent work by Bertotti [IEEE Trans. Magn. MAG‐24, 621 (1988)] and others has shown that it is possible to model the micromagnetic Barkhausen discontinuities at the coercive point using a two‐parameter stochastic model. However, the present formulation of the model is restricted to limited regions of the hysteresis curve over which dM/dH is approximately constant and whendH/dt is held at a constant rate. A natural extension of this model is to take the basic result, in which the level of Barkhausen activity in one time period is related to the activity in the previous time ...


Comprehensive Analysis Of Barkhausen Emission Spectra Using Pulse Height Analysis, Frequency Spectrum, And Pulse Wave Form Analysis, Levent B. Sipahi, David C. Jiles, D. Chandler May 1993

Comprehensive Analysis Of Barkhausen Emission Spectra Using Pulse Height Analysis, Frequency Spectrum, And Pulse Wave Form Analysis, Levent B. Sipahi, David C. Jiles, D. Chandler

Materials Science and Engineering Publications

The dependence of magnetic Barkhausen emissions (MBE) upon both field excitation and detection frequencies and excitation wave form was studied in order to investigate two of several crucial factors which affect the emissions. Sinusoidal, triangular, and square wave forms were used to generate the MBE and the pulse height spectra, frequency spectra, and pulse wave forms of these signals were analyzed. The frequency spectra of sinusoidal and triangular alternating field excitations showed similar behavior but the spectrum under square wave excitation was different due to the existence of high frequency components during square wave switching. As yet, no common standard ...